46. A star connected, 3-phase, 20 MVA, 6.6 kV alternator has a per phase reactance of 20%. It is protected by merz-price circulating current principle which is set to operate for a fault current of 180 A. Then calculate the reactance per phase of 20% of winding. (B) 0.80 (3) 9.9879 (A) 0.40 (90429

Q: Does r' = er = 0.788r, which comes in calculation of inductance, play a role in capacitance…

A: Whether r′=e−14r=0.788r is important in calculation of capacitance or not just like inductance…

Q: + V₂ | 20 mA Hua R₁ R₂ 1.2 ΚΩ 3.3 ΚΩ V, I

A: The given electric network is:

Q: The Laplace transform of the function i(t) is 5s+3 I (s) = s(s+4)(s²+3s+2) Its final value will be

A: Given function, Is=5s+3ss+4s2+3s+2

Q: In Figure 16-8, the button on Floor A will operate the buzzer on Floor B. The button on Floor B will…

A: Two buzzers at two different floors operated by two buttons with three wire connection

Q: (b) Consider the following discrete-time linear time invariant (LTI) system: (i) 0.1] x+1)=[088 04]…

A: A=0.80.100.4,B=12,C=12,

Q: C R₁ Vo For the op-amp filter circuit shown above, assume C₁ = 10nF, R₁ Find the passband gain (in…

A: Given Circuit: To determine: Pass-band gain

Q: 4. Set up the LP formulation for state estimation (Do not solve LP). Bus 1 is the slack bus with V₁…

A:

Q: picks one input and connects it to one output. seven-segment display Demultiplexer, ob. Od. parity…

A: In this question we will write about  device that picks one of many inputs and links it to a single…

Q: In the circuit shown below, if VA= 1V and V-2V, the statuses of the diodes are (Assuming ideal…

A: In this question we need to choose a correct option

Q: Problem5. Find the A.C. steady state current i using nodal analysis. Hint: Covert the problem to…

A: In this question,  We need to determine the steady state current i as shown the circuit.  We know…

Q: Given the Transmitter frequency = 10.55 GHz and the satellite Translation frequency = 650 MHz,…

A:

Q: Determine the zero-state response of the following system, if the input is; f(t) = e-4t.u(t) H(s) =…

A: In this question we need to find the zero state response for the given input

Q: A 24 KW, 140 V, Duplex LAP-wound DC machine has been set to induce rated voltage at a speed of 2200…

A:

Q: 4.46 The electric field intensity in free space is given by E = 2 xyz ax + x²z ay + x²y a₂ V/m…

A: Electric field intensity in free space is, E=2xyzax+x2zay+x2yaz V/m Charge Q=2 C is required to move…

Q: MI If Is=1x10¹6A and V₁-26mV, Then Vout is 750 mV Select one: O a HE RL 1KQ Ic 91 131 V O b. 2.66 V…

A:

Q: An RLC electrical circuit consists of a resistor (resistance R), an inductor (inductance L) and a…

A: The ODE is given as LdIdt+RI+QC=0      ...1I=dQdt     ...2Now, we need to solve the above ODE to get…

Q: Consider the two-input nonlinear system żey 1 x = u ý = v Use the center manifold theory to prove…

A: Consider the two-input nonlinear systemz˙=exy-1x˙=uy˙=v(i) Use the center manifold theory to prove…

Q: (4 X(+) Assume that X(jw) is Fourier transform of x(+): Determine and Cos(5wt) (مان) Ax -Sw -3w -2W…

A:

Q: Consider the gate in the following circuit: +2.5 V Logic inputs A to E A HL PMOS network E O BO H…

A:

Q: Find the current through 4KQ (connected across terminal a-b) using Norton's equivalent circuit. ΙΚΩ…

A:

Q: are there more steps to get the final transfer function

A:

Q: Q 5:A 50 HZ 4 pole turbo generator rated at 20 MVA, 13.2 KV has an inetia constant of 9 KJ/MVA A.…

A: In this question we need to find the following Kinetic energy stored in rotor at synchronous speed…

Q: Determine the directivity in dB for an antenna that produces a power density of 10 uW/m2 at a point…

A: To determine the directivity in dB for an antenna that produces a power density of 10 μW/m2 at a…

Q: k E מן x (Output) u(t) (Input force) No friction $¹3: Mechanical systems

A:

Q: 6. There is no energy stored in the capacitor in the circuit below when switch 1 closes at t= 0.…

A: In this question we need to find the voltage vo(t) for t>0.

