Answered: 1. The total inductance for this…

Engineering

Electrical Engineering

1. The total inductance for this circuit is mh. 4 h 2h 3h L

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PP: Two capacitors having values of 80 F and 60 F are connected in series. What is the total...

See similar textbooks

Related questions

Q: SMF more efficient over long distances than MMF?

A: Given: Why is SMF more efficient over long distances than MMF?

Q: Q3: a) Consider the modulated signal s(t) indicated below where the modulating signal is…

A: Giving a wave or signal the amplitude or frequency of another wave or signal is known as modulation.…

Q: If VOUT is pointing at half of the potentiometer, then the value of VOUT is Vs + 15 V R₁ 10 kQ2 R₂…

A: Given circuit, Vout is pointing at half of the potentiometer. Rout=R22=10 kΩ2=5 kΩ

Q: Calculate the output voltage at t=5μs. Round-off to 2 decimal places and write your answer in the…

Q: If resistances of 10ohm, 20ohm, 30ohm are connected in parallel and supplied with 240 volts,…

Q: H.W.2 For the circuit shown, determine the feedback topology & determine Ave, Rif. Rof pvcc В 1.2k W…

Q: Problem 3) Find the loop currents I and IB and the current Io in the circuit shown using loop…

A: Given circuit,

Q: 기아 장 ~ 154

A: Given, The circuit is,

Q: A 4 pole d.c. generator runs at 750 r.p.m. and generates an emf of 240 V. The armature is wave wound…

A: Solution:Given data;D.c. generator,Pole p=4, Runs N=750 r.p.m,e.m.f E=240 V,Armature Wave.…

Q: Q1- Draw the root locus for the control system whose open-loop transfer K function is:…

Q: There are 175 slots in a 3-phase, 16-pole, 50 Hz., star connected alternator. There are 4 conductors…

A: We have an star connected alternator we have, slots = 175 Poles (p) = 16 frequency (f) = 50 Hz 4…

Q: What is the low frequency input resistance, Ri, in ko for the amplifier shown at 27° C with Rc =…

A: The above question is based on the small signal low-frequency analysis of pnp BJT. To solve this,…

Q: H.W.2 For the circuit shown, determine the feedback topology & determine Ave, Rif. Rof pvcc В 1.2k W…

Q: With the load ROD disconnected, compute the open circuit voltage Vab With the load connected,…

A: Given- Source voltage Vin = 12 V Load resistance, RLoad = 5 k ohm To find- Voltage across ab Vab = ?…

Q: Consider an RC coupled amplifier at low frequency. Internal voltage gain is -120. Find the voltage…

A: Given: Internal voltage gain is -120 Collector resistance is 1 kohm The load is 9 kilo ohm The…

Q: s²+35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38 The…

A: It is given that: Ys=s2+3s+k2s3+4s2+5s limt→∞yt=38

Q: In 132 kV transmission system, the phase to ground capacitance is 0.01 µF. The inductance being 6 H.…

A: We have an 132 KV transmission line with, Phase to ground capacitance (C) = 0.01 μF = 0.01 * 10-6 F…

Q: Q1-A- Find the unit-step time response of the closed-loop second-order control system of the…

Q: Design the following Boolean functionF(A,B,C,D) = ∑ (1,3,5,7,13, 15) using a decoder

A: Given- F(A,B,C,D) = ∑ (1,3,5,7,13,15) Find- Design given Boolean function using decoder

Q: Kindly give explanation i already have answer A business uses two 3 kW fires for an average of 20…

Q: (a) A 2 PSK modulates the phase of the carrier AСos2fct so that binary 1 corresponds to 0 rad phase…

A: To do: a) we have to explain the modulation and coherent detection of BPSK. b) we have to…

Q: What Is the jobs done by registers inside a CPU

A: A register is each of a small set of knowledge-holding locations that are part of a pc processor. A…

Q: Nichrome wire is used in some radiative heaters. What length of Nichrome wire, having a…

A: Given: A=5 mm2 and T=500°C Required: Length of the nichrome wire.

