36 - By applying a sinusoidal signal of frequency w0 to a linear system, the steady-state output of the system will be: O A) a sinusoidal signal with the same phase, but difference in amplitude and frequency O B) a sinusoidal signal with the same frequency, but difference in amplitude and phase O C) a sinusoidal signal with the same amplitude, but difference in frequency and phase O D) any signal with the difference frequency and amplitude O E) any signal with the same frequency and amplitude

36 - By applying a sinusoidal signal of frequency w0 to a linear system, the steady-state output of the system will be: O A) a sinusoidal signal with the same phase, but difference in amplitude and frequency O B) a sinusoidal signal with the same frequency, but difference in amplitude and phase O C) a sinusoidal signal with the same amplitude, but difference in frequency and phase O D) any signal with the difference frequency and amplitude O E) any signal with the same frequency and amplitude

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in series. The voltage across the capacitor: Select one: a. Leads the current in the capacitor by exactly 90o b. Is in phase with the sinusoidal voltage source c. Is in phase with the voltage across the resistor d. Leads the current in the circuit by 90o e. Lags the current in the circuit by 90o
b) Determine the voltage ?(?) and current ?(?) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors ?L, ?r and ?c. e) Sketch the phasor diagram showing ?s, ?r, ?r, ?c and ?.
2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b) Determine the voltage v(t) and current i(t) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors V,, VR and Vc. e) Sketch the phasor diagram showing Vs, Vr, Vr, Vc and I.
PHASE RELATIONSHIP SINUSOIDAL( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
1. What effect does changing the frequency on the effective value of sinusoidal voltage? 2. What effect does changing the amplitude on the effective value of sinusoidal voltage?
Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage and circuit current in purely capacitive circuits? 2. Vm = 100cos(377t + 75°) transform into sine form is a complex number that represents the amplitude and phase of a sinusoid. 3. 4. What is the phase relationship between a supply voltage and current through a purely inductive circuit? . 5. The rms value of the signal is also called the
(b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequeney of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms . (iii) Determine phase relationship between voltage and current waveform.
18 In the circuit shown in the figure below, for what value of C will the current-I be in phase with the sinusoidal source voltage V= sin2t? Vs (1 + j1) Q (a) -F 4 (b) (c) (d) 1F /-
1. A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk Vrms h. equation of the waveform (in time domain) i. the instantaneous voltage when t = 120 ms j. the angle (1st occurrence) aftert = 0 when the C. voltage is +80 V k. the time (2nd occurrence) after t = 0 when the voltage is -10 V d. Period e. Frequency f. Angular Velocity g. Phase Angle 180 V -50 ms
Task (3) Al Hussein Technical University You are given the below parallel RLC circuit, answer the following questions showing the detailed steps. 1.5 μF Lis 300 mH 220 V R3 300 2 L2 120 mH 50 Hz 0.5 µF Figure 3: Parallel RLC Circuit a) Total impedance of the circuit b) The voltage and current Phase shifts of the total impedence. c) The voltage across C1 and the current flows through it. d) The voltage across L1 and C2. e) The currents flow through L1, R and L2.
1. Instruction: Provide the correct answer. 1. What is the relationship between the supply voltage and circuit current in purely capacitive circuits?. 2. Vm = 100cos(377t + 75°) transform into sine form is a complex number that represents the amplitude and phase of a sinusoid. 3. 4. What is the phase relationship between a supply voltage and current through a purely inductive circuit?. 5. The rms value of the signal is also called the 6. The It is also the cosine of the angle of the load impedance. 7. When Q < 0, the power factor is 8. The process of increasing the power factor without altering the voltage or current to the original load is known as 9. is the cosine of the phase difference between voltage and current. is the measurement to measure average power. 10. What is the meaning of VAR?