0=685-1922,2=0.00497 Neper / mile 1=0.0352 rad /mik at 1000 Hz. If Z₁ = 2 and E= 10 Vrms with Zgs 7002. Find to nd impedance, voltage, current and powe

Q: Manganese(IV) is an even stronger oxidizing agent than manganese(III). Itoxidizes zinc to Zn2+ in…

A: The reaction is shown below:  Zn→Zn2++2e- The work done by the battery is,  W=E∆Q The charge…

Q: Find the value of the source voltage Vx in the circuit below. Current of 2 Amps is passing through…

A: Given circuit,

Q: Find 12 in the circuit shown below. 4 13 3Q 50L0⁰ 1½ a) 8.72-1.37⁰ b) 3/-48.7° 5+j6 30/90° 6-j5 c)…

A:

Q: If an AC signal has a peak voltage of 55V, what is the average value voltage? a. 110 V b. 17.5070 V…

A:

Q: Problem: A coil of pf 0.6 is in series with a 100μF capacitor. When connected to a 50Hz supply, the…

A: Solution !!

Q: Z 3D 20 www 40 -j3 n O d. Z 1,95 -j1,29 = O e. Z 1,95 + j0,29 0 j3 n j20 -j30 O a. Z₁ = 1,95 +j1,29…

A: Simplified circuit for total impedance ZT :

Q: A coil draws 1800W when connected to a 120V dc source. It consumes 3000W when used on a 200V, 60Hz…

A: We need to find out the value of the inductance of given coil

Q: Obtain Zin for the circuit in Le Fig. 9.67. Zin j15 Ω 25 Ω wwwm -j50 Ω 20 Ω 30 Ω 110 Ω

A: Given, The circuit is,

Q: 19. A factory draws an apparent power of 300 kVA at a lagging power factor of 0.65. The active power…

A: Given: A factory draws an apparent power, S=300 kVA Lagging power factor, cosϕ=0.65

Q: Que 4.28. On short circuit tests, the currents and voltages were determined experimentally for an…

A:

Q: 2.1 For the following polynomial for 1+ G(s)H(s) = 0 and using Routh's method for stability, is this…

A:

Q: 25 Given the closed-loop transfer function T(s) = s2+3s+25 Find wn, Natural Frequency wn = Damping…

A: Given: The closed loop transfer function, Ts=25s2+3s+25

Q: 1) A tuned circuit has a 15-mH inductor with a 450-omhs resistance that resonates at 2.3 MHz, a.…

A:

Q: QUESTION 13 For a certain BJT amplifier, the transconductance (gm) value is 20mS and the value of…

A: Given, Trans conductance, gm=20 mS Input resistance, Rinbase=10 kΩ

Q: Given points M(-1, 2, 1), N(3,-3, 0), and P(-2,-3,-4), find: a) RMN b) RMN + RMP c) Ml d) aMP e)…

A:

Q: Assume a Y-Y connected balanced 3-phase system in positive obc sequence with phase voltage of…

A: Given data, A Y-Y balanced 3-phase system in positive sequence. Phase voltage of magnitude Vp=170 V…

Q: Given the vector field H = xy²zax + x²yzay + xyz²ą, express it in cylindrical system at point (3,…

A: It is given that: H=xy2zax+x2yzay+xyz2azpoints3,-4,5

Q: 6. (1 pt) Given the following second order system, what type of system is it? O Critically damped…

A:

Q: An oscillator employs 1. Positive 2. Negative 3. Neither positive nor negative 4. Data insufficient…

A: The solution is provided in the following section.

