5. Determine the Resultant Force at A. 2 ft Fe 490 lb Fg 600 lb 4 ft 6 ft 3 ft 4 ft 2 ft 4 ft 3

Q: a)A simply supported beam of length 6 m ,carries point load of 3 kN 4 m from the left end. Draw the ...

A:

Q: find the x coordinate of the centroid of the composite line shown

A:

Q: Identify whether the water with the following condition is subcooled liquid, saturated liquid, wet s...

A: It is required to determine state of water

Q: 6.17 : A centrifugal compressor running at 2000 rpm receives air at 17C and if the outer diameter of...

A: Given: velocity = 2000 rpm diameter = 750 mm Cp = 1 kJ/kgK = 1000 J/kgK Answer: 23.16 deg C

Q: The continuous cable that wraps around the small pulleys at A, B, C, and D has a length of 8m. The s...

A:

Q: What is the endurance limit of welded members?

A: To find  Endurance limit.

Q: If the long axis of ellipsoid makes 300 with horizontal plane and principal strain axes ratio is 3.5...

A: Like pressure investigation at a point, strain can likewise be turned to various bearings and conseq...

Q: Is the effect of temperature on all materials the same? Yes or no

A: No, the effect of temperature is different for different materials.

Q: the reaction forces at

A: To find Reaction forces at Point A & D

Q: What would happen to the two shocks if the diffuser angle was reduced from 6 degrees to 0 degrees? W...

A: Given: M1 = 2.3 deviation = 6/2 = 3 degree  

Q: Consider an ideal SPRING-MASS SYSTEM with a block of mass m attached to a movable end of a horizonta...

A: Given data Spring-mass system with a block of mass m attached.Spring constant = k It undergoes simpl...

Q: A stone is thrown vertically upward from the ground with a velocity of 48.3 ft/sec. One second later...

A:

Q: Assuming that the Earth has a uniform density p = 5540.0 kg/m', what is the value of the gravitation...

A: Answer: The value of the gravitational acceleration at a distance of 4100 km from the Earth's center...

Q: Find the number of rotations of wheel 3 in rotations per minute (rpm) wile the load A is moving down...

A:

Q: Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. The frame, loaded as shown, is ...

A: Given DataP=30kipsfs= 2.435

Q: Calculate the magnitude of the tension T and the angle 0 for which the eye bolt will be under a resu...

A:

Q: A square hollow bar having an outside dimension of 250 mm by 250 mm with 6 mm thick is to be replace...

A: Now since at every point, it is assumed that the particles of materials are in equilibrium, the shea...

Q: A two stage air compressor has a suction condition of 100 kpa, 30 o C and has a capacity of 3 m3 /s....

A:

Q: A graduated cylinder has a mass of 100 gm when empty. When 30 ml of water is added, the graduated cy...

A:

Q: In most commercial aircraft the wings are connected to the fuselage through O a, rivets O b. welding...

A: Wing is kind of cantilever beam. Lug use to attach fuselage to the wings. The main loading on the wi...

Q: 14.11) FOR THE GIVEN STATE OF STRESS, DETERMINE (A) THE ORIENTATION OF THE PLANES OF MAXIMUM IN-PLAN...

A: Givenσx=124.2MPaσy=-82.8MPaτxy=55.2MPa

Q: Operational Cable mass=15kg 5x %3D Aircraft Rudder 2.2361m (a)

A: Giveny4=5x  or  y=514x14y=2.2361mx=5mthe maximum permissible load of the cable , Pr=3kN=3000Nmass of...

Q: The composite beam shown in the Figure below is formed of a wood beam and a steel reinforcing plate....

A:

Q: The composite beam shown in the Figure below is formed of a wood beam and a steel reinforcing plate....

A:

Q: Calculate the pressure exerted on a floor by a one pointed table leg (170 kg on all four leg) of are...

A:

Q: For the shown static system, determine the minimum diameter of cable BD to withstand the shown load,...

A:

Q: An AISI 1045 cold-drawn steel tube has an outside diameter of 50 mm and an inside diameter of 42 mm....

A: do=50mm di=42mm

Q: List the top hardest materials and describe their hardness property and applications

A: Given Material To find Hardest material list Hardness and application of the materials

Q: difference between parallelogram and crank-rocker mechanism

A:

Q: Fins, or extended surfaces, commonly are used in a variety of engineering applications to enhance co...

A:    Fins are surfaces that extend from an item to improve the rate of heat transmission to or from th...

Q: withstand the shown load, given that the maximum allowable stress for the ca 90 MPa. 40° 32 kN D в 3...

A:

Q: Derive the expression for the frequency trasfer functions X,(i w)/F (i w) and 0(i w)/F(i w) and (2.4...

A: Given : To find : Transfer function

Q: (he head of water over the Lelkeed. B. An inward flow reation turbine & Supplyiny water at outlet an...

A: Given; Discharge rate = 600 liters/s Velocity of flow = 6 m/s The velocity at periphery , u1=24 m/s ...

Q: 4.Find the gain vo/vs of t

A: To find Gain of circuit

Q: Explain how important is instrumentation and process control in Engineering industry

A: Instrumentation and Process Control :  Instrumentation and control is mainly  refer to the analysis ...

Q: SAMPLE PROBLEM 2: Assume that AE are equal for each rod Reqd: Internal forces for member AB, CD, EF ...

A: Given Data: Length of the beam, L=0.8 m

Q: 2. At a particular temperature, the surface tension of water is 0.073 N/m. Under ideal conditions, t...

A: Answer: The theoretical height of the capillary rise is 0.297655 m.  

Q: The wall of a room is made of plywood that has a thickness of 3.00 cm and an area of 18.0 m?. The ro...

A: Thickness of wall, L=3.00 cm=0.03  mArea of the wall, A=18.0 m2Temperature difference between inside...

Q: 4. A 128.0-N box is pulled up a frictionless ramp inclined at 30° from the horizontal at a distance ...

A:

Q: Q:What is the velocity of the wave in this coarial cable?

A: The velocity of wave or a signal in coaxial cable is about 8 in/ns.  

Q: 0.6 m 0.3 m 0.4 m F= 300 N B.

A: Given Data The distance AB in y axis is: 0.2 m The distance AB in x axis is: 0.4 m The force acting...

Q: 14.28) FOR THE GIVEN STATE OF STRESS, DETERMINE USING MOHR'S CICLE (A) THE ORIENTATION OF THE PLANES...

A: Given   σx = 13.8 MPa σy = 69 MPa τxy = 20.7 mpa.  

Q: A uniform horizontal beam with a length of 3.00 m and a weight of 40 N is attached to a wall by a pi...

A:

Q: How much does the water in an aquarium 2.5 ft long, 1.5 ft wide and 1.0 ft deep weight? (weight dens...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Under conditions for which the same room temperature is maintained by a heating or cooling system, i...

A:

Q: the pin support at A suddenly fails, determine the beam's initial angular acceleration and the force...

A:

Q: member AB of the frame. In other words, find the reactions at pins A and B. 300 lb 60° B 4 ft E -3 f...

A:

Q: I. Identify whetherthe waterwith the following condition is subcooled liquid, saturated liquid, wet ...

A:

Q: Calculate the steam quality of a saturated liquid/saturated vapour mixture at 100°C with enthalpy 81...

A: Giventemperature Ts=100oCspecific enthalpy h=812kJ/kg

Q: 1. A gas in a cubical container with side equal to 0.3568 m has a pressure of 0.24 MPa at 24°C. If t...

A: The stepwise procedure to solve this problem is shown in the following attached image: