Answered: 35) An ideal gas undergoes an…

35) An ideal gas undergoes an isothermal expansion. During this process, its entropy A) remains unchanged. B) increases. C) decreases. D) cannot be predicted from the data given.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter15: Thermodynamics

Section: Chapter Questions

Problem 30CQ: Does a gas become more orderly when it liquefies? Does its entropy change? If s, does the entropy...

See similar textbooks

Related questions

Q: Blue exerts a constant 1333 N on white who is 200 lbs for 5 s. SHOW ALL WORK Find the changes in…

A: Given: The force exerted by blue on white is 1333 N. The mass of the white is 200 lbs. The time…

Q: A simple harmonic oscillator has an amplitude of 3.50 cm and a maximum speed of 26.0 cm/s. What is…

A: Xm=3.5 cm. wXm=26 cm/s. x=1.75 cm

Q: Find the Momentum Mass=33 kg Velocity=2.1 m/s

Q: Q2. In Figure Q2, ropes AB and AC are tied at point A which is 5 m from the base of the tree, O. The…

Q: 34. A coal power station functions at 40.0 percent efficiency. What is the amount of work it does if…

A: Efficiency, n = 40% = 0.4 Input heat, Q = 1.20 × 1012 J Output work, W = ?

Q: 1-Draw the profile section with (V.S. = 1/50 and H.S. = 1/2500). 2-Calculate and draw the elevation…

A: Step 1: Mark levels on graph paper on desired scale: Given Horizontal scale = 1/2500 Given Vertical…

Q: A 4-kg block is placed at point 1 on the track that is 3.5 m above the ground. Paths 1-2 and 3-4 are…

A: Write the given values with the suitable variables. m=4 kgh1=3.5 md=2 mμ=0.25 Here, m, h1, d, and μ…

Q: Q2: Find the acceleration of the three weights shown in fig. Assume pulleys are frictionless. Also…

A: Free body diagram gives whole idea of the forces acting. Force brings about motion and changes in…

Q: Find the pressure Force=2.11 N Area 0.331 m2

A: GIVEN: force =2.11 N Area =0.331m2

Q: When dropped a ball rebounds to 4/5 of its original height. How high will the ball rebound after the…

Q: A 4-kg block is placed at point 1 on the track that is 3.5 m above the ground. Paths 1-2 and 3-4 are…

Q: Which of the following does NOT demonstrate Newton's first law of motion? A bicycle parked on a…

Q: The frequencies of two successive modes of standing waves on a string are 850 Hz and 900 Hz. What is…

A: Given Frequency of the two successive modes of standing waves are :- fn = 850 Hz fn+1= 900 Hz…

Q: A Ferris wheel is 27 meters in diameter and completes 1 full revolution in 12 minutes. revolves…

A: Diameter, d = 27 m Radius, r = d/2 = 13.5 m One revolution in 12 minutes. Distance of ferris wheel…

Q: An ocean wave has a length of 12 m. A wave passes a fixed position every 3 seconds. What is the…

Q: The position versus time for a certain particle moving along the x-axis is shown in the figure. 1.…

Q: 5. Two long, parallel conducting wires carry current that are parallel to x-axis. Wire 1 carries a…

Q: What is the wavelength of radio waves transmitted by a radio station with a frequency of 1360…

Q: Q2. In Figure Q2, ropes AB and AC are tied at point A which is 5 m from the base of the tree, O. The…

A: Draw the FBD and then decompose the forces for AB rope. For AC, its better to just take the cross…

Q: For a cylindrical conductor with a hollow center, let the radius from the axis to the inner circle…

Q: A 7.6 kg block of wood resting on a platform was hit by a 26 g of bullet travelling upward with a…

A: according to momentum conservation law , momentum before collision = momentum after collision…

Q: 29) An ideal gas is compressed isothermally to one-third of its initial volume. The resulting…

Q: Given the mass of the Earth is 5.98 x1024 kg and a satellite orbits the Earth once every (a) Find…

