+ 1 V₂ 552 [mm] 12mH 5mH n 1.82 M 35mf

Q: AC Power and Power Factor 1. Two loads are connected in parallel across a 13,200-volt line. Load A…

A:

Q: 2% (2067 V 2. A short-circuit test when performed on the H.V. side of a 10 kVA, 2000/400 V…

A:

Q: H.W / 1/ Find Req a-b in the circuit of Figure:

A:

Q: Three generators rated as follows: G1: 100 MVA, 33 KV, sub-transient reactance of 10%; G2: 150 MVA,…

A:

Q: Q) Find the 6-point discrete Fourier Transform (DFT) of the following signal: x[n] = 4 + 2cos (n)…

A: DFT is discrete Fourier transform It is a finite sequence of equidistant samples of the…

Q: For an FM modulator with 48 kHz of frequency deviation and a modulation signal frequency fm= 8kHz,…

A:

Q: 5. What is the full-load current of a 230-volt, 3-phase, 125-horsepower synchronous motor when it is…

A: We need to find out the current for given circuit.

Q: The difference between frequency and phase modulation is which of the carrier's properties is…

A: Modulation:- Modulation is the technique in which characteristics of the carrier is changed…

Q: 1-Why transformer Rating in KVA? 2-Why is efficiency of transformer high compare to other electrical…

A: Given  We need to explain the reasons why a. Transformer rating is in KVA and efficiency is higher…

Q: Question 1 From the waveform shown in the figure, determine the parameters of the harmonic voltage…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: = For E-MOSFET gives Ip(on)= 500mA (minimum) at VGS 10V and VGS(th) Determine the drain current for…

A: Brief description: For the given enhancement MOSFET we need to derive the value of drain current ID…

Q: Two balloons with charges of +4.00 μC and -10 µC attract each other with a force of 0.0625 Newton.…

A:

Q: 7. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a…

A:

Q: Vi Solve for VCB and VCE. 10 μF + '47 ΚΩ B 10 ΚΩ 18 V ' 2.4 ΚΩ C ΦΕ 10 με 16 + Vc β=120 1.1 ΚΩ Vo

A:

Q: There are many different matching techniques. What are important factors required to select a…

A: Thre are different matching techniques however they all have certain important factors required to…

Q: 10.a. The type of stepper motor that has a pair of center-tapped windings is the A. closed-loop…

A: Motor:  An electric motor is a device that converts electrical energy into mechanical power. In most…

Q: Find the half-range Fourier cosine series of f(x) = (-x)² in the interval (0, π).

A: Fourier series: This is a mathematical tool for expanding the periodic signal in the term of their…

Q: bs all the energy delivered to me interval during which the f water rises from room tem

A: Given as, Voltage, V= 120 V, Current, I= 2 A.

Q: Three loads are connected in parallel to a 240-V, 60 Hz supply. Load 1 is composed of three 600-W…

A: In the AC electric circuit, the total power is known as the apparent power which has two parts…

Q: Describe the simulation of three phase induction motor

A: Three Phase Induction Motor: A three-phase induction motor is an electro mechanical energy converter…

Q: Q3) what is the dispersion taking place in long transmission lines? State the condition to obtain…

A: Transmission line distribution is an important aspect of signal performance. The behavior of this…

Q: We need to send data 2 bits at a time at a bit rate of 2Mbps for FSK modulation. The carrier…

A: Bandwidth: This is the range of frequency in which different frequencies signal lies. Outside the…

Q: 7. What is the minimum conductor ampacity, overload protection, and dual-element fuse rating for a…

A: Given,For a 3-phase motor,V=560vT=40°CP=125 hpIFL=115 A

Q: 10. For 12 V and 40 mA, the power is O(A) 480 mW O(B) 0.480 W O(C) 480,000 μW O(D) All of the above

A: Given, Voltage, V = 12 V Current, I = 40 mA

Q: 6.a. A 200 step-per-rotation stepper motor is attached to a table with a five-pitch lead screw. How…

A: Stepper Motor:  A stepper motor, sometimes referred to as a step motor or stepping motor, is a brush…

Q: 17.a. A type of lead screw that has squared-off threads is the A. Cross screw. B. Evans screw. C.…

A: Acme Screw used to translate rotary motion into linear motion. A type of lead screw that has squared…

Q: Q1. Answer/Interpret the following: Cp-142 HHH START Cp-3 1. Objective of this controller: STOP…

A: 1. Objective the given controller is The circuit opens the engine and the green light OPENs when the…

Q: v (A) = -20 Cos (377t +30) V +4

A: In this question we will find current through capacitor...

Q: DATE: connected load draws current i(t) = ECOS (100π € +30°). When voltage v() = 220 cos (1007€…

A:

Q: 37. If the impedance triangles of two transformers operating in parallel are not identical in shape…

A: The  Standard parallel operation of transformer can be done if the following conditions are…

Q: What are the topics in Fundamentals in Deformable Bodies that is essential in the profession of…

A: The solution is provided in the following section.

Q: Find I7 using Norton's Theorem

A: Given: Consider the given circuit: To find: The current I7 using Norton's Theorem.

Q: The load on a 120-V, 60 Hz supply is 5KW (resistive), 8 KVAR (inductive), and 2 KVAR (capacitive).…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Consider the following linear time-invariant discrete-time system which is casual.…

A:

Q: III-a) A steady voltage of -1.25V is applied to an op amp integrator having component values of…

A:

Q: his normal weight

A:

Q: Q1. All gates has two or more inputs except NOR gate XOR & XNOR AND gate None of the above NOT

A: Brief description :  Here in the above given question they want to know about logic gates.

Q: 3-phase, code A, 40°C, 75-horse- wer factor with a nameplate full-load

A: Given as, Nameplate full-load current =185A Minimum capacity of the conductor is 125%. full load…

Q: 3. You have seen how Kirchhoff's laws were used in your lectures to obtain a 2nd order differential…

A: Kirchoff's law states that the sum of all currents flowing through a closed is zero.

Q: Determine the current value Io in the circuit that is shown below?

A:

Q: Draw the circuit diagram of a non-inverting comparator and inverting comparator

A: Circuit diagram of non- Inverting and Inverting Comparator:

Q: What is the CPU time if the number of instructions executed by the program is 500, cycles per…

A: Answer: Option:- C  5,00,000 sec

Q: For an FM modulator with 48 kHz of frequency deviation and a modulation signal frequency fm= 8kHz,…

A: given an FM modulator with frequency deviation of 48 K Hzand modulation signal frequency fm=8 K Hz…

Q: 4. e principle of operation of a 3-phase. Induction motor is most similar to that of a (a)…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 7- A 6-pole, 50-Hz, 3-0 induction motor is running at 950 rpm and has rotor Cu loss of 6 kW. Its…

A: Given  Two multiple choice questions based on motors. Please find the below attachment for clear…

Q: compute for the center frequencey and wavelength in a dipole antenna with 1 reflector and 1 director…

A: An antenna is a communication device that transmits and receives signals to represent data. In the…

Q: power induction motor?

A: Given as, Voltage, V= 600-volt, Power, P=50 hp=50×746 W, Lets take, cos ∅=0.8.

Q: Q1/ Draw the bode plot below on the semi-log paper and find GM and PM for G(s)H(s) = 1…

A: The bode plot is used to find the stability of the system using frequency response analysis.

Q: Apply the Shockley's equation and draw the transfer characteristics of the JFET in he circuit shown…

A: Given data is IDss=10mA, VP=-10V The given figure is shown below.

Q: 3. What is the rated full-load current of a %4-horsepower, 208-volt single-phase motor?

A: We need to find out the current for given power