Answered: 5. A cylindrical tank is at rest as…

5. A cylindrical tank is at rest as shown. The tank has a weight of 100 kN. Approximately what horizontal force (in kN) should be applied horizontally at point C to raise the tank? Answer 57.7 center

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter11: Angular Momentum

Section: Chapter Questions

Problem 24P: Repeat the preceding problem replacing the marble with a solid cylinder. Explain the new result.

See similar textbooks

Related questions

Q: 62. A certain hydraulic system is designed to exert a force 100 times as large as the one put into…

Q: 7. The face of a dam adjacent to the water is vertical, and its shape is in the form of an isosceles…

Q: A fire truck ladder is 20 m long, weighs 28000 N, has its center of gravity at its center, and can…

A: The free-body diagram of the ladder is shown below.

Q: A large man sits on a four-legged chair with his feet off the floor. The combined mass of the man…

A: To find the pressure

Q: 13. Review. The tank in Figure P14.13 is filled with water of depth d = 2.00 m. At the bottom of one…

Q: A small ferryboat is 3.90 m wide and 5.90 m long. When a loaded truck pulls onto it, the boat sinks…

A: Given:- A small ferryboat is 3.90 m wide and 5.90 m long. When a loaded truck pulls…

Q: For the hydraulic press , which is right? (a) pA = pB & F1 > F2 (b) pA = pB & F1 pB & F1 = F2…

A: In case of an uncompressible fluid the pressure is distributed same everywhere in the fluid, thus…

Q: 5. The billboard BC weighing 500 kN is subjected to a wind pressure of 150 kN/m as shown. Neglecting…

Q: 1)A round fishing bobber floats with 25% of its volume below the water. The boober has a radius 2.0…

A: 1)volume immersed = 25 % of the original volume = 0.25 * (4π/3) * (0.02)3 = 8.377 * 10-6 m3

Q: 5. The small piston of a hydraulic lever has a diameter of 5cm. The large piston has a diameter of…

A: Given: The diameter of small piston is 5cm The diameter of the larger piston is 50cm

Q: Pressure Pump P Po h Water

Q: A bronze statue of mass 200 kg is being completely submerged a water tank , held motionless by a…

Q: A horizontal pipe narrows from a radius of 0.280 m to 0.110 m. If the speed of the water is 1.70 m/s…

A: From the conservation of mass, we can say that the amount of water flowed in two pipes must have to…

Q: 2] The device shown is used to straighten the frames of wrecked autos. Determine the tension of each…

Q: The Mariana trench is located in the Pacific Ocean at a depth of about 11 000 m below the surface of…

Q: A large man sits on a four-legged chair with his feet off the floor. The combined mass of the man…

Q: 1] The members of a truss are connected to the gusset plate. If the forces are concurrent at point…

Q: The cylinder in the figure rest on an inclined plane and is submerged in liquid up to its top as…

A: Let R denote the radius of the cylinder, h denote the height of the cylinder, V denote the volume of…

Q: The Mariana trench is located in the floor of the Pacific Ocean at a depth of about 11400 m below…

Q: PROBLEM (a) Calculate the weight of a cylindrical column of water with height h = 40.0 m and radius…

Q: The Mariana trench is located in the Pacific Ocean at a depth of about 11 000 m below the surface of…

Q: Q2) A) The massless, 122 cm-wide gate shown in Fig. (3) pivots about the frictionless hinge O. It is…

A: Given: Gate width =1.22m Weight pivoted = 907kg Now applying lever action we get height of the water…

Q: A storage tank holding gasoline (SG = 0.72) and water is shown on the right. What is the absolute…

A: Let the height of storage tank is H. Than the gauge pressure at the bottom = (density of gasoline)×…

Q: (II) A viscometer consists of two concentric cylinders, 10.20 cm and 10.60 cm in diameter. A liquid…

A: Given data *The diameter of the inner cylinder is d1 = 10.20 cm = 10.20 × 10-2 m *The diameter of…

Q: The pipe flow in Fig. P3.12 fills a cylindrical surge tank as shown. At time t = 0, the water depth…

Q: A pirate's treasure chest lies 50.0 m below the surface of the ocean. What is the magnitude of the…

A: Write the surface area of rectangular top.

