6. The rate of flow of water through a horizontal pipe is 0.25 m³/s. The diameter of the pipe which is 200 mm is suddenly enlarged to 400 mm; the pressure intensity in the smaller pipe is 11.772 N/cm². Determine: (i) Loss of head due to sudden enlargement, (ii) pressure intensity in the large pipe, (iii) power lost due to enlargement

6. The rate of flow of water through a horizontal pipe is 0.25 m³/s. The diameter of the pipe which is 200 mm is suddenly enlarged to 400 mm; the pressure intensity in the smaller pipe is 11.772 N/cm². Determine: (i) Loss of head due to sudden enlargement, (ii) pressure intensity in the large pipe, (iii) power lost due to enlargement

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

8. Determine the rate of flow of water through a pipe of diameter 10 cm and length 60 cm when one end of the pipe is connected to a tank and other end of the pipe is open to the atmosphere. The height of water in the tank from the centre of the pipe is 5 cm. Pipe is given as horizontal and value of f= .01. Consider minor losses.
Water from a reservoir is pumped over a hill through a 450 mm diameter and an absolute pressure of 1.0 kg/cm2 is maintained at the summit. Water discharge is 30 m above the reservoir. The quantity pumped is 0.5 m3/s. Frictional losses in the discharge and suction pipe, and pump is equivalent to 1.5 m. The speed of pump is 800 rpm. Determine the following: a.Water power of the pump b.New value of discharge if the speed of the pump is increased to 1000 rpm c.New value of head if the speed of the pump is increased to 1000 rpm d.New value of power if the speed of the pump is increased to 1000 rpm Please solving using the methodology (Given, requires, schematic diagram, solution and discussion)
Determine the rate of flow of water through a pipe of diameter 20 cm and length 50 m when one end of the pipe is connected to a tank and other end of pipe is open to the atmosphere. The pipe is horlzontal and the height of water in the tank is 4m above the centre of the pipe. Neglect the minor losses and take f= 0.009.
Water flows at a rate of 0.030 m³/s in a 0.16-m-diameter pipe that contains a sudden contraction to a 0.08-m-diameter pipe. (a) Determine the pressure drop across the contraction section. (b) How much of this pressure difference is due to losses and (c) how much is due to kinetic energy changes? (a) P1-P2- (b) P1 P2 (c) P₁-P₂- kPa kPa kPa
Water (p = 1000 kg m3'H= 10-3 R) flows in a horizontal constant-area pipe; the pipe cross ms 1. section area of 0.1 m?. At the pipe inlet, a pump is installed and at the outlet, the pressure is atmospheric. Determine the pump power when the pipe length is 10 meter and a. When the velocity is 0.01 m/s b. When the velocity is 0.1 m/s and the pipe is smooth When the velocity is 0.1 m/s and the pipe equivalent roughness is 0.1 mm (you may use Moody chart here) d. When the pipe is smooth and vertical and the velocity is 0.1 m/s С.
Water flows at the rate of 0.015 m/sec from open reservoir A to open reservoir B (both are large reservoirs that are open to the atmosphere) through two concrete (8 = 0.32 mm) pipes connected in series. If L1 = 800 m, Di = 16 cm, L2 = 200 m, and D2 = 8 cm, determine the difference in water surface elevations (Az) of the reservoirs. The coefficient of contraction (K.) is 0.36, the entrance coefficient is K = 0.5, the exit coefficient is K = 1.0, and assume fully turbulent flow (Xx = 9810 N/m?, Ku = 1.12 x 10-6 m²/s). You do not need to check if the assumption of fully turbulent flow is valid, just assume that it is valid. А Az =? Pipe 1 В Pipe 2 undefined
Water flows through a corner valve at a flow rate of Q=0.75 m³/s . The pressure just upstream of the valve is P₁ = 500 kPa and the pressure just downstream is P₂ = 300 kPa. The inside pipe diameters of the valve inlet and exit are respectively, D₁ = 5 cm and D₂ = 12 cm. If the flow through the valve occurs in a horizontal plane, determine the head loss, h₂ (in meters) and the rate of loss of available energy (in W) across the valve. D2 Di
The total discharge in the system below is 15.5 cfs and the head loss from B to C is 24 ft. Using n = 0.011 for all pipes, determine the following: (a) flow rate Q2 (cfs) through pipe 2, (b) flow rate Q3 (cfs) through pipe 3, (c) flow rate Q4 (cfs) through pipe 4, (d) head loss h1 (ft) in pipe 1, and (e) head loss his (ft) in pipe 5. 2000 ft 12 in 3000 ft 1500 ft 4000 ft 30 in 10 in 24 in A В D 2500 ft 15 in
Determine the rate of flow of water through a pipe of diameter 10 cm and length 60 cm when one end of the pipe is connected to a tank and other end of the pipe is open to the atmosphere. The height of water in the tank from the centre of the pipe is 5 cm. Pipe is given as horizontal and value of f= .01. Consider minor [Ans. 15.4 litres/s] losses.
A pitot-static tube is used to measure the velocity of air flowing through a duct. The manometer shows a difference in the head of 5.8 cm of water. If the density of air and water is 1.13 kg/m3 and 1000 kg/m3 determine the velocity of air. Assume the coefficient of the pitot tube as 0.98. Head in meters
An orifice meter is to be installed in a 12 cm ductile iron pipe carrying water at 27oC. A mercury manometer is to be used to measure the pressure difference across the orifice when the expected velocity is 3.2 m/s. The manometer scale reads 12 mm Hg. Determine the appropriate diameter of the orifice. The density of the manometer fluid is 850 Kg/m3 while the density of water at 27oC is 993 Kg/m3. Assume C to be 0.61. Answer: 0.1204 m
A pipe with unequal ends is used to transport a fluid. The pipe diameter at the larger end is 0.67 cm and the other end is 0.29 cm. The larger and smaller ends are located 9 m and 3 m, respectively, from the datum line. If the flow at the 9 m datum line is 1.48 m/s and the pressure is 5156 kN/m2, compute for the pressure, in kPa, at the smaller end. Express your answer in 3 decimal places.