1. The distance of 25 km has to be carried a power of 12 MW. Because the line is uncompensated, k factor is 0.1, determine the following: a. The Line voltage. %3D b. The conductor size. c. The voltage regulation

1. The distance of 25 km has to be carried a power of 12 MW. Because the line is uncompensated, k factor is 0.1, determine the following: a. The Line voltage. %3D b. The conductor size. c. The voltage regulation

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.10MCQ: Transmission line conductance is usually neglected in power system studies. True False

See similar textbooks

Related questions

Q: A 30 mile, 3-phase transmission line delivers 8,000 kW at 33 kV, p.f. 0.8 lagging. The resistance…

Q: If a transmission line has to be designed with an ultimate strength 6000 kg and a safety factor of…

Q: 13.) In practice, what would happen to the transmission line voltage when it is heavily loaded and…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Vo coswt Z, = 50 10

A: V(L) = V+ejBL [1+τej(ϕL-2βL)] I(L) = V+ejBLZo [1-τej(ϕL-2βL)]

Q: One of the following factor, which will not affect the resistance of the transmission line.…

A: One of the following factor, which will not affect the resistance of the transmission line?

Q: The conductor configuration of a bundled single-phase overhead transmission line is shown in figure…

A: Given radius r=2 cm length =10,000 ft =1000×0.3048 =304.8 m resistivity =7.8×10-8 Ω m frequency is…

Q: 6. Verify that the volume of conductor required in a transmission system is inversely proportional…

A: Power in Three-Phase circuit- Power depends on voltage, current and power-factor. Law's of…

Q: A transmission line has a span of 150m between level supports of 16 meter height. The ground…

A: Span of transmission line is given span =150 m Height is given h = 16 m Ground clearance = 90 %

Q: Q1/ Explain in detail VOLTAGE DROP / RISE IN TRANSMISSION LINE With mathematical examples

Q: In the analysis of Short Transmission Lines, the Lines should be in which type of Three-Phase…

A: SOLUTION- for short transmission lines show three phase connection used constellation diagram

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: As given in the question transmission line (L) = 150 Height from the bottom is = 10 meter…

Q: Question 03: What is the difference between balanced and unbalanced line transmission lines, show…

A: We need to state the differences between balanced and unbalanced transmission lines.

Q: While studying the performance of medium transmission linos, only resistance and of the line are…

A: Given About the performance of the medium transmission line

Q: 3. Consider the following 3-phase transmission line with a conductor geometry symmetrically spaced…

Q: 2. A single phase transmission line has two parallel conductors 2.5 m apart, the radius of each…

A: Solution of given Q is showing in step 2

Q: In an over head transmission line the weight on the conductor due to wind is 2.35 kg. The total…

A: In overhead line weight on the conductor due to wind = 2.35kg Total weight = 3.45kg No ice loading…

Q: 1. A single-phase transmission line is composed of two solid round conductors having a radius of…

A: Given: Single phase transmission Radius of conductor, r=.45 cm Distance between conductors, d=350 cm

Q: Determine the current in the neutral conductor and the current in each line conductor (i.e., IR, IB…

A: A 3-Φ, four-wire system is shown below: The phase voltage and the line voltage in a star…

Q: The voltage, current and power factor at the sending end of a single-phase transmission line are…

A: In this question we need to find a voltage at load side of transmission line

Q: 400MVA power is transmitted with 380kV voltage and 18.1948 degree power angle with the help of a 500…

Q: a single phase overhead transmission line delivers 4000k w at 11 kV at 0.8 pf lagging. If resistance…

A: First we will calculate receiving end current from given values, using formula we will find sending…

Q: Example A single phase transmission line has two parallel conductors 3 m apart, the ra- dius of each…

Q: 2. In this experiment, the three line-to-line voltages A, B and C are 120 electrical degrees out of…

A: Line voltages are displaced by 120 degree Phase voltage are displaced by 120 degree Line voltage…

Q: Н.W. 3-phase bundled conductor line with two sub-conductors per phase has a horizontal configuration…

Q: Using sketch discuss the impact of following terms occurred in the transmission line conductors: i)…

A: (i) Corona effect :- Corona is the self electric discharge of atmospheric air. If the operating…

Q: 7. Does the length of an ac transmission line affect the values of the characteristic impedance and…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: A single circuit three-phase line operated at 60 Hz is arranged as shown in figure. The conductors…

A: Given data for the question is Frequency = 60 Hz Distance between conductors suppose we give them…

Q: If the per-phase line loss in a 60-km-long transmission line is not to exceed 60 KW while it is…

A: Considering the given data:

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: Q: 4 Figure below shows a 345 kV double-circuit three-phase transposed line composed of two ACSR,…

A: given the configuration is as shown above. now the conductor has a diameter of 1.472 in and GMR is…

Q: (k) Determine the economical cross-sectional for a single phase transmission line, 1 km transmission…

A: For the 3 phase transmission line of 1 km and a voltage of 110 kV. Thus, the load cycle is, 6 hr 20…