Q: A hollow ball with a diameter of 3.72 cm has an average density of 0.0843 g/cm. What force must be…

A: The needed buoyancy-(G)＝The force required＝(density of water) × gravity × (volume of T.T. ball) - mg…

Q: Ans the following: (a) Will a piece of iron float or sink in water ?

A: Given data, Density of water=1 g cm-3Density of iron=7.8×10-3g cm-3Density of mercury=13.6 g cm-3Ans…

Q: 1. An anchor of mass 100 kg a nd volume 4.0 x 10 m is resting on the bottom of a lake, with a rope…

A: According to Archemede's principle Buoyant force =weight of liquid displaced

Q: Water is to be pumped to the top of the Empire State Building, which is 366 m high. What gauge…

A: Given that, Height = 366 m

Q: The iron block weighs 4N and has a volume of 182 cm3. What is the density of the block? a. 2010…

A: Weight of the iron block is W = 4 N Volume of the block is V = 182 cm3

Q: 3. A dam is used to hold back a river. The dam has a height H = 12 m and a width W = 10 m. Assume…

A: a) As given , density of water at 40C is 1000 kg/m3 Consider a small strip of dam length dy at a…

Q: A small ferryboat is 4.10 m wide and 6.70 m long. When a loaded truck pulls onto it, the boat sinks…

A: Width of the boat is w = 4.10 m Length, l = 6.70 m Depth, h = 3.60 cm = 0.036 m Buoyant force, Fb=mg

Q: 7. There are water in the containers below with same heights which shown (a), (b), (c) and (d).…

Q: hat is the volume of the person that is above water? Express answer using two significant figures

A: Given Mass = m= 75 kg Volume=V = 0.086 m³ Weigjt = 75*9.8 =735 N Density of water=p = 1000 kg/m³…

Q: 47. A person with a mass of 81 kg and a volume of 0.089 m² floats quietly in water. (a) What is the…

A: Answer :- a) the volume above the water is - V above = Vtotal - V sub = 0.089 m3 -…

Q: shoes

A: Given: Mass of the woman = 50 Kg The radius of the heel = 0.500 cm Pressure on the floor =?

Q: 3. A hollow block of plastic floats on sea water (density 1030 kg/m') with 51.0% of its volume under…

Q: B15 A tank contains a liquid of density 1.2 x 10 kg m '. A body of volume 5.0 x 10 'm' and density…

Q: A box made of high grade plastic material has an initial volume of 20 m3. It is then immersed below…

A: Given data: Original volume (V) = 20 m3 Final volume (V') = 17.39 m3 Required: The volume strain

Q: 5. Consider an upright cylindrical water tower with a of radius (7 m). The water depth in the water…

Q: Hydraulic balance. An m = 60.0 [kg] box was placed on top of a 2.75 [m²] massless platform. Given…

Q: Q6: Water enters a horizontal pipe with a rectangular cross section at a speed of 1 m/s. The width…

A: Given, Speed of water initially,v1=1 m/s Initial pressure, P1=3000 Pa Height,h=20 m Density of…

Q: A box made of high grade plastic material has an initial volume of 20 m. It is then immersed below…

A: strain on the body is defined as change in dimension of body divided by initial dimension of the…

Q: 14.Consider the following situations: In an automotive shop, the force exerted on the small piston…

Q: Two adult polar bears, each of mass 440. kg are adrift on an ice floe in the seawaters of the Arctic…

Concept explainers

Density of Solids

The density of a substance refers to how much matter is present in a given amount of space. It is expressed as the ratio of the mass of the substance to its volume.

