2.837 2.762 1.5 1 1.631 1.5 -4.256- -6.000- 2.447- STA. 0+128.32 2.284 2.380 1.5 1.414 1.5 3.426- -6.000 2.120 STA. 0+140

Q: Compute the missing side AB. (Type your answer using 2 decimal places, numerical value only, no need…

A:

Q: Compute the end area of the irregular cross-section described below: Width of Road = 9 meters 3.8…

A: Solution Cross-section of the earthwork is drawn below. All the areas are fill areas. Width of road…

Q: Q6. If the known benchmark elevation of a proposed building in downtown Nashville is 597.2 ft. When…

A:

Q: Town A and B are on the opposite sides of a river .The towns are to be connected with a bridge CD…

A: The figure drawn from the given information is shown below.

Q: Using the average-end-area method, calculate the cut-and-fill volumes for stations 125 + 00 through…

A: Given:

Q: 4) Determine the area & perimeter of the trace below. 130.0- 100.0 160.0-

A:

Q: For the tract ABCD, the DMD of line DA is equal to -334.56 m; the DMD of line CD is -543.75 m,…

A: To determine the departure of the preceding line with the help of DMD for two consecutive lines.…

Q: POINT NORTHING EASTING A 300 300 340 220 C 420 180 D 390 250 a. Compute the area using coordinate…

A: x y x*y y*x A 300 300     B 340 220 66000 102000 C 420 180 61200 92400 D 390 250 105000…

Q: Using the average-end-area method, calculate the cut-and-fill volumes for stations 125 +00 through…

A: The average end area method is useful for estimating quantities in construction, It is an…

Q: Recommended width of widening. A 0.6 m B 0.5 m c) 0.7 m D) 0.8 m

A:

Q: evations were obtained using 10m squares. PointA ner of the lot and D-4 at the southeast corner. A

A: (a) The scale utilized is 1cm = 2m . The line is displayed underneath. The cycle used to line a line…

Q: A PARCEL OF LAHD LOT 278 CAD 211.SITUATED IN THE BARRIO OF WAWA MUNICIPALITY OF LUMBAN PROVINCE OF…

A: The following table shows the bearings, distances and latitude, departure of the lines. Line…

Q: MN = 60

A:

Q: A 90m by 90m lot is to be divided into 9 equal square sections. The elevations of the ground surface…

A:

Q: Explain and show conflict points of 1. Four-legged intersection 2. Five-legged intersection 3. Round…

A: Note: Hi! Thank you for the question as per the honour code, we’ll answer the first question since…

Q: 2. The building is to be constructed on a lot shown below. Calculate the distances of lines (1-2)…

A: The sum of latitude for closed traverse without and error is 0 The sum of departure for closed…

Q: From the given tract of land having the following data: LINES LATITUDE DEPARTURE А-B +40 -80 В-С +80…

A: The given values are as follow, To Determine ,The DMD of line AB The double area of the lot

Q: 6" B A 8" 600ъ

A:

Q: etermine the subdivided areas by a line passing through corner C and at the mid-length of the line…

A: Latitude=Lcosθ where , L=length of line              θ=bearing (given in question) LATITUDE VALUES…

Q: 1.In item No. I what is the length of m or AP? a) 4,226.67m     b) 4,567.34                  c)…

A: To find length of BP and AP

Q: net area along 4,5,2,6,7

A: Given data, Width of the plate= b= 150mm Diameter of the rivet= d0= 20mm Thickness of the plate = t…

Q: 1. A parcel of land has a technical description as shown in the tabulated data. Lines Bearing 1-2 S.…

A: First we will convert all bearing in WCB and then calculate the internal angle.

Q: A 120m by 120m lot is to be divided into 9 equal square sections. The elevations of the ground…

A:

Q: What are the Sample Acres when doing 17% cruise using 1/10 ac fixed plots on 89 acres?