Q: Single Phase Transmission Line has two parallel conductors 2 meters apart. The diameter of each…

Q: The transmission line has the following data weight of the conductor = 8.2 kg/m, working tension =…

A: sag in transmission line ,sag(s) = wl28T

Q: a) A single-phase transmission line has two parallel conductors m apart, the radius of each…

A: For the two-conductor transmission line system, the loop impedance per m length of the line can be…

Q: An overhead transmission line has a span of 250 m and the weight of the line conductor is 0.68 kg…

Q: Determine Ly, Ly, and LT in H/m for the single-phase two-conductor line shown below. All conductors…

Q: A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4…

Q: Which among these statements is false or incorrect about Transmission Lines? A. It is possible to…

A: Choose the False or Incorrect statement among given options about Transmission lines?

Q: Question # 03: What is the difference between balanced and unbalanced line transmission lines, show…

A: Given: The difference between the transmission lines which are balanced and unbalanced is asked.

Q: In a 380 kV three-phase transmission system, the diameter of the overhead lines in the form of…

A: Part (a): The line voltage is given as 380 kV. The disruptive critical voltage is determined as:…

Q: A single-phase transmission line has two parallel conductors 4 m apart, the radius of each conductor…

A: Part i: Write the expression for the external inductance per meter length of one conductor,

Q: In an over head transmission line the conductor weight with ice loading is 2.35 kg. The total weight…

A: As per bartleby guideline for more than one question asked only first is to answered please upload…

Q: What is the purpose of an overhead transmission line? How are these lines classified

A: The purpose of an overhead transmission line is to transfer power from one place to other place (…

Q: Problem 1 Explain the meaning of the term "bundle conductor transmission line" and discuss the…

A: Part (a) - Introduction - In some transmission lines, despite of a single conductor per phase,…

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: Consider the diagram shown in Figure below

Q: : A single circuit three-phase transmission line is composed of four ACSR conductors per phase with…

Q: Estimate the distance over which a load of 15000 kW at 0·85 p.f. can be delivered by a 3-phase…

Q: Bundled Conductors are done in order to reduce the diameter of the cable to used to carry huge…

A: 1)Bundled conductors are used to reduce corona loss. 2)It leads to reduction in line inductance and…

Question

Please solve asap.

1. The distance of 25 km has to be carried a power of 12 MW. Because the line is
uncompensated, k factor is = 0.1, determine the following:
a. The Line voltage.
b. The conductor size.
c. The voltage regulation

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

High Voltage level in Transmission system ensures ………………… a. High current in Overhead conductors b. Less power factor c. Low Power Transfer d. Reduction in conductor size
Find the GMR of this conductor as r.( Need handwritten solution only please otherwise downvote)
An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650 kg per 100 meters. Calculate the maximum SAG in the conductor. If the height of the tower is 13 meters, estimate the clearance of conductor to the ground. Draw a figure and mark values of sag, clearance, span, height of conductor etc.
In a three-phase line, in order to avoid unequal phase inductances due to unbalanced flux linkages, what technique is used?
Question 1) A 154 kV transmission line has a length of 100 km. The line and the conductors are given in Figure 1. The line is operated at f= 50 Hz. For both old and new lines calculate; a. GMD and GMR. b. Inductance of the line in Henries (H). c. Series Impedance (Z) of the line in Ohms. d. *Compare the results for both lines and comment on the results. e. *If the distance between the two neighbouring conductors is increase from 13 meters to 15 meters what would be the parameters in part a.,b. and c. comment on the results. New Line's Conductors 13 m 13 m Old Line's Conductors d r = 2 cm d = 40 cm r = 2 cm Figure 1
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
Problem #1 • An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650 kg per 100 meters. Calculate the maximum SAG in the conductor. If the height of the tower is 13 meters, estimate the clearance of conductor to the ground. Draw a figure and mark values of sag, clearance, span, height of conductor etc.
12. There are 6 conductors in a double circuit line. Each conductor has a radius of 12 mm. The 6conductors are arranged horizontally. The center to center distance between the conductor is 2m. The sequence of conductors are from left to right as follows: a,b.c,a', b', c'. Calculate the inductance per km per phase of system. the a' 2 m 2 m 2 m 2 m 2 m
In a string of suspension insulator with three units, the line unit has 20kV and k=0.35. The voltage across tower unit is........ and across middle unit is.......
A dc two line distributor AB 600 metre long is fed at 440 V from substation A and at 430 V from substation B, the load are: 100 A at C (150 m from A), 200 A at D (150 m from C), 250 A at E (50 m from D), 300 A at F (100 m from E). If each line conductor has a resistance of 0.01 ohm per 100 m, calculate the current supplied from substation A and B and the voltage across each load.
What is load line and what is duty cycle?
10- If power factor is less than unity then it will result in a. Large kVA rating of equipment b. Large copper losses c. Greater conductor size d. Large kVA rating of equipment, Greater conductor size and Large copper losses