Question

lomework tarquin (27066)
Explanation:
law of sines,
5. A cylindrical tank is at rest as shown. The tank has a weight of 100 kN. Approximately
what horizontal force (in kN) should be applied horizontally at point C to raise the tank?
Answer 57.7
wcenter

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

63. To find the resultant of a concurrent force system, express each force as a Cartesian vector and add the i, j. k components of all the forces in the system. True False 64. A position vector ir ates one point in space relative to another point. True False 65. The tensile force developed in a continuous cable that passed over a frictionless pulley must have a constant magnitude throughout the cable to keep it in equilibrium. O True False 66. A cable can support only a compressive or "pulling" force. True False 67. In equilibrium, IF includes all the known and unknown forces which act on the particle. True O False
Figure Fw 40° CG mg FT ▼ Calculate the tension Fr in the wire that supports the 42 kg beam shown in the figure(Figure 1). Express your answer using two significant figures. FT = 320 N ✓ Correct Part B Previous Answers A Calculate the magnitude of the force Fw exerted by the wall on the beam. Express your answer using two significant figures. Fw = 320 N Part C Previous Answers ✓ Correct ✔
3 edugen.wileyplus.com/edugen/lti/main.uni IS Fundamentals of Physics, 11th Edition, Custom WileyPLUS Course for West Help | System Announcements PRINTER VERSION BACK NEXT Chapter 10, Problem 043 Your answer is partially correct. Try again. The uniform solid block in the figure has mass 30.1 kg and edge lengths a = 0.836 m, b = 1.34 m, and c =0.0995 m. Calculate its rotational inertia about an axis through one corner and perpendicular to the large faces. Rotation axis
The lamina shown is a quarter circle with radius 4 cm and mass M kg. Find the angle that AB makes with the vertical when a mass of 0.5M kg is attached to C and the lamina is freely suspended from B. В 4 cm A
1. Complete the following if g = 9.81 and V = 10 m3 (Show your Solution) (kg' m(kg) W (N) kg \m m³ A 20 C 4. 100 E 100
Determine the bending moment 6.75 ft to the right of point B for the beam shown belowif P = 579 lb, Q = 702 lb, R = 517 lb, x = 5.27 ft, y = 5.88 ft, and z = 6.4 ft. Round off the final answer (in lb ft) to four decimal places. ... P O R |x Your Answer: -2,089.652 B y C D 2A- Z E
The 300-lb force is to be resolved into the compu salong lines a-a' and b-b'. Determine the angle a knowing that the component along line a-a' is 240-lb. b. What is the corresponding value of the component along line b-b'. a. 300 lb 60° Your anSwer
A 185 N sign is supported by two ropes. One rope pulls up and to the right ?1=29.5∘ above the horizontal with a tension ?1, and the other rope pulls up and to the left ?2=42.5∘ above the horizontal with a tension ?2, as shown in the figure. Find the tensions ?1 and ?2.
Knowing that the mass of the cylinder in the figure shown is 1Okg.(The acceleration of gravity g=9.8 m/s) Determine the tension in cable CA and CB that is required for equilibrium of the cylinder. B. 30°7 45° Select one: O a. Tension in cable CA=71.7 N, Tension in cable CB=50.7 N O b. Tension in cable CA=87.9 N, Tension in cable CB=71.7 N O . Tension in cable CA=50.7 N, Tension in cable CB=71.7 N O d. Tension in cable CA=71.7 N, Tension in cable CB=87.8 N
A 500 N force is applied to the vertical pole as shown. Determine the scalar y-component of the force vector along x and y'-axes.
In rolling, if the maximum draft is 13 mm, & the coefficient of friction is Capstan is found in 0.3, thus the minimum roll radius is blanking. O Other processes 140 mm O Rolling. O 156.5 mm O forging. O 135.5 O bar drawing. O 130 mm wire drawing. O 145.5 mm Bending O 0.4215 O Deep drawing O 150 mm O extrusion. O 0.5125 O O أخرى: 144.444 mm
Two circular platforms are attached to a fluid reservoir. On one platform rests the entire cast of Glee frozen in carbonite. A force of 7.0 N is applied downward to the empty platform with radius 8.0 m. The other platform applies a force of 7.2 N to the carbonite-frozen pop-idols. What is the radius of the platform holding the Glee cast?