2. A square coil of resistance 4 0, 50 turns and side length 5 cm is placed with its plane making an angle of 40° with a uniform magnetic field of 2 T. In 4.5 s the coil rotates until its plane becomes parallel to the magnetic field. Find the current induced in the coil. GIVEN REQUIRED EQUATION COMPUTATION ANSWER

2. A square coil of resistance 4 0, 50 turns and side length 5 cm is placed with its plane making an angle of 40° with a uniform magnetic field of 2 T. In 4.5 s the coil rotates until its plane becomes parallel to the magnetic field. Find the current induced in the coil. GIVEN REQUIRED EQUATION COMPUTATION ANSWER

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 40P: A coil of 1000 turns encloses an area of 25 cm2. It is rotated in 0.010 s from a position where its...

See similar textbooks

Similar questions

12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
Check Your Understanding Shown below is a rod of length l that is rotated counterclockwise around the axis through O by the torque due to mg . Assuming that the rod is in a uniform magnetic field B , what is the emf induced between the ends of the rod when its angular velocity is ? Which end of the rod is at a higher potential?
A charge of 4.0C .s distributed uniformly around a thin ring of insulating material. The ring has a radius of 0.20 m and rotates at 2.0104 rev/min around die axis that passes through its center and is perpendicular to the plane of the ring. What is the magnetic field at the center of the ring?
A 0.50-kg copper sheet drops through a uniform horizontal magnetic field of 1.5 T, and it reaches a terminal velocity of 2.0 m's. (a) What is the net map,-, eh: force on the sheet after it reaches terminal velocity? (b) Describe the mechanism responsible for this force, (c) How much power is dissipated as Joule heating while the sheet moves at terminal velocity?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
A coil of 1000 turns encloses an area of 25 cm2. It is rotated in 0.010 s from a position where its plane is perpendicular to Earth’s magnetic field to one where its plane is parallel to the field. If the strength of the field is 6.0 x I0 T. what is the average emf induced in the coil?
Two flat, circular coils, each with a radius R and wound with JV turns, ace mounted along the same axis so that they are parallel a distance d apart. What is the magnetic field at the midpoint of the common axis if a current I flows in the same direction through each coil?
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26
Check Your Understanding Consider using Ampere’s law to calculate the magnetic fields of a finite straight wire and of a circular loop of wire. Why is it not useful for these calculation?