Q: 35. A heat engine functions with 70.7 percent thermal efficiency and consumes 12.0 kJ from heat…

A: Given: Heat engine functions with 70.7% thermal efficiency It consumes 12.0 kJ Efficiency is raised…

Q: 3) The flux of the electric field (24 N/C)t + (30 N/C)j + (16 N/C)k through a 5.0 m² disk placed in…

Q: In your own words, explain Faraday’s Law of Induction. Why was the theory so revolutionary? As far…

Q: chapter 4.3 5) The position of a particle moving along the y axis, starting from the origin at t =…

A: Instantaneous speed is explicit as the rate of change of position over a very short period of time…

Q: 17) On a cold day, a piece of metal feels much colder to the touch than a piece of wood. This is due…

A: Thermal conductivity of metal is more than thermal conductivity of wood . therefore we feel much…

Q: You throw a ball straight up with a speed v from the top of a cliff, and it lands on the base of the…

A: 11) Let the height of the cliff be h and the height up to which the ball reaches be s Initial…

Q: Tuning forks are used in the diagnosis of nervous afflictions known as large-fiber polyneuropathies,…

A: Given: Tuning forks are used in the diagnosis of nervous afflictions known as large-fibre…

Q: 2. Suppose that the switch in an RC circuit with Eo = 0 is closed at time t = 0 when the capacitor…

Q: Find the currents I1, I2, I3 flowing in the circuit.

Q: (a) Find the electric field (magnitude and direction) a distance z above the midpoint between two…

A: Electric field due to a point charge, q is given as E =kqr2 Here, r is the distance between the…

Q: Find the speed of car Distance 66.44 km Time=2 hr

A: Given data : Time=t Distance=d Required : Speed

Q: Calculate the magnitude of the total angular momentum for an electron in a 4d5/2 state.

A: We have an electron which is in a state given by 4d5/2 where n=4 level is the principal quantum…

Q: A cyclist coasts up a 11.1" slope, traveling 15.0 m along the road to the top of the hill. If the…

Q: 23) A carpenter is driving a 15.0-g steel nail into a board. His 1.00-kg hammer is moving at 8.50…

A: given: mass of steel = 15g hammer mass = 1 kg velocity of hammer = 8.5m/s specific heat of steel =…

Q: N S S N

Q: SKETCHPAD Question 9 Assume these three vectors are acting on an object. 1. magnitude = 45, 0=311°…

Q: 2) The wave functions for two waves traveling in the same direction on a string are described below:…

A: The superposition of two waves is also a wave. It has same features as the waves by which it is…

Q: The longest bone in the human body is the femur. It is the only bone located in the upper leg.…

A: Tension is a force length of a object, particularly on a flexible object, such as a rope or…

Q: NOTE: Round off answer up to 2 decimal places. Use g = 9.8 m/s². Indicate the unit (symbol). A cube…

Q: Find force Mass=2.334 kg Acceleration=0.6 m/s2

A: Introduction : In this question we are provided with value of mass and acceleration.with these data…

Q: Which of the following devices performs heat transfer using work, with the goal of maintaining the…

A: (a) An internal combustion engine The internal combustion engine is an engine in which the burning…

Q: A car moving at 11.5 m/s crashes into a tree and stops in 0.32 A. Calculate the magnitude of force,…

Q: In a projectile motion, the time for the object to reach the maximum height is 5 seconds. What is…

A: The time of the object to reach the maximum height of the projectile motion is given as t=5 s

Q: Table 1: Angular displacement, linear distance, work, and power data Video # Load (kp) Pedal…

A: From the given data table draw the graph using excel sheet and also fix the label the x-axis and…

Q: A woman stands on a bathroom scale in a motionless elevator. When the elevator begins to move, the…

Q: Find the Current Voltage-44 Volt Resistance-5.5 Ohm

A: Given data : Voltage=V Resistance=R To find : Current

Q: The speed at which a grandfather clock runs is controlled by a swinging pendulum. a) If you find…

