11. As the light irradiance level goes up, what will happen to the current? A. Current stays the same but voltage goes up B. Voltage stays the same but current will Increase C. Current and voltage will both Increase D. Nothing happens 12. What is the cell temperature that the modules are tested at? A. 15° C В. 20° с С. 25° с D. 30° C 13. The conversion of power from DC to AC is usually about A. 20% - 30% efficiency B. 40%-50% efficiency C. 60%-70% efficiency D. 80%-90% efficiency 14. The amp hour measure the. A. Total resistance of the module B. Accumulated current flow C. Peak power D. Power loss of a module 15. In an incandescent lamp, what percent of energy is used for light? A. 10 В. 20 С. 30 D. 40

11. As the light irradiance level goes up, what will happen to the current? A. Current stays the same but voltage goes up B. Voltage stays the same but current will Increase C. Current and voltage will both Increase D. Nothing happens 12. What is the cell temperature that the modules are tested at? A. 15° C В. 20° с С. 25° с D. 30° C 13. The conversion of power from DC to AC is usually about A. 20% - 30% efficiency B. 40%-50% efficiency C. 60%-70% efficiency D. 80%-90% efficiency 14. The amp hour measure the. A. Total resistance of the module B. Accumulated current flow C. Peak power D. Power loss of a module 15. In an incandescent lamp, what percent of energy is used for light? A. 10 В. 20 С. 30 D. 40

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter3: Static Electricity

Section: Chapter Questions

Problem 7RQ: A thundercloud has a negative charge, and an object on the ground has a positive charge. Will the...

See similar textbooks

Similar questions

8. Liquids with solid impurities a) Have higher dielectric strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average de voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
Make a sketch of a sine wave shape for a standard 120 V as power line. show the exact number of cycles that occur during 1/10 of a second.
Discuss the difference between Alternating Current (AC) and Direct Current (DC)
Alternating voltage and current differ from direct voltage and current because alternating voltage and current a.)never change. b.)change polarity. c.)maintain a constant polarity. d.)are not real electricity The period (T) of a waveform is a.)unrelated to the frequency. b.) the reciprocal of the frequency. c.)equal to the frequency. d.)the reciprocal of the cycle
3-9 An rms ac voltmeter and a peak-to-peak-reading ac voltmeter are to be used to determine whether three ac signals are sinusoidal. Deter. mine whether the signals are sinusoidal if the following readings are obtained First signal Second signal Third signal peak-to-peak reading = 35.26 V rms reading. - 12.00 V peak-to-peak reading - 11.31 V rms reading = 4.00 V peak-to-peak reading = 25.00 V rms reading -8.83 V
A thundercloud has a negative charge, and an object on the ground has a positive charge. Will the lightning discharge be from the cloud to the ground or from the ground to the cloud?
so then how is Rth 0.8695 kOhms in the original explanation?
Highvoltage
Listen Regarding a Sine wave of an A.C. voltage (pictured below for reference), changing the Volts per division setting results in which of the following? O a) Changes the actual frequency of the waveform. O b) Changes the actual period of the waveform. O c) Changes the actual voltage level of the waveform. O d) Has no effect on the actual voltage level, period or frequency of the waveform.
Q18. An AC waveform is shown in figure B3. 4 10 20 30 40 50 70 100 Time (ms) 110 -2 -3 -4 -5 Figure B3 i) For the above waveform, determine a. Peak-to-peak voltage b. Time period c. Frequency ii) For the above waveform, determine a. Peak Factor b. Form Factor
Answer the question briefly. 1. What is Alternating Current (AC)? Draw a simple graphical representation of AC. 2. What are the advantages of using alternating current over direct current?
a. individal current b. voltage source