10. A beaker is filled with a liquid of density p1 up to a certain height. A is a point, h m downwards from the free surface such that the pressure at A is P. If the liquid is replaced by equal volume of another liquid of density p2, at what distance from the free surface will the pressure be P now?

Q: The inclined pipe shown in the figure is used to carry oil (p = 900 kg/m³, μ = 9x10-3 Pa.s) The pipe…

A: Solution: Given: ρ=900 kg/m3 μ=9×10-3Pas D = 20 cm =0.2 m L = 300 m V = 3 m/s

Q: 3. The arm of a teapot is 10 cm long and inclined at an angle of 60° to the vertical. The center of…

A: To determine the pressure at the base of the beaker.   Given, Length of arm of the teapot, say L =…

Q: 4. A horizontal pipe carries cooling water from a reservoir as shown in the following figure. If the…

A: Given: The pipe diameter is 20 cm. The flow rate is 0.06 m3/s. The length of the pipe is 2000 m.…

Q: 9.2 (A). Determine the change in volume of a thin cylinder of original volume 65.5 x 10~³m³ and…

A: A cylinder whose ratio of thickness to its internal diameter is less than (1/10) to (1/20) then that…

Q: (3) An open jet of water at 20 °C exits a nozzle into sea-level air and strikes a stagnation tube,…

A: Consider the free body diagram ; Given data Pressure at section-1 (P1) =110kpa…

Q: A vertical cylindrical tank is 9 m high and 5 m in diameter. It is two thirds full of water and is…

A: Solution 1) Solution Given Data Cylindrical tank height= 9 m Diameter= 5 m Rotational speed= 48 rpm

Q: Q1) A pipe line 30 cm in diameter and 3200m long is used to pump up 50 kg/sec. of an oil where its…

A:

Q: A closed tank is partially filled with glycerin. If the air pressure in the tank is 6 lb/in.² and…

A:

Q: Determine the diameter of an orifice that permits a tank of horizontal crosssection 1.5m2 to have…

A:

Q: In figure 2.5, if the pressure of gas in bulb A is 50 cm Hg vacuum and Patm = 76 cm Hg, the height…

A:

Q: -32 Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading…

A: Manometer- These are the devices that are used to measuring the pressure at a point in a fluid.…

Q: In the figure below, pipe A contains gasoline (S.G.=0.75), pipe B contains oil (S.G.=0.91) and the…

A:

Q: A hydraulic jack contains 2.0 litres of oil as the working fluid. The compressibility of the oil is…

A: Finding out absolute decrease in the volume of the oil.

Q: 7. An arm of a teapot is completely filled with tea (density=p) If the arm has a length of I and is…

A: To determine the pressure difference between points C and D, as shown in the figure.   Given,…

Q: 3. The open trapezoidal tank shown in the figure is initially filled with oil (SG = 0.80) up to a…

A:

Q: Oil flows through a smooth pipe of diameter D = 4 cm between points (1) and (2) that are 4 m apart…

A:

Q: Please help with solving

A:

Q: Calculate the discharge through a pipe of diame ter 200 mm when the difference of pressure head…

A: Given: Diameter of pipe, d = 200 mm = 0.2 m Length, L = 500 m Pressure head difference, hf = 4 m…

Q: The two pistons in the figure below are moving to the left. Piston A has a speed twice as great as…

A:

Q: 2) An open cylindrical tank contains 2 liquids with specific gravities and depth as follows: Liquid…

A: Given data, Liquid 1: SG = 1 Depth h = 1.3 m Density = 1000 kg/m3 Liquid 2: SG = 1.5 Depth H = 1.35…

Q: 3. Determine the level "y" of the oil (SG=0.80) in the right hand tube as shown in the figure. Both…

A:

Q: 1. Hydrostatic force on a curved surface Consider the container with the half-sphere dome, filled…

A: radius of sphere R = 1 m Height = 10 m

Q: n the figure below, both tank and the tube are open to the atmosphere. If L = 2.13 m, what is the…

A:

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A:

Q: A tank contains oil sg=0.80, gasoline sg=0.90, and sea water sg=1.05. What is the pressure at a…

A:

Q: 2m (water) 9. R 2m C. R=2m (water) di

A: Given data  Radius  Compound curve Water Depth if emersion

Q: A 3m Oil: 2m S.g. = 0.9 %3D (F), B 2m Water (F,

A:

Q: 5. If the pressure in a tank of oil (sp gr 0.85) is 3yx kN/m2, what is the equivalent head (a) in…

A:

Q: The gauge pressure reading at B is used to measure the pressure at point A in a water flow. If the…

A:

Q: 5. A beaker is filled with a liquid up to a height h. If A and B are two points, one on the free…

A:

Q: The funnel is filled with water and oil to levels shwon. Determine the depth of oil h' that must be…

A: Given :

Q: Solve the following problems 1. With 30 liters/sec of water flowing as shown in figure, what…

A:

Q: A container 10 m wide and 10 m long contains water 2 m high and is accelerating to the right at a…

A:

Q: 3. A solid cylinder d= 100mm and h = 95mm weighing 3.75N is immersed in a liquid SG = 0.9 inside a…

A: Let the height above the Liquid surface =h mLet the height above the Liquid surface =0.095-h mSO…

Q: B) The pressure in the tank at B is 500 kPa, as shown in fig.(5). If the differential elevation of…

A: According to the given figure, we can identify it as an inverted manometer. An inverted u-tube…

Q: An open 5 m square tank containing water 2 m high is moving at constant acceleration of 3.5 m/s?.…

A:

Q: In figure 2.5, if the pressure of gas in bulb A is 50 cm Hg vacuum and Patm = 76 cm Hg, the height…

A:

Q: Three liquids given the following properties are poured into the cylindrical container with a…

A: To Find Pressure at 0.5 m above the tank bottom.

Q: n the figure,which fluid will a pressure of 700kPa first be achieved? P. = 90kPa ethyl alcohol,p =…

A:

Q: 10.1. Liquid of weight density y flows uniformly down an inclined plane of slope angle 0. Derive an…

A: A rough image of the given flow condition is shown below:

Q: The surface tension of mercury at 60°C is 0.47N/m. What capillary height in mm will occur in this…

A: Given Data,  Surface tension = 0.47N/m Radius of glass tube(r)=0.3mm Diameter of glass tube…

Q: 7. What is the pressure value (PA) needed to achieve equilibrium for the figure shown (kPa)? a. 0.59…

A:

Q: 9. A beaker is filled with a liquid of density p1 up to a certain height. A is a point, h m…

A: Solution : The pressure at point A will be decreased according to the condition which is mentioned…

Q: In figure 2.5, if the pressure of gas in bulb A is 50 cm Hg vacuum and Patm = 76 cm Hg, the height…

A:

Q: Q1: the pressure at point A is 172 pa. All fluids are at 20°C. The air pressure in the closed…

A: to find pressure at point B

Q: and n, in feet of fluid A, when: A. Fluid A is gasoline (sp gr 0.715), the gage liquid is mercury,…

A: Writing pressure equation:Pm+γA4.2+z-γgz=PnHead diff=Pm-PnγA=4.2+z-γgγAz

Q: Given the bulk modulus of water B2.1x10 Pa2.1 GPa, What increase in pressure needs to be applied to…

A:

Q: 0.20 m h 0.20 air m y 0.60 m 0.60 (0.60) = 0.40 I 0.30 m 0.30 m 0.30 0.30

A:

Q: A tank contains three liquids, oil with a specific gravity of 0.8, gasoline with a specific gravity…

A: Given data  Specific gravity of oil = 0.8  Specific gravity of gasoline = 0.9  Specific gravity of…

Q: 1. The cylinders are piled in a rectangular ditch as shown. Neglecting friction, determine the…

A: Given that ,WA=15 lb ; RA=4 inWB=40 lb ; RB=6 inWC=20 lb ; RC=5 in…

Asphalt Binders and Mixtures

Asphalt binders are subsidiary products procured during the refining process of petroleum while manufacturing gasoline, diesel, and similar petroleum products. Asphalt binders are obtained from the residue that remains after the distillation of petroleum, this residue is further subjected to steam distillation and oxidation to remove the traces of gas oil present in the residue. Certain additives or modifiers are also added to asphalt binders to alter them to suit different applications.