A: Due to the acceleration of gravity there is a performance takes place, which is oscillation ,…

Question

100%

35) An ideal gas undergoes an isothermal expansion. During this process, its entropy
A) remains unchanged.
B) increases.
C) decreases.
D) cannot be predicted from the data given.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

There is no change in the internal of an ideal gas undergoing an isothermal process since the internal energy depends only on the temperature. Is it therefore correct to say that an isothermal process is the same as an adiabatic process for an ideal gas? Explain your answer. `
In a cylinder, a sample of an ideal gas with number of moles n undergoes an adiabatic process. (a) Starting with the expression W=PdV and using the condition PV = constant, show that the work done on the gas is W=(11)(PfVfPiVi) (b) Starting with the first law of thermodynamics, show that the work done on the gas is equal to nCV(Tf Ti). (c) Are these two results consistent with each other? Explain.
An ideal gas is compressed to half its initial volume by means of several possible processes. Which of the following processes results in the most work done on the gas? (a) isothermal (b) adiabatic (c) isobaric (d) The work done is independent of the process.
Review. A house has well-insulated walls. It contains a volume of 100 m3 of air at 300 K. (a) Calculate the energy required to increase the temperature of this diatomic ideal gas by 1.00C. (b) What If? If all this energy could be used to lift an object of mass m through a height of 2.00 m, what is the value of m?
Does a gas become more orderly when it liquefies? Does its entropy change? If s, does the entropy increase or decrease? Explain your answer.
(a) An ideal gas expands adiabatically from a volume of 2.0103 m3 to 2.5103 m3. If the initial pressure and temperature 5.0105 Pa and 300 K, respectively, what are the final pressure and temperature of the gas? Use =5/3 for the gas. (b) In an isothermal process, an ideal gas expands from a of 2.0103 m3 to 2.5103 m3. If the initial pressure and temperature were 5.0105 Pa and 300 K, respectively, what are the final pressure and temperature of the gas?
(a) How much food energy will a man metabolize in the process of doing 35.0 kJ of work with an efficiency of 5.00%? (b) How much heal transfer occurs to the environment to keep his temperature constant? Explicitly show how you follow the steps in the Problem—Solving Strategy for thermodynamics found in Problem-Solving Strategies for Thermodynamics.
A sample of an ideal gas expands isothermally, doubling in volume. (a) Show that the work done on the gas in expanding is W = nRT ln 2. (b) Because the internal energy Eint of an ideal gas depends solely on its temperature, the change in internal energy is zero during the expansion. It follows from the first law that the energy input to the gas by heat during the expansion is equal to the energy output by work. Does this process have 100% efficiency in converting energy input by heat into work output? (c) Does this conversion violate the second law? Explain.
A gas in a cylindrical closed container is adiabatically and quasi-statically expanded from a state A (3 MPa, 2 L) to a state B with volume of 6 L along the path 1.8pV= constant. (a) Plot the path in the pV plane. (b) Find the amount of work done by the gas and the change in the internal energy of the gas during the process.
Explain how water’s entropy can decrease when it freezes without violating the second law of thermodynamics. Specifically, explain what happens to the entropy of its surroundings.
What is the change in entropy in an adiabatic process? Does this imply that adiabatic processes are reversible? Can a process be precisely adiabatic for a macroscopic system?
This problem compares the energy output and heat transfer to the environment by two different types of nuclear power stationsone with the normal efficiency of 34.0%, and another with an improved efficiency of 40.0%. Suppose both have the same heat transfer into the engine in one day. 2.501014J. (a) How much more electrical energy is produced by the more efficient power station? (b) How much less heat transfer occurs to the environment by the more efficient power station? (One type of more ef?cient nuclear power station, the gas—cooled reactor, has not been reliable enough to be economically feasible in spite of its greater eficiency.)