Q: A diesel engine power plant has one 600 kW and two 250 kW generating units. The fuel consumption is…

A: We have an diesel engine power plant with total of 3 units, 1 unit of 600 KW 2 unit of 250 KW Fuel…

Q: Find the number of turns N, required to establish a flux p = 12 × 10¹ Wb in the magnetic circuit…

A: ⇒ϕ=N2I2lμμoA⇒12×10-4D=40×3×μ×4π×10-7×0.00120.2⇒μ=1326.29

Q: 14. In the circuit below, E₁ = 25 V and E₂ = 12 V. Find the current I. A. B. C. +0.2 A D. -0.2 A E.…

A: Given circuit,

Q: Problems Two resistors are connected in series as shown in the following figure. What is the current…

A: Given circuit:

Q: 1.25 Fig 1.5 + v PSPICE The voltage and current at the terminals of the circuit element in Fig. 1.5º…

Q: find the result

Q: 1) Determine the transfer function for the system given below. R(S) S+1 C(S)

A: In this question, We need to calculate the transfer function . Transfer function is define the…

Q: The quality factor of a bandpass filter that has an upper cutoff frequency of 121 krad/s and a lower…

A: Given data, Upper cutoff frequency, fH=121 krad/s Lower cutoff frequency, fL=100 krad/s

Q: B- For the closed-loop control system of the open-loop transfer function Find the minimum value of K…

Q: If the output power from an audio amplifier is measured at 100W when the signal frequency is 1kHz,…

Q: d²y du 5. A control system is described by +3x+2y= + u. Where 'u' is input dt² dt and 'y' is output.…

A: Apply laplace transform to the differential equation. Ratio of laplace transform of output to the…

Q: Sketch the single-sided and double-sided spectra of x(t) = 2 sin (10nt - 1)

Q: A certain amplifier has r.m.s. output voltage of 10 V. What is the r.m.s. output voltage for gain…

A: Given, An amplifier has rms input voltage, Vin=10 V Voltage gain, AV=-3 dB

Q: What difficulties may designers and manufacturers have when building and producing semiconductors…

A: The fabrication process of the semiconductor to integrate billions of transistors in a single chip…

Q: 68. A negative voltage feedback amplifier has voltage gain without feedback, A, = 1000 and feedback…

A: Given: A negative voltage feedback amplifier has, Voltage gain without feedback, Av=1000 Feedback…

Q: number 2 and 3

Q: Q2- A- Find the static steady-state error shown by the systems of bpen-loop transfer function…

A: In this question we need to find the static steady state error for the given system

Q: дноши for the lossless transmission lin below, the ti is driven with a generator that has Eg=30…

A: A transmission line is referred to as lossless if it has no line resistance or dielectric loss. The…

Q: Sketch the single-sided and double-sided spectra of x(t) = 3 + 4 cos(20nt +30) + 2 sin(60nt) - 4…

A: Quantity squared RMS, where quantity is the unit of the time-domain signal, is frequently used to…

Q: what is the value of current flowing through the forward biased diode

Q: ....... is the decimal symbol for hexadecimal 3AD

A: Given data is hexadecimal 3AD. Find the decimal symbol.

Q: Compute the average value of the sinusoid shown in Figure 8.3, where , denotes the peak (maxi- mum)…

A: Given:

Q: ) A 200mA, 50Hz AC current source (of negligible output impedance) is connected across the same RL…

Q: A 200 MW power station delivers 200 MW for 3 hours, 70 MW for 6 hours and is shut down for the rest…

A: We have an power station and we have been asked to find its annual load factor. Power station…

Q: R31=25 R23=75 (a) R12=50 2 R3 R1 (b) R2 De 2

Q: Sketch the root loci for the system shown in the figure below R(s) K s(s+1) (s+2)

Q: H.wlsवे The minium Mu Multy plexers using to design 128 to 1 multy plexer are. ?

A: Given: 128×1 MUX MUX: MUX is also known as multiplexer. Multiplexer combining multiple inputs into a…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

1. The total inductance for this circuit is,
mh.
4 h
2 h
3h

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
List the five capacitor replacement rules.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Three capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)