Answered: 15. True/False: Some dissolved ions can…

15. True/False: Some dissolved ions can recombine with the crystal. 16. True/False: More NaCl can dissolve if more water is added to the solution.

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 19QRT

See similar textbooks

Related questions

Q: A solution is saturated at 25oC . It is then slowly cooled to 20oC with no change to the appearance…

Q: What would a glassware assembly like this be used for? Heating a reaction under reflux conditions…

A: Fractional distillation is a process by which components in a chemical mixture are separated into…

Q: Consider why CaCl2 or MgCl2 are used as de-icers rather than NaCl is no longer used as a deicer.

A: De-icers or de-icing agents are substances that removes snow, ice from roads or any other surface.…

Q: Which of the following is true about TOTAL WATER HARDNESS? (A) carbonates of Ca²+ and Mg2+ that does…

A: Given, Options are :

Q: The solubility of PbSO₄ in water at 25 °C is 7.9 × 10⁻⁴ M. What is Ksp for PbSO₄?

Q: Which type of distillation is used for miscible liquids with very small gap of boiling temperature?…

Q: What happens to the intermolecular forces during phase transition? What is the relationship of phase…

A: IMF stands for intermolecular forces During the phase transition, the intermolecular forces of…

Q: Does the commonly reported solubility of an inorganic compound in water pertain to large crystals or…

A: Solubility of any substance depends upon the physical and chemical properties of the solute and the…

Q: The solubility of Ni3(PO4)2 in water at a particular temperature is 8.0 × 10-4 M. What is Ksp for…

A: Solubility means the maximum amount of solute that can be dissolved in given solvent. Factor…

Q: Using the results from the solubility test table, what can be concluded about the structure/property…

A: Interpretation: To comment on the structure/property of each of the polymer on the basis of…

Q: Atrazine is a herbicide that is commonly used in the United States. The Henry's law constant of…

A: Henry's law: It states that the solubility of the gas in a liquid is directly proportional to the…

Q: Which solution (saturated, unsaturated, or supersaturated) represents a non-stable

Q: A small crystal of sodium acetate was added to eventually became A. supersaturated; unsaturated…

A: Given : A small crystal of sodium acetate was added to a clear, colourless solution. This caused the…

Q: a) Which salt has minimum solubility at40°C? 200 160 180 170 160 b) At what temperature solubility…

A: The questions can be answered using the given graph:

Q: Hydrophobic colloids are stabilized in water by adsorbed anions. Explain with an example?

A: Hydrophobic colloids are stabilized in water by adsorbed anions has to be explain with an example,

Q: Determine the mass in grams (g) of a nonvolatile, nonionizing compound that must be added to 4.79 kg…

A: delta Tf = Kf × m m = molality Delta Tf = lowering in melting point

Q: Which is the least soluble, calcium phosphate, (Ca3(PO4)2) (Ksp = 1.0 x10 29) or ferric phosphate,…

A: Which is least soluble calcium phosphate or Ferric phosphate has to be given.

Q: 58. Define the equilibrium vapor pressure of a substance. How and why does it depend on temperature?…

Q: Explain why ions are more soluble in water than are molecules with dipoles.

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Where should heat be applied to a test tube? Bottom of the test tube. Top of the test tube. Middle…

A: Where should heat be applied to a test tube?

Q: Iron and carbon can form a solid solution when carbon concentration is relatively small. Which of…

A: Carbon atom can occupy the interstitial sites between iron atoms as it have small size than Fe

Q: 1. The boiling point elevation of an aqueous sucrose solution is found to be 0.39°C. What mass of…

A: Elevation in boiling point : Boiling point elevation indicates to the increase in the boiling point…

Q: The critical point for a substance is 1000 atm and 750 K. The triple point for this substance is…

A: The critical point for a substance is 1000 atm and 750K.The triple point for this substances is…

Q: Based on boiling points, can the weakest IMF (dispersion forces) be stronger than hydrogen bonding…

A: The forces of attraction existing among the molecules of a substance that belong to any state of…

Q: Use the graph below to answer the following questions. 2. What is the vapor pressure of CHCI3 at…

A: 2) Vapour pressure of CHCl3 at 50∘C = 70 kPa 3) Boiling point of water when external presssure is 30…

Q: why oils leave a translucent spot on paper even after drying while ethanol and water do not

Q: Which of the ff. angles is used for turbidity measurement of a colored solution? 180 degrees O 135…

A: Please find your solution below : 90 degrees angle is used for turbidity measurement of a coloured…

Q: Arrange the following in increasing order of melting point (small to large). Briefly defend your…

A: Given information:

Q: Which of the following is true about TOTAL WATER HARDNESS? A sulfates of Ca²+ and Mg²+Ca and Mg that…

Q: 1. crystallization are there in 0.2 mole of sodium sulphate Na, SO.. 10H,0? (A) 0.2 (B) 2 (C) S (D)…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: 13.) The vapor pressure of water at 31°C is 33.4 mmHg. Calculate the vapor pressure of water over a…

A: Raoult's law states that the vapour pressure of solution (Psolution) is directly proportional to the…

Q: what is a dimer in chemistry? and how are dimers useful in the pharmaceutical industry

Q: When recrystalizing an aspirin sample the hot solution cooled to room temperature and no crystals…

A: Recrystallisation process involves the solute (to be purified) dissolve in an appropriate solvent.…

Q: The 250-mL coke was then opened. Given the atmospheric pressure is 1 atm and volume percent of CO2…

A: Daltons Law is given as

Q: s all melt at temperatures lower than their salts. ローロ B 21 (1) → 1, (3) + 2e ? Mg*(1) + 21¯(4) →…

A: As we know, in electrolytic cell , Oxidation takes place at anode and reduction takes place at…

Q: What is the purpose of using rock salt in ice-cream making? Explain what happens when the salt is…

A: In this question, we will discuss about why rock salt ( like NaCl ) added in ice for making…

Q: powders and granules dosage forms have faster dissolution rate than capsules and tablets ,why?

