14. If the center conductor of a coaxial cable is made to have smaller diameter, all other things being equal, what will happen to the Zo of the transmission line? A. It will increase. B. It will decrease. C. It will stay the same. D. There is no way to know.

14. If the center conductor of a coaxial cable is made to have smaller diameter, all other things being equal, what will happen to the Zo of the transmission line? A. It will increase. B. It will decrease. C. It will stay the same. D. There is no way to know.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.3P: A transmission-line cable with a length of 2 km consists of 19 strands of identical copper...

See similar textbooks

Related questions

Q: A transmission line conductor at the water crossing was supported by two towers of height 35 m and…

Q: 2. Solve the following question and submit the solution before the deadline. A transmission line…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: What is the minimum-size supply-side bonding jumper required if installed on the line side of a…

A: The supply-side bonding jumper is installed on the line side of a 300-ampere service disconnecting…

Q: (b) A transmission line conductor with weight per unit of 1.55 kg/m is installed between two towers…

Q: HW: For fiber optic, is it better to get BLP with low value or large value and why?

A: BLP is expressed as Bandwidth length product BLP states that the given signal frequencies can be…

Q: An over head transmission line has a cross area of conductor of 4 cm and supported from two towers.…

A: Given: For an overhead line supported at the same level, weight per meter length of conductor w=6 N,…

Q: The towers of height 45 m and 85 m respectively support a transmission line conductor at water…

Q: Choose the correct Answer: ETC Department of UTAS-NIZWA wants to install the cable in the computer…

A: There are three fiber optical cables are given as we know fiber optical cable has high bandwidth.…

Q: Which type of conductor is not used in cables for Transmission Lines? A. Lead B. Steel C. Aluminium…

A: conductor is the most important component of a transmission line. A good conductor should have the…

Q: An over head transmission line has a cross area of conductor of 4 cm and supported from two towers.…

A: In the given question The Cross area of the conductor is = 4cm The distance between the…

Q: A transmission line has a span of 150m between level supports of 16 meter height. The ground…

A: Span of transmission line is given span =150 m Height is given h = 16 m Ground clearance = 90 %

Q: Explain about the significant of using copper in undersea transmission system?

A: According to question we have to explain about, significant/advantages of copper in undersea…

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: As given in the question transmission line (L) = 150 Height from the bottom is = 10 meter…

Q: Give the raceway size required for each of the following conductor combinations: 1. Three, 1/0 AWG…

A: Given information, Three, 1/0 AWG and 1 AWG with THW type insulation is to be carried by EMT…

Q: Explain what will happen to the characteristic impedance when the spacing between the center of two…

A: We know direct formula of two conductor transmission line.

Q: 4.15 Find the GMR of a stranded conductor consisting of six outer strands surrounding and touching…

Q: pomy I. An overhead transmission line at a river crossing is supported from two towers at heights of…

A: Transmission Line: In electrical engineering, a transmission line is a specialized wire or other…

Q: (i) Explain the major components of a high voltage transmission lines with suitable diagram. Label…

A: The bulk transportation of electrical energy from a generating station to a substation is known as…

Q: An over head transmission line has a cross area of conductor of 4 cm and supported from two towers.…

Q: Which type of conductor is not used in cables for Transmission Lines? О А. Соррer O B. Aluminium O…

A: A conductor is the most important component of a transmission line. A good conductor should have the…

Q: 1. Identify and describe the step-by-step process used to pull cable and also describe the…

A: The step-by-step process used to pull cable STEP 1: Check the Cable Width and Pipeline to make sure…

Q: Question # 04: Justify: why low attenuation and immunity to electromagnetic interference are the…

A: The fiber optical cable is made up of non-conductive cable, thus there are no metallic conductors,…

Q: The towers of height 35 m and 95 m respectively support a transmission line conductor at water…

Q: a). What is the reason for providing sag in an Overhead transmission line? b). List any two…

A: Whenever there is a need to send electricity to far off long distances, then the usage of overhead…

Q: An over head transmission line has a cross area of conductor of 4 cm and supported from two towers.…

Q: Explain the two main testing process used in testing transmission cables.

A: Fiber optics is a technology that is connected with the transmission of information as light rays…

Q: Can coaxial cable terminate with RG-6 coaxial cable

A: Coaxial cable can be used to transmit a variety of signals, including cable television, internet and…

Q: Explain Basic Trip Circuit in Transmission line? Also, Discuss the Fundamental Requirements of…

A: Protection refers necessary isolationof healthy system from faultysystem, so that fault can not…

Q: a List the factors affecting the sag of a transmission line. (write any three factors)

Q: 20. If a cable assembly such as a metal-clad (MC) cable includes an equipment grounding conductor…

A: given a mcq on optical cables and the coloured used for MC cables.

Q: Which fibre is utilised to protect the inner core and prevent the cable from straining in…

A: The explanation is as follows.

Q: What is the benefit of using stranded conductors in transmission systems?

