3. The below figure shows a pipe with a circular cross section of diameter D mm on the left end and a square cross section with side D mm on the right end. Mercury enters the left end with a velocity 1 cm/s and leaves the right end with a velocity V2. Find V2 (neglect losses in the pipe). Inlet Outlet Cannot be find since length is not given Cannot be find since diameter is not given а. b. с. 7.85 mm/s d. 12.73 mm/s

3. The below figure shows a pipe with a circular cross section of diameter D mm on the left end and a square cross section with side D mm on the right end. Mercury enters the left end with a velocity 1 cm/s and leaves the right end with a velocity V2. Find V2 (neglect losses in the pipe). Inlet Outlet Cannot be find since length is not given Cannot be find since diameter is not given а. b. с. 7.85 mm/s d. 12.73 mm/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A gas flows through a square conduit, at the entrance the conduit sides are 10 cm, the velocity is 7.55 m/s, and the gas mass density is 1.09 kg/cu. m. At the exit, the conduits sides are 25 cm, and the velocity of flow is 2.02 m/s. Find the density of the gas at the exit section considering that the gas is compressible a. 0.6598 kg/cu. m b. 0.6851 kg/cu. m c. 0.6518 kg/cu. m d. 0.6185 kg/cu. m
4. A centrifugal pump delivers water to a height of 22 metres at a speed of 800 r.p.m. The velocity of flow is constant at a speed of 2-0 m/s and the outlet vane anglc is 45°. If the pump discharges 225 litres of water per second, find the diameter of the impeller and width of the impcller at oudet. (Ans. 375 mm: 95 mm)
Pipe A, 30 cm in diameter, branches into two pipes B and C. Pipe B is 15 cm in diameter and pipe C is 7.5 cm in diameter. If the flow in A is divided as follows 2/3 goes to B and 1/3 goes into C, what is the discahrge in pipe A, if the velocity must not exceed 3 m/s in any of the pipes?
Answer should be correct it do it if you are sure . I just need answer upto two decimal points . A jet of water of dia 10 cm strikes a flat plat normally with a velocity of 15 m/s The plate is moving with the velocity of 6m/s in the direction of jet and away from the jet . Find - 1. Force exerted by the jet on the plate.2. Workdone by the jet on plate /sec.
Q3) A) A water jet issues from a nozzle 5 cm diameter, strikes a plate with a velocity of 30 m/sec. the plate makes an angle of 60° to the horizontal. If frictional loss is such as to reduce the velocity of the stream leaving the body to 25 m/sec, find:- 1. The component of force in the direction of get. 2. The component of force normal to get, 3. The magnitude and direction of resultant of force exerted by water. B) What do you understand by the term 'multistage pump'? Explain clearly the difference between a single stage and a multistage centrifugal pump.
Q4: Oil was placed over water placed in a tube in the shape of the letter A, so it moved the air on the other side, as in the figure below. Find the height of the column of air, and if it passes through the left tube, what is its velocity, knowing that the air density is 1.29 kg/m³ and the density of the oil is 750 kg/m³? Patm Patm air h L = 5 cm -K Point B Poin: A water oil
at point a in pipeline carrying water, the diameter is 1m, the pressure is 98kPa and the velocity is 1m/s. at point B, 2m higher than A, the diameter is 0.5m and the pressure is 20kPa. Determine the direction of flow. need answer please
Answer with True or False of the following question: (7M 1. Water flows steadily down a vertical pipe of constant cross section. Neglecting friction, according to Bernoulli's equation, velocity decreases with height. 2. A liquid in an open right circular cylinder is given rigid body rotation about the axis of the cylinder. The pressure distribution in any vertical plane is uniform. 3. A curved surface is submerged in a static liquid. The horizontal component of pressure force on it is equal to the pressure force on a vertical projection of the surface. 4. A U-tube manometer measures the difference in total energy between two points.
A/ A tank fill by the liquid and partially immersed a very long vertical tube in it. The tube has the radius R and rotating at o radians per second clockwise. Find the steady state velocity and pressure profiles in cylındrical coordinates.
Q2/ An outward flow reaction turbine has tangential velocity at its inner rim as 20 m/s, and ratio of radii is 0.9. The turbine is placed 1 m below the water surface and blade angle are 90° and 20° at inlet and outlet respectively. The radial velocity of flow at inlet is 6 m/s. Neglecting frictional losses and taking the discharge as radial, draw velocity triangles at inlet and outlet and find: (a) guide vane angle (b) the velocity of water from the guides. (c) total head of water (d) hydraulic efficiency
dp 1. It shows that the behavior of fluid is A From the equation stated, show the formula for mass flow rate AVp = c. :C.
A water jet with a flow rate of 2.83 m3 / s is traveling at 6 m / s in the positive x direction. The cost of the current striking a stationary splitter is correct about a 45 aç angle, other company are deflected downwards by the same angle and the final velocities of the two streams are 6 m / s. By neglecting the gravity, the separator is in place against the force applied by the water. calculate the x- and z- power of what is required to hold it. For water ? = 1.184 kg / m3