0:X +Denvellum.ecollege.com/course.html?courseld=17487819&OpenVellumHMAC=2eff1f5e5c39f8fae8797554f56600c3#10001@2F2WItem 5A 12 V car battery dies not so much because its voltagedrops but because chemical reactions increase itsinternal resistance. A good battery connected with jumpercables can both start the engine and recharge the deadbattery. Consider the automotive circuit of (Figure 1).Figure30.01 2+12 VE80F3E0.50 ΩJumpersGoodbattery$4+8V1Deadbattery000000F4R0.05 Ω%51 of 1Startermotor:::.F5T6F6Part AYHow much current could the good battery alone drive through the starter motor?Express your answer with the appropriate units.I =SubmitPart BI =ValuePart CHow much current is the dead battery alone able to drive through the starter motor?Express your answer with the appropriate units.SubmitMacBook Air&7BμARequest AnswerValueF7μARequest AnswerP PearsonUOUnitsDIIF8Units?9?DDF900F10PF11+

The given data we have: Internal resistance of good battery: 0.01Ω EMF of good battery: 12V Internal…

A 12 V car battery dies not so much because its voltage drops but because chemical reactions increase its internal resistance. A good battery connected with jumper cables can both start the engine and recharge the dead battery. Consider the automotive circuit of (Figure 1). Figure 0.01 ΩΣ + 12 V 050 ΩΣ Jumpers Good battery 8V Dead battery 1 of 1 > 0.05 ΩΣ Starter motor ▼ Part A How much current could the good battery alone drive through the starter motor? Express your answer with the appropriate units. I = Part B Submit Request Answer μА I= Value Submit How much current is the dead battery alone able to drive through the starter motor? Express your answer with the appropriate units. μA Value Units Request Answer ? Units ?

A 12 V car battery dies not so much because its voltage drops but because chemical reactions increase its internal resistance. A good battery connected with jumper cables can both start the engine and recharge the dead battery. Consider the automotive circuit of (Figure 1). Figure 0.01 ΩΣ + 12 V 050 ΩΣ Jumpers Good battery 8V Dead battery 1 of 1 > 0.05 ΩΣ Starter motor ▼ Part A How much current could the good battery alone drive through the starter motor? Express your answer with the appropriate units. I = Part B Submit Request Answer μА I= Value Submit How much current is the dead battery alone able to drive through the starter motor? Express your answer with the appropriate units. μA Value Units Request Answer ? Units ?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 70AP: A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters,...

See similar textbooks

Similar questions

A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V. (a) What average current does the phone draw from its battery? (b) Calculate the energy stored in a fully charged battery if the phone requires charging after 5.00 hours of use.
If electrical energy costs 0.12 per kilowatt-hour, how much does it cost to (a) burn a 100-W lightbulb for 24 h? (b) Operate an electric oven for 5.0 h if it carries a current of 20.0 A at 220 V?
A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?
Figure P18.26 shows a voltage divider, a circuit used to obtain a desired voltage Vout from a source voltage . Determine the required value of R2 if = 5.00 V, Vout = 1.50 V and R1 = 1.00 103 (Hint: Use Kirchhoff's loop rule, substituting Vout = IR2, to find the current. Then solve Ohms law for R2. Figure P18.26
Lightbulb A is marked 25.0 W 120. V, and lightbulb B is marked 100. W 120. V. These labels mean that each lightbulb has its respective power delivered to it when it is connected to a constant 120.-V source. (a) Find the resistance of each lightbulb. (b) During what time interval does 1.00 C pass into lightbulb A? (c) Is this charge different upon its exit versus its entry into the lightbulb? Explain. (d) In what time interval does 1.00 J pass into lightbulb A? (e) By what mechanisms does this energy enter and exit the lightbulb? Explain. (f) Find the cost of running lightbulb A continuously for 30.0 days, assuming the electric company sells its product at 0.110 per kWh.
A battery is used to charge a capacitor through a resistor as shown in Figure P27.44. Show that half the energy supplied by the battery appears as internal energy in the resistor and half is stored in the capacitor. Figure P27.44
If electrical energy costs 0.12 per kilowatt-hour, how much does it cost to (a) burn a 100-W lightbulb for 24 h? (b) Operate an electric oven for 5.0 h if it carries a current of 20.0 A at 220 V?
The current-versus-voltage behavior of a certain electrical device is shown in Figure OQ21.3. When the potential difference across the device is 2 V, what is its resistance? (a) 1 (b) 34 (c) 43 (d) undefined (e) none of those answers
Four resistors are connected to a battery as shown in Figure P21.40. The current in the battery is I, the battery emf is , and the resistor values are R1 = R, R2 = 2R, R3 = 4R, and R4 = 3R. (a) Rank the resistors according to the potential difference across them, from largest to smallest. Note any cases of equal potential differences. (b) Determine the potential difference across each resistor in terms of . (c) Rank the resistors according to the current in them, from largest to smallest. Note any cases of equal currents. (d) Determine the current in each resistor in terms of I. (e) If R3 is increased, what happens to the current in each of the resistors? (f) In the limit that R3 , what are the new values of the current in each resistor in terms of I, the original current in the battery? Figure P21.40
Figure P18.26 shows a voltage divider, a circuit used to obtain a desired voltage Vout from a source voltage . Determine the required value of R2 if = 5.00 V, Vout = 1.50 V and R1 = 1.00 103 (Hint: Use Kirchhoff's loop rule, substituting Vout = IR2, to find the current. Then solve Ohms law for R2. Figure P18.26
For the network in Figure P18.60, show that the resistance between points a and b is Rab=2717. (Hint: Connect a battery with emf across points a and b and determine /I, where I is the current in the battery.) Figure P18.60