A: the advantages of stranded conductors are given below:

Q: Identify the minimum distance requirements between network cables and power sources and identify…

A: 50 mm is the minimum distance required between the power source and network cables.

Q: (i) Explain the major components of a high voltage transmission lines with suitable diagram. Label…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 1. What is the effect of unsymmetrical spacing of conductors in a 3-phase transmission line ?

A: Unsymmetrical spacing occurs when the distance between the three phase line conductors is not equal,…

Q: Types of conductor used in transmission line.

A: The types of conductor used in transmission line is as follows: 1. ACAR ( Aluminium Conductor Alloy…

Q: 2) Write down the specification and types of insulators used in transmission line

A: The electrical insulator is a device that provides the required insulation between the line…

Q: If a transmission line has to be designed with an ultimate strength 7000 kg and a safety factor of…

A: Given Length of span (l) =300 m T= tension in the conductor Wt. of conductor per meter (W) =2 kg…

Q: Explain the meaning of the term “bundle conductor transmission line" and discuss the effects of its…

A: A single-stranded conductor is used for transmitting the power from one end to the other ends when…

Q: A transmission line has a span of 150m between level supports of 16 meter height. The ground…

A: Span is 150 m Height of the tower is 16 m Ground clearance is 95% of the tower of height.

Q: The segment length for coaxial cable is -

A: COAXIAL CABLE: It is an electrical cable which transmits radio frequency (RF) signals from one point…

Q: When selecting conductors, from where is the motor full - load ampere rating to be taken

A: During the selection of the conductors, the motor full-load ampere rating is taken in the squirrel…

Q: Please explain why it is preferable to use coaxial cable rather than twist pair wire.

A: 1) In real time applications the noise ( unwanted signal) can be add to the required information.…

Q: What is need of using copper conductors instead of aluminum in underground transmission system?

A: In this question , we will write the reason why copper conductor used in underground transmission…

Q: How many 14 AWG THHN conductors, including an equipment grounding conductor, can be installed in a…

A: Here we have to refer standard tables, When determining the maximum number of conductors permitted…

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: Consider the diagram shown in Figure below

Q: Prove that the conductor cost for transmission line is inversely proportional to the square of the…

A: Power suppied by source is cosntant VIcosϕ = constsant I∝1vlosses are also constant (I2R = constant…

Q: Why do multiple conductors in dc, 1-phase, and 3-phase power cables not disturb the magnetic compass…

A: Multiple conductors in DC, 1- phase, or 3 phase power cables do not disturb the magnetic compass…

Q: A transmission line has a span of 150m between level supports of 18 meter height. The ground…

Q: Explain (brief description) what will happen to the characteristic impedance when the spacing…

Question

14. If the center conductor of a coaxial cable is made to have smaller diameter, all other things being equal, what will happen to the Zo of the transmission line?
A. It will increase.
B. It will decrease.
C. It will stay the same.
D. There is no way to know.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

a.Why does power plants have high amounts of voltages? Explain. b.Is it safe for transmission lines to have high current instead of high voltage? Why? c.What phenomenon is avoided by having separations between three conductor phases? Explain this phenomenon.
An over head transmission line supported from two towers location at the same level. The distance between the towers is 200 m. The tension in the wires is 9000 N. The weight of one meter of the conductor is 10 N. The sag of the wires is * 2.55 m 1.55 m 4.55 m 5.55 m Non of them
What are the colors of the conductors in nonmetallic-sheathed cable for a. 2-wire cable? _______________, _______________ b. 3-wire cable? _______________, _______________, _______________
A transmission-line cable with a length of 2 km consists of 19 strands of identical copper conductors, each 1.5 mm in diameter. Because of the twist of the strands, the actual length of each conductor is increased by 5. Determine the resistance of the cable if the resistivity of copper is 1.72-cm at 20C.
A stranded conductor is an example of a composite conductor. True False
Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All strands have the same radius r.
5. A coaxial cable, having an inner diameter of 0.025mm and using an insulator with dielectric constant of 2.56, is to have a characteristic impedance of 2000 2. What must be the outer conductor diameter?
How does the choice of cable material, like copper vs. aluminum, affect transmission rates and interference?
Q2. What is the benefit of using stranded conductors in transmission systems?
16 Which among these statements is false or incorrect about Transmission Lines? A. It is possible to have more than one cable per phase in a Transmission Line. B. Three-Phase Transmission Lines always only have three cables. C. Double Circuit configuration can transmit more power compared to Single Circuit configuration. D. Transmission Lines are generally bare conductors like ACSR.
2) Stranded conductor 61/2.9 mm. calculate the equivalent diameter of conductor? a. 14.5 mm. b. 16.9 mm. c. 26.1 mm. d. 20.3 mm.
A- Define Impedence. Mention the difference between Impedence and Resistance ? B- A coaxial cable's shiled diameter is 0.4cm and the inner conductor has a diameter of 0.02cm. What is the characteristic impedance of that cable? C- What is meant by impedance matching? Why is impedance matching is needed?