Q: A 5232/436 volts, 41 hz, 180 504 KVA step-up transformer is connected to a source having a line…

A: A 5232/436 volts 41 hz 180.504  step-up transformer is connected to a source having a line frequency…

Q: Consider the circuit below. [ 500R 12V 1k 100R 300R 2k R and k are resistance multipliers of x1 and…

A:

Q: flash distillation A three-stage flash unit is being operated in a plant. The feed enters flash drum…

A: A three-stage flash unit is being operated in a plant. The feed enters flash drum 2 (FD2). The…

Q: /A4 pole turbo generator is rated at 150m VA 14 Kv and 50 HZ has an inetia constant of H 12 Mj/MVA,…

A: In this question we need to the rotor acceleration in electrical degree/sec2.

Q: Ti 1 X"=j0.05 j0.15 G1+D C 3 막 스 中 20.6 10.3 2 T2 j0.05 X"=j0.05 (G2) 시

A: We need to draw the positive, negative, zero sequence network for this given power system network.

Q: Exercise The armature of a 8-pole, 400 r/min generator, has 80 slots. Each coil has 6 turns and the…

A:

Q: Find the Fourier series representation of f(t) = 1 + t, −π < t < π , period 2π

A: Given Data: A continuous-time signal of, f(t) = 1 + t, −π &lt; t &lt; π  To Find: Fourier series…

Q: Suppose a 200 load resistor is attached to the filter in (Figure 1). Figure Vil 150 Ω ww 10 mH +…

A:

Q: A single phase bridge inverter has an RLC load with R= 20 ohms, L= 32 mH and C = 0.115 mF. The…

A: In this question we need to find the power absorbed by the load Po and the fundamental power Po1 .

Q: Find the output y(n) of the system h(n)= u(n)-u(n-3) if its input x(n)= (-)"u(n), by using a) y(n)=…

A:

Q: The equivalent circuit of a 22KVA, 11700/450 V, 60Hz, single-phase loaded transformer when referred…

A: The circuit diagram is shown below,

Q: A-30 transmission line is having positive sequence impedance 20 Q and the zero sequence impedance is…

A: Given, A 3-phase transmission line having, Positive sequence impedance, Z1=20 Ω. Zero sequence…

Q: The sacrifice factor of the op-amp is equal to Select one: O a. Aol + Ad O b. 1+ Aol B O c. Aol -…

A: Sacrifice factor : Sacrifice factor is defined as the ratio of open loop gain and the closed loop…

Q: b) [Research Question] Design a DC battery charger for an electrical vehicle which has a 96 V…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Find V(t). Is=10A, R= 10Ω, L=5H C=1 mF. AT T=0 THE SWITCH OPENS The circuit is in the attached…

A: In this question we need to find the voltage v(t) shown in the given circuit

Q: ) Given an input voltage from power supply battery, V dc-12V, f=3 kHz and ON time is 0.2m Calculate…

A: Given : Vdc=12 Vf=3 kHzTON=0.2 ms

Q: How much is Vab in the circuit. 9 Ω 12 V 4Ω a -Ö + Vab- 8 Ω Μ 3Ω Μ 1Ω

A:

Q: 4) a) A GaAs diode with V₁ = 4V C = 30 μF is given as the configuration on figure Vi 10 V a) Obtain…

A:

Q: A 13320 / 370 volts, 62 hz, 160.95 KVA step-up transformer is connected to a source having a line…

A: Transformer specification 13320/370 volts  62 Hz 160.95 KVA

Q: Asynchronous generator, with synchronous reactance of 4 ohm, is connected directly to an infinite…

A: Given, Synchronous reactance, Xs=4 Ω. Phase voltage of infinite bus, Vph=15842 V. The equivalent…

Q: = Consider the circuit to the right. Vad = 5V, Vin = 1V, kn 2mA/V² and Vtn = 0.5 V. Find ID, VD and…

A: Consider the given circuit, Vdd=5V , Vin=1V , kn=2 mA/V2  and  Vtn=0.5 V. To find ID , VD​ and…

Q: The symbol Oground Olighting panel power panel time switch represents

A: Symbols of  Ground  Lighting panel Power panel Time switch

Q: 14.22 Find the transfer function H(w) with the Bode magnitude plot shown in Fig. 14.74. H (dB) A 40…

A: In this question we need to find the transfer function from the given bode magnitude plot

Q: The following timer block depicts a(n) B001 Tra Rem = off 00:00s+ O a. Off-delay O b. Asynchronous…

A:

Q: state one of the wind energy conversion system design consideratons. Why is this important? 2. What…

A: Step-1&gt;One important design consideration for a wind energy conversion system is the selection of…

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.