1)W... -0A 1550 kg spacecraft is moving sideways in deep space (so you don't have to worry aboutgravity) at speed of 6500 m/s, as shown above. The rocket engine is then turned on, applying aforce of 2700 N for 20 minutes.witha) What is the speed of the spacecraft after the 20 minute engine burn?does the sprby When the spring is extended 0.35 m longer than its equilibrium position, what is theb) What is the angle between the new velocity vector after the engine burn and thevelocity vector before the burn (which is sideways in the picture above)?d) When the spring is compressed byWhen the spring is comprspring?apting in comp1515of the 2

Answered: Image /qna-images/answer/16bc987c-6508-4e31-b929-bb3b4f62fa9b.jpg

1) WWW -Q A 1550 kg spacecraft is moving sideways in deep space (so you don't have to worry about gravity) at speed of 6500 m/s, as shown above. The rocket engine is then turned on, applying a force of 2700 N for 20 minutes. a) What is the speed of the spacecraft after the 20 minute engine burn? its b) What is the angle between the new velocity vector after the engine burn and the velocity vector before the burn (which is sideways in the picture above)?

1) WWW -Q A 1550 kg spacecraft is moving sideways in deep space (so you don't have to worry about gravity) at speed of 6500 m/s, as shown above. The rocket engine is then turned on, applying a force of 2700 N for 20 minutes. a) What is the speed of the spacecraft after the 20 minute engine burn? its b) What is the angle between the new velocity vector after the engine burn and the velocity vector before the burn (which is sideways in the picture above)?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter8: Potential Energy And Conservation Of Energy

Section: Chapter Questions

Problem 79AP: Consider a block of mass 0.200 kg attached to a spring of spring constant 100 N/m. The block is...

See similar textbooks

Similar questions

A fellow student tells you that she has both zero kinetic energy and zero potential energy. Is this possible? Explain.
(a) Sketch a graph of the potential energy function U(x)=kx2/2+Aex2 where k , A, and are constants. (b) What is the force corresponding to this potential energy? (c) Suppose a particle of mass in moving with this potential energy has a velocity v when its position is x = . Show that the particle does not pass 2+2 through the origin unless Amv2=k22(1e a 2 ) .
Assume that the force of a bow on an arrow behaves like the spring force. In aiming the arrow, an archer pulls the bow back 50 cm and holds it in position with a force of 150 N. If the mass of the arrow is 50 g and the “spring” is massless, what is the speed of the arrow immediately after it leaves the bow?
Consider a block of mass 0.200 kg attached to a spring of spring constant 100 N/m. The block is placed on a frictionless table, and the other end of the spring is attached to the wall so that the spring is level with the table. The block is then pushed in so that the spring is compressed by 10.0 cm. Find the speed of the block as it crosses (a) the point when the spring is not stretched, (b) 5.00 cm to the left of point in (a), and (c) 5.00 cm to the right of point in (a).
Check Your Understanding What potential energy U(x) can you substitute in Equation 8.13 that will result in motion with constant velocity of 2 m/s for a particle of mass 1 kg and mechanical energy 1 J?
In the Back to the Future movies (https://openstaxcollege.org/l/2lbactofutclip), a DeLorean car of mass 1230 kg travels at 88 miles per hour to venture back to the future. (a) What is the kinetic energy of the DeLorean? (b) What spring constant would be needed to stop this DeLorean in a distance of 0.1m?
A pendulum, comprising a light string of length L and a small sphere, swings in the vertical plane. The string hits a peg located a distance d below the point of suspension (Fig. P7.80). (a) Show that if the sphere is released from a height below that of the peg, it will return to this height after the string strikes the peg. (b) Show that if the pendulum is released from rest at the horizontal position ( = 90) and is to swing in a complete circle centered on the peg, the minimum value of d must be 3L/5. Figure P7.80
An electron in a television tube is accelerated uniformly from rest to a speed of 8.4107 m/s over a distance of 2.5 cm. What is the power delivered to the electron at the instant that its displacement is 1.0 cm?
A bungee cord is essentially a very long rubber band that can stretch up to four times its unstretched length. However, its spring constant vanes over its stretch [see Menz, P.G. “The Physics of Bungee Jumping.” The Physics Teacher (November 1993) 31: 483-487]. Take the length of the cord to be along the direction and define the stretch as the length of the cord minus its un-stretched length that is, (see below). Suppose a particular bungee cord has a spring constant, for of and for. (Recall that the of (Recall that the spring constant is the slope of the force versus its stretch (a) What is the tension in the cord when the stretch is 16.7 m (the maximum desired for a given jump)? (b) How much work must be done against the elastic force of the bungee cord to stretch It 16.7 m? Figure 7.16 (credit modification of work by Graeme Churchard)
The particle described in Problem 71 (Fig. P5.71) is released from point A at rest. Its speed at B is 1.50 m/s. (a) What is its kinetic energy at B? (b) How much mechanical energy is lost as a result of friction as the particle goes from A to B? (c) Is it possible to determine from these results in a simple manner? Explain.
A block of mass 0.500 kg is pushed against a horizontal spring of negligible mass until the spring is compressed a distance x (Fig. P7.79). The force constant of the spring is 450 N/m. When it is released, the block travels along a frictionless, horizontal surface to point , the bottom of a vertical circular track of radius R = 1.00 m, and continues to move up the track. The blocks speed at the bottom of the track is = 12.0 m/s, and the block experiences an average friction force of 7.00 N while sliding up the track. (a) What is x? (b) If the block were to reach the top of the track, what would be its speed at that point? (c) Does the block actually reach the top of the track, or does it fall off before reaching the top?
A particle of mass 2.0 kg moves under the influence of the force F(x)=(3/x)N. If its speed at x=2.0 m is v=6.0 m/s, what is its speed at x = 7.0 m?