Can you please type out all of your solution so that they are easy for me to read I have really bad eyesight 29. (I) What is the maximum voltage that can be applied acrossa 3.9-kn resistor rated at / watt?

Given :- power P = 1/4 w = 0.25 w Resistance R = 3.9 kohm = 3900 ohm

Answered: 29. (I) What is the maximum voltage…

Science

Physics

29. (I) What is the maximum voltage that can be applied across a 3.9-k resistor rated at watt?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 78AP: A 20.00-ohm; 5.00-watt resistor is placed in series with a power supply, (a) What is the maxim tun...

See similar textbooks

Related questions

Q: Find the pressure Force=0.2 N Area 0.1 cm2

Q: If the energy received by 2 m² area in 250 seconds is 1180 KJ. Calculate the value of Solar constant…

A: Introduction : In this question we are provided it value of time , area and energy . With these…

Q: Particles A and B have the same momentum. B has more kinetic energy than A if it: a. is moving…

Q: A spaceship's orbital maneuver requires a speed increase of 1.30 ✕ 103 m/s. If its engine has an…

Q: 5. A car slows down from (v-20 m/s) to (= 10 m/s) in 5s. The car acceleration is: a) 2 m/s² b) 4…

Q: A radioactive substance whose mass is 200 mg will decay to 180 mg after 12 years. Determine the…

Q: An 85 kg mass has an acceleration of 5.5 m/s². What is the net force applied?

Q: A 90 kg Panda is sliding down a bamboo at a constant speed of 2.4 m/s. The friction on the Panda is…

Q: An electron that is in its ground state can undergo which of the following? spontaneous emission )…

Q: 2. A horizontal force, F, of 12 lbs pushes a block weighing 5.0 lbs against a vertical wall. The…

Q: Potential difference between two points of a wire carrying 38 ampere current is 5 volt. Calculate…

Q: Compute Impulse Force 12.145 N Time=0.88 s

Q: The gradient of velocity versus time graph is equal to

A: The gradient of velocity versus time graph is equal to the acceleration.

Q: Find work done Force=0.1 N Displacement 0.2 m

A: Given data : Force=F Displacement=d Required : Work done

Q: During a thunder storm over the summer, you want to estimate the distance in kilometers (not miles!)…

A: During a thunder storm over the summer, if we want to estimate the distance in kilometers of a flash…

Q: MULTIPLE CHOICE You stretch a spring an extra 40.0 cm beyond its initial length. How much energy…

Q: An 85 kg mass has an acceleration of 5.5 m/s². What is the net force applied?

A: Introduction : In this question we are provided it value of acceleration and mass . With these data…

Q: A(n) 65-g ice cube at 0°C is placed in 680 g of water at 28°C. What is the final temperature of the…

Q: Calculate the electrical energy consumed in Joules if a toaster of 56 W is used 1420 seconds ?

A: Given data: Power (P) = 56 W Time (t) = 1420 s Required: The electrical energy (E)

Q: Total Internal Reflection: A point source of light is positioned 20.0 m below the surface of a lake.…

Q: Directions: Complete the concept map below. Write your answers in your notebook or on a separate…

Q: what is displacement what is gradient and velocity

Q: 2. A stone is thrown from the top of a building upward at an angle of 30.0° to the horizontal with…

Q: ΝΤΟΥΣ Α' Καμματικός και η κόρη μέρα του και και στα αργήθηκε και μια ματιά και με προστάτη και παρά

Q: 3. A 6.0-kg initially at rest is pulled to the right along a frictionless, horizontal surface by a…

Q: What is the net force on the object? If the net force is to the right, enter a positive value and if…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Given data Time = 6 h Distance = 220 km Find the average speed ?

A: Given data: Time (t) = 6 h Distance (d) = 220 km Required: The average speed

Q: Find the Area Pressure=20 N/cm2 Force 10 N

Q: Given data Time = 6h Distance = 220 km Find the average speed ?