A: The values given in the question are as follow Fixed area of plots=89 acres 17% crsise using…

Q: 22- Which of the following symbols is a representation of a Manhole in Civil 3D? A) B) S C) M 23-…

A: Given  The representation of autocad 3D models

Q: 2. ) Compute area of the parcel below. <-5.0 -19,7 0,0 -15,0 0,0 15.0 -4.6 17,0 --3,2 18,4

A: The given figure is shown below:

Q: Two square lots that lie adjacent to each other has a total area of 208 m?. to enclose the 2 lots by…

A: Answer : Option (d) is correct

Q: a) Determine the distance of line CD using Compass Rule b) Determine the bearing of line EA using…

A:

Q: • If free haul distance is 530 ft., determine the overhaul distance between 0+00 and 9+10. CUT…

A: Free haul distance is the distance within which the cost of transportation of materials remains…

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

A:

Q: 5 kN 3 kN 30 60°

A:

Q: It is desired to transport 20 CFS of water through a rectangular finished concrete (n= 0.012) canal…

A:

Q: The centerlines of two parallel tracts in a railroad layout are connected by a reverse curve of…

A: To find  Stationing of PRC &amp; PT

Q: PROBLEM 1: From the ff. closed traverse LINES BEARING DISTANCES N.30° E. N. 78° E. S. 32° E. 1-2…

A:

Q: these data to the Greenshields & Greenberg e capacity AND R-SQUARE.

A: consider plot for the solution

Q: BALANCE THE TRAVERSE BY TRANSIT RULE AND COMPUTE THE AREA BY DMD METHOD Corr'n Corr'n Line Bearing…

A: transit method - in this method the distribution of error in different latitude and departure in…

Q: a.) Compute the bearing of line 4-1. b.) Compute the distance of line 4-1. c.) Compute the DMD of…

A: Latitude L=l cosθDeparture D=l sinθ Let l4-1 be the distance of line 4-1.  x and y be the latitude…

Q: 10.15 m o'12" 2020 43'12" 190 35'12" 8.31 m 9.33m LINE CORRECTED LATITUDE CORRECTED DEPARTURE 1-2…

A: DMD of a line = DMD of previous line + Departure of previous line + Departure of present line. DPD…

Q: rd/2 ctan y sec y 1. x' cos' ydxdy

A: Using reduction formulae

Q: From the closed traversed described below: a. Compute the bearing of line 4-1 b. Compute the…

A:

Q: 10. Towns A and B are on opposite sides of a river. The towns are to be connected with a bridge cD ,…

A: Two towns A and B on the opposite sides of a river are to be connected with a bridge CD…

Q: se are us Ily closed sur are in urba rural ocations for the purpose of determining and defining…

A: Solution: The correct option is Cadastral Surveys.

Q: A parcel of lot (trapezoidal) has a technical description as shown in the tabulated data. Lines…

A: To Find :- DMD of line CD Double area of line DA Total area of lot using DMD

Q: 1.00- -0.75 D B E 200 F G 1.50 125 0.50 H 0.25 225 A Point of Origin (0, 0) 3.00 Figure 1: Angle…

A: Absolute coordinate system is the one in which we present every point coordinate as a cartesian…

Q: A В 196 N 294 N

A: The given value: Static coefficient of friction μs=0.40 Kinetic coefficient of friction μe=0.30

Q: 2. Given below is the technical description of lot 2081, Cebu Cadastre: LINES BEARINGS DISTANCES S…

A:

Q: MCQ/ If Ø = 0.987643 rad. Find Ø in degrees. A-56º 35' 16'' B-45º 42' 16'' C-52º 04' 26'' D-54º 30'…

A:

Q: Determine the area bounded by a straight road and an irregular boundary using the data given below:…

A: To Determine Area bounded by straight road and an irregular boundary.

Volumes

Volume usually is the dimensional quantity that involves the evaluation of any three-dimensional figure enfolded inside a closed space. The SI unit (International System of Units) of volume is m3 and the dimensional unit of volume is [L3]. For estimation of the volume of any figure, various formulae are used. Another application of volume includes the reference in the sound levels, the higher the sound intensity, the louder the sound heard, and hence, the larger the volume. The SI unit of sound volume is decibels (dB).