)A 3 foot diameter culvert has a free discharge and steep slope. The entrance loss coefficient is K. = 0.5. The headwater is 6 feet above the invert of the culvert. What is the discharge? If the headwater continued to rise to 8 feet and the road level is at 7 feet, what is the flow given a road length of 15 feet and C = 1.5? (Recall Ca = 1/(1+KJ!/2)

)A 3 foot diameter culvert has a free discharge and steep slope. The entrance loss coefficient is K. = 0.5. The headwater is 6 feet above the invert of the culvert. What is the discharge? If the headwater continued to rise to 8 feet and the road level is at 7 feet, what is the flow given a road length of 15 feet and C = 1.5? (Recall Ca = 1/(1+KJ!/2)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Compute the normal depth of flow in a 36-in diameter culvert with a slope of 0.0016 and a Manning's n of 0.015 for a discharge of 20 cfs
1. A trapezoidal concrete-lined ditch has a bottom width of 3 ft, a depth of 2 ft, and side slopes of 2:1. Estimate the discharge if the channel slope is 1.0. What is the velocity? The Froude number?
A concrete-lined, rectangular channel has to be constructed to carry a discharge of 500 cfs. Design the channel assuming that the following values are fixed based on the design conditions: a. Bed slope = 0.002 b. n = 0.015 c. b/y ratio = 2.0 (i.e., the width, ?, is equal to 2y)
0.2A concrete pipe culvert is to be constructed under road to carry a max. Discharge Sm /sec. if the length of pipe culvert 10m @ slope 1/100 , find the diameter of the pipe & draw the culvert between the change of discharge & the diameter.
In a rectangular channel 2.5 feet wide with a discharge of 15 cfs and upstream depth of 6 inches, there is a 9 inch riser. What is the depth of flow after the riser? Why does the depth fall or rise? Note: kindly give me right solution according to the question
A rectangular channel (b = 9 feet) crosses beneath a roadway inside a 70-inch RCP culvert with a C = 0.6. Note: That the culvert dimensions may not be a standard size. 1. If the design flow rate is 281 cfs what is the water surface elevation when the invert elevation of the pipe is 1,277 ft. Report to 1 decimal place 2. Provide a profile view of the channel entering the culvert. Include the invert elevation, diameter, headwater and water surface elevation on your scratch paper.
A. Design a trapezoidal channel to carry a discharge of 10.5 m^3/s. The bottom slop of the channel is 0.0035. Also the flow depth is half of the channel bottom width. Take roughness coefficient as 0.025 and side slop as 1H to 4V. B. Based on the given information and your results in part A, compute the state of flow
An elliptical culvert is 3.5 feet tall and 9 feet wide. It is filled with water to a depth of 1.05 feet. Find width of the stream.
Don't copy from Chegg.. I need all right solutions with clear calculations. Determine the normal flow depth, Froude Number at normal depth and the critical depth for the rectangular channel has a width of 6 m and convey a discharge of 24 m3/s with Manning’s n=0.012 and the streamwise slope is 1 in 200. Determine whether the normal flow is subcritical or supercritical
Is the flow subcritical or supercritical in a 5 m wide rectangular channel with a discharge of 10 m³/sec? Take So = 0.005, n= 0.014.
2. Design a pipe culvert to be provided for a highway embankment across a small valley having the following data: Top width of the embankment: 8 m Height of the embankment: 4 m Side slope: 1.5 H: 1 V Maximum discharge: 6 cu-m/s Slope of the valley: 1/100 Loading: IRC Class AA Also, draw a longitudinal section along the pipe.
A concrete-lined trapezoidal channel has to be constructed to carry a discharge of 500 cfs. Design the channel. Assume that the following values were fixed based on the site conditions: • Bed slope = 0.002 • n = 0.015 • Side slope, z = 1 (vertical):1.5 (horizontal) • b/y ratio = 2.0