1. A wire is connected from a support at ri = (0, 2.0, 8.0) meters to an object of mass 45 kg at ra (5.5, %3D 4.3, 3.2) meters. Find the tension in the wire, expressed as both x, y, and z components and as a magnitude and direction relative to the hanging mass. Take the acceleration due to gravity as acting in the negative k direction, i.e a = (0, 0, -g).

1. A wire is connected from a support at ri = (0, 2.0, 8.0) meters to an object of mass 45 kg at ra (5.5, %3D 4.3, 3.2) meters. Find the tension in the wire, expressed as both x, y, and z components and as a magnitude and direction relative to the hanging mass. Take the acceleration due to gravity as acting in the negative k direction, i.e a = (0, 0, -g).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

weighs 60 N on Earth. (3). A system consists of a pulley (vertical wheel) that is only allowed to rotate (spin). A cord is passed over the pulley and at each end there is a mass attached to the end of the cord. The mass attached on the left is m, =0.6 kg and at the right the mass is m2 = 0.8 kg. a) Calculate both the Tension in the cord and the acceleration of the system. b) What are the accelerations of both masses, if you were to cut the cord? Neglect the friction between cord and wheel,
100 Ib 50 Ib 45 250 lb 2. Determine M, P, and Q in the figure shown so that the resultant of the coplanar nonconcurrent force system is zero.
Q2/ A force of 100 N applied on a mass of body 25 kg moves at a constant acceleration, if the displacement function of the body is X = 2t + t2 , find th ce following: 1- the acceleration of body 2- The force of friction 3- The velocity of it at 5 second
Based on the newton's second low of motion, the mass is the force applied on a system Ture O False O
Two box hang from the ends of a string suspended from a frictionless pulley. The mass on the left is chosen to create a tension of 4 N in the string. The box on the right has a weight of 2 N. What will be the acceleration of the box on the right? Assume the acceleration of gravity is 9.8 m/s?. 4 N 2 N
Q2/ A Body of weight of 40 Kg is pulled along a rough horizontal plane by pull of 20 N acting at an angle of 14 with the horizontal. Find the friction force and normal force (reaction)? 20 N 40 Kg
Let us say that we have a ladder with its own length (L) and its own mass (m) this ladder just so happens to make a (θ) degree angle with a wall. The center of mass of this ladder is 1/3 of the way up from the bottom (it gets narrower towards the top). A person of mass M then decides to climb the ladder until he comes to the halfway point. Wall has no friction but the ground has on the ladder.. a) Draw this situation and label forces so you may set up the statics equations. b) Find the force on the ladder due to the ground (both x and y components) and the force on the ladder due to the wall.
The engine of an automobile develops 20hp when the automotive is traveling at 50 km/hr. What is the resisting force in Newton? If the resisting force is proportional to the velocity, what horsepower will drive at 25 km/hr?
PROBLEM 4.0 Find the value of Friand Fr2 and the acceleration of each body. P₁ FT2 A 200 N FTI B 300 N P₂
A block moves up a 30° incline under the action of certain forces, three of which are shown in Fig. 6-2. F, is horizontal and of magnitude 40 N. F, is normal to the plane and of magnitude 20 N. F3 is parallel to the plane and of magnitude 30 N. Determine the work done by each force as the block (and point of application of cach force) moves 80 cm up the incline. 30 F cos 30° 30° Fig. 6-2
Q2/ The out - of - balance of a machine rotor is equivalent to 5 kg at 10 mm radius in one plane A, together with an equal mass at 15 mm radius in a second plane B. AB = 375 mm and the two radii are 120°. Find the mass required in third plane C at a radius of 125 mm and its angular position with respect to the given radii so that there is no resultant out - of - balance force. Find also the position of C along the axis for the residual couple to be a minimum and of this couple when the speed is 500 r.p.m.
THERMODYNAMICS Prob 1. A piston weighs 4.3 kgs and has a cross sectional area of 450 mm2. Determine the pressure that is exerted by this piston on the gas in the chamber, as shown in the figure. Assume gravitational acceleration 'g' to be 9.81 m/sec?. Piston Gas Prob 2. Find the mass of air in a closed chamber measuring 35 ft x 20 ft x 10 ft, when the pressure is 17 Ib/in? and the temperature is 75°F. Assume air to be an ideal gas.