A: Disintegration means break down of the tablet or capsules into granules which are again disintegrate…

Q: what crystal structures are. Explain that they are Crystalline Networks (Bravais Networks). Indicate…

Q: 1. For an aqueous solution containing Na*, Cl-, and Br¯, determine: (a) the number of components (b)…

A: Concept: According to phase rule: F= C+P-2 Where F = degree of Freedom C = component P = no of…

Q: hat happens to the volatile liquid that is placed in the flask? 1. All of it leaves 2. It remains a…

A: Interpretation: We have to explain what happens when volatile liquid is placed in flask.

Q: ………… is usually used only to separate liquids whose boiling points differ greatly or to separate…

A: a. Distillation is a process to separate two or more liquids either volatile or involatile having…

Q: What volume of water at 20.0 °C (d = 0.9982 g cm3) is needed to dissolve 36.1 g of sucrose to make a…

A: What volume of water at 20.0°C (d = 0.9982 g cm 3) is needed to dissolve 36.1 g of sucrose to make a…

Q: Why is foaming important in shampoos?

Q: Which liquid layer, top or bottom, do you expect to be the organic layer?

A: Which liquid layer, top or bottom, do you expect to be the organic layer?

Q: Explain the behavior of a cooled and remelted sample.

A: Given- A capillary shows a substantially higher melting point of 145°C. Repeated recrystallization…

Q: The vapor pressure of pure toluene at 60 °C is 0.198 atm. A solution prepared by dissolving 2.2 mol…

A: We have given that Vapor pressure of pure toluene = Ptoluene° = 0.198 atm Moles of toluene = nt =…

Question

100%

question 15

c. ions precipitate
d. ions recombine with the salt crystal
kas done
15. True/False: Some dissolved ions can recombine with the crystal.
16. True/False: More NaCl can dissolve if more water is added to the solution.
17. Define the following terms:
a. recrystallization
iments
b. saturated solution

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

. Why does the amount of excess solid solute present in a solution not affect the amount of solute that ultimately dissolves in a given amount of solvent?
A 0.250-M sodium sulfate solution is added to a 0.200-M barium nitrate solution and 0.700 g barium sulfate precipitates. Write the balanced equation for this reaction. Calculate the minimum volume of barium nitrate solution that was used. Calculate the minimum volume of sodium sulfate needed to precipitate 0.700 g barium sulfate. Assume 100% yield.
In Exercise 12.49, what is the allowed concentration of AgCl in g per 100 g of water? The Safe Drinking Water Act of 1974 established the maximum permitted concentration of silver ion at 0.05 ppm. What is the concentration of Ag+ in parts per million in a saturated solution of AgCl? (NOTE: 1 ppm = 1 mgofsolute/L of solution.)
12.111 You have three white solids. What experiment could you carry out to rank them in order of increasing solubility?
You make a saturated solution of NaCl at 25 C. No solid is present in the beaker holding the solution. What can be done to increase the amount of dissolved NaCl in this solution? (See Figure 13.11.) (a) Add more solid NaCl. (b) Raise the temperature of the solution. (c) Raise the temperature of the solution, and add some NaCl. (d) Lower the temperature of the solution, and add some NaCl. Figure 13.11 The temperature dependence of the solubility of some ionic compounds in wafer. The solubility of most ionic compounds increases with increasing temperature This is illustrated using NH4CI (ports b and c).
Figure 16.3 shows the solubility of AgNO3 in water inunits of moles of AgNO3 per kilogram of H2O. If 255 g of AgNO3 is added to 100 g of water at 95°C and cooledslowly, at what temperature will the solution becomesaturated?
What happens if you add a very small amount of solid salt (NaCl) to each beaker described below? Include a statement comparing the amount of solid eventually found in the beaker with the amount you added: a a beaker containing saturated NaCl solution, b a beaker with unsaturated NaCl solution, c a beaker containing supersaturated NaCl solution. A saturated sodium chloride solution.
A solution contains 0.00740 M calcium ion. A concentrated sodium fluoride solution is added dropwise to precipitate calcium fluoride (assume no volume change). a At what concentration of F does precipitate start to form? b When [F] = 9.5 104 M, what is the calcium-ion concentration? What percentage of the calcium ion has precipitated?
You are designing a process to remove carbonate ions from an aqueous system by precipitation. If the effectiveness of the process is the only concern (meaning there are no environmental or other issues involved), which of the following metal ions would be the best choice: Ca2+,Fe2+,Pb2+,orAg2+ ? Explain your answer. Salt Ksp CaCO3 4.8109 FeCO3 3.51011 PbCO3 1.51013 Ag2CO3 8.21012
12.49 The Safe Drinking Water Act of 1974 established the maximum permitted concentration of silver ion at 0.05 ppm. What is the concentration of Ag+ in parts per million in a saturated solution of AgCl? (NOTE: 1 ppm = 1 mg of solute/L of solution.)
Calculate the concentration in (w/v) of the following solutions: a. 150.mL of solution contains 7.50g of dissolved solid Na2SO4. b. 150.mL of solution contains 7.50g of any dissolved solid solute. c. 350.mL of solution contains 30.7g of dissolved solid solute.