A: Introduction : In this question we are provided it value of distance and time . With these data we…

Q: 6 A material with a density of 5 p/m' and a volume of 20 cm' has a mass of

A: The density of the material, d=5 g/cm3 The volume of the material, V=20 cm3 Density is defined as…

Q: A car of weight 180 kg. To what height should it be raised so that potential energy is 1420 J? Take…

A: Introduction : In this question we are provided it value of potential energy ,mass and acceleration…

Q: Three model rockets have just had their engines turned off. All of the rockets are aimed straight…

A: rocket A : mass = 700 g initial velocity = 30 m/s rocket B : mass = 500 g initial velocity = 40 m/s…

Q: A block placed on a rough inclined surface is used to compress a spring that is parallel to the…

A: A block placed on a rough inclined surface is used to compress a spring that is parallel to the…

Q: When a thermodynamic system does work on the environment and no Q is added to the system, its…

A: Solution: Given: When a thermodynamic system does work on the environment and no Q (heat) is added…

Q: Find the Area Pressure=20 N/cm2 Force=10 N

A: Given Pressure is P=20 N/cm^2 Applied force is F=10 N

Q: 1. In a piston cylinder system, the gas an initial pressure of 100 kPa and expands from 1.5 m³ to…

Q: Compute Impulse Force=12.145 N Time=0.88 s

Q: Calculate the magnetic field B created at a point M located at the distance h of a plane infinite P…

A: In this question we have to calculate the magnetic field created. Please give positive feedback if…

Q: 1.565872597159 radian Using the supplied information and any appropriate assumptions and / or…

Q: Find the pressure Force=0.2 N Area=0.1 cm2

Q: frequency of the He line of the Balmer series for hydrogen. Calculate (a) the wavelength and (b) the

Q: DN Required information In the below FBD, the forces are labeled with their magnitudes. ΑΝ CN BN…

Q: Find pressure Force=2 N Area=0.2 mm2

A: Given data : Force=F Area=A Required : Pressure

Q: The cable AB carries a tension of 410 N. Determine the moment about O (positive if counterclockwise,…

Q: A bus is moving on a straight road 8 m/s. It is acceleration at 15.2 m/s². What will be it's…

A: Given Initial velocity of bus u = 8 m/s Acceleration of the bus a = 15.2 m/s2 To find velocity…

Q: am pulling my kids in their wagon on the way to the park. The handle makes an angle of 40° above the…

Q: Calculate the work done by a student in lifting a 0.3 kg book from the ground and keeping it on a…

Q: Calculate the electrical energy consumed in Joules if a toaster of 56 W is used 1420 seconds ?

A: Given data : Power (P) = 56 W Time (t) = 1420 s

Q: (I) A service station charges a battery using a current of 6.7 A for 5.0 h. How much charge passes…

A: In this question we have to find the charge passing through the battery. Please give positive…

Q: How do you do this question with integrals instead

Question

100%

Can you please type out all of your solution so that they are easy for me to read I have really bad eyesight

29. (I) What is the maximum voltage that can be applied across
a 3.9-kn resistor rated at / watt?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The [R drop across a resistor means that there is a change in potential or voltage across the resistor. Is there any change in current as it passes through a resistor? Explain.
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
An electronic apparatus may have large capacitors at high voltage in the power supply section, presenting a shock hazard even when the apparatus is switched off. A “bleeder resistor" is therefore placed across such a capacitor, as shown schematically in Figure 21.50, to bleed the charge from it after the apparatus is off. Why must the bleeder resistance be much greater than the effective resistance of the rest of the circuit? How does this affect the time constant for discharging the capacitor?
A 20.00-ohm; 5.00-watt resistor is placed in series with a power supply, (a) What is the maxim tun voltage that can be applied to the resistor without hanniug the resistor? (b) What would be the current through the resistor?
Integrated Concepts If you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600F capacitor, what is the resistance in the flash tube?
Regarding the units involved in the relationship t = RC, verify that the units of resistance times capacitance are time, that is, . F = S.
Show that the power dissipated by the load resistor is maximum when the resistance of the load resistor is equal to the internal resistance of the battery.
Refer to Figure 10.17 and the discussion of lights dimming when a heavy appliance comes on. (a) Given the voltage source is 120 V, the wire resistance is 0.800 and the bulb is nominally 75.0 W, what power will the bulb dissipate if a total of 15.0 A passes through the wires when the motor comes on? Assume negligible change in bulb resistance, (b) What power is consumed by the motor?
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
Using the exact exponential treatment, determine how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M resistor to 90.0% of its final voltage.
Semi-truck or trucks use four large 12-V batteries. The starter systemrequires 24 V, while normal operation of the truck’s other electrical components utilizes 12 V. How could the four batteries be connected to produce 24 V? To produce 12 V? Why is 24 V better than 12 V for starting the truck’s engine (a very heavy load)?
When two unknown resistors are connected in series with a battery, the battery delivers 225 W and carries a total current of 5.00 A. For the same total current, 50.0 W is delivered when the resistors are connected in parallel. Determine the value of each resistor.