Q: 1.2 If for intrinsic Silicon at 27°C, the charge concentration and mobilities of free-electrons and…

A: Given: For intrinsic silicon the charge concentration,  n=p=ni=1.5×1016m3 Mobility of free electron,…

Q: You have been given the following function: V = ax+By2² It describes the electric potential in a…

A:

Q: 1.1 A specimen of intrinsic germanium with the density of charge carriers of 2.5 x 1013/cm³, is…

A: Given, A specimen of intrinsic germanium with, The density of charge carrier, ni=pi=2.5×1013cm3 The…

Q: A small signal equivalent circuit of single common-emitter amplifier is shown in Figure Q1.b with…

A:

Q: Find the Thevenin equivalent with respect to the terminals a,b and determine the current across 1.5…

A: Given:

Q: Subtract (5 + j2) - ( 6 - j7), find the answer in rectangular and polar forms NFTOC in polar form,…

A:

Q: of electrons from the plate is caused by the acceleration of electrons by the screen grid. This…

A: Answer: Secondary Emission

Q: H.W: What would you expect to see displayed on the RL? R₂ VILAS

A:

Q: Using Pole Zero Placement Method, determine the unit gain scale factor for a second-order notch…

A: Given: Sampling rate or sampling frequency fs=13,000 Hzbandwidth BW=1700 HzNarrow stop-band center…

Q: Problem 11. An underground cable has the follow- ing primary constants: resistance R = 10 22/loop…

A: Given: An underground cable has the following primary constants: Resistance, R=10 Ωloop km…

Q: For the following, put all final answers in the +20V table below or sketch a similar table. a. Solve…

A: a. The circuit is shown below:  The equivalent resistance of the above circuit is,…

Q: A type of activity that has no duration and uses no resources is called what? O Dummy O Crossover O…

A: As we know that as there so many activities  which uses resources and time duration  as performed…

Q: Hartley oscillator is commonly used in ...... 1. Radio receivers 2. Radio transmitters 3. TV…

A: The solution is provided in the following section.

Q: 2. When the switch in the circuit is moved from position 1 to 2 at t= 0. Find the voltage across the…

A:

Q: Show that a lossless transmission line of "18 alway hers 1 Zinl = Zo leyth independent of the load…

A:

Q: Que 2.23. What should be the value of R, so the maximum po can be transferred from the source to R,…

A: In this question,  We need to determine the value of load resistance RL  as shown the circuit for…

Q: 3. Determine using superposition theorem. 12 V (+ 82 + V x = 50 105 11 3A

A:

Q: Q1-A- Find the unit-step time response of the closed-loop second-order control system of the…

A:

Q: A lossless transmission line having 50 Ω characteristic impedance and length λ/4 is short-circuited…

A:

Q: G1 파 H R₁ H G₂

A:

Q: how many luminaires are required?

A: Here given amount of luminaries is of size 40ft by 20ft in meter 12.1m by 6m and as you mentioned…

Q: R(s) + G1 G2 G3 G4 +1 + G5 G1 FIGURE P5.5 Anter +A G6 day bindell C(s)

A: Given diagram,

Q: Four lamps are suspended 6 m above the ground at the corners of a lawn 4 m on each side. If each…

A:

Q: What is the maximum transmission efficiency of an AM signal?

A: The correct option along with the explanation has been provided in the following section.

Q: D.T.L.T.I. systems are connected as shown below. Find the overall impulse response of a system and…

A:

Q: 7-19 In Fig. 7-24, solve for 1₁, 12, and/3. Figure 7-24 R₁ = 10 92 R₂ = 152 1₁=9A www R₂ = 12 92

A: Given data,

Q: The magnetic core in Figure has a square cross section of 3 × 3 cm. The air gap x = 5 mm. The coil…

A: Given data, Number of turns N=250 Voltage V= 220 V DC Resistance R= 11 ohm Dimensions of core =3…

Q: The frequency of e.m.f. generated in an 8- pole alternator running at 900 r.p.m. is

A: Given an alternator with, Total number of pole, P = 8 Synchronous speed, Ns=900 rpm Frequency, f =?

Q: 3. Determine Vusing superposition theorem du

A: Given:

Q: 1) An SCR has a circuit fusing rating of 90 A²s. The device is being used in a circuit where it…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3. Determine the maximum power that can be delivered to the load by first reducing the network to a…

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.