A 35.2 HP, 250 V, 100 A. 1500 RPM, series DC motor with ndmature reaction is considered in this problem. This motor has a series-field winding of 20 turns per pole. Its armature resistance in RA -0.05 £2, and its series field resistance is Rs 0.05 52. The magnetization curve at 1500 RPM is given by the following table: EA (V) F (Amp.tums) 50 95 125 150 180 200 212 229 250 253 1000 1280 1500 2000 2500 3000 3500 4000 243 200 500 755 The motor is operating at rated voltage, armature current of 100 Amperes, and with rotational losses of 1500 Watt. Find the speed of the motor. Answer: The speed is n- RPM.

A 35.2 HP, 250 V, 100 A. 1500 RPM, series DC motor with ndmature reaction is considered in this problem. This motor has a series-field winding of 20 turns per pole. Its armature resistance in RA -0.05 £2, and its series field resistance is Rs 0.05 52. The magnetization curve at 1500 RPM is given by the following table: EA (V) F (Amp.tums) 50 95 125 150 180 200 212 229 250 253 1000 1280 1500 2000 2500 3000 3500 4000 243 200 500 755 The motor is operating at rated voltage, armature current of 100 Amperes, and with rotational losses of 1500 Watt. Find the speed of the motor. Answer: The speed is n- RPM.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. The operation of Commutator in DC Motor is * O a) to convert dc to ac O b) to convert ac to dc O c) to convert fixed dc to variable dc O reverse the current direction in the rotating windings each half turn
• Q5/ in a DC motor. List and describe the types of losses that occur
A DC shunt generator delivers 45 A at a terminal voltage of 220 V. The armature and the shunt field resistances are 0.01 2 and 44N respectively. The stray losses are 375 W. What is percentage efficiency of the DC generator
A 230v DC series motor takes 30A when giving its rated output at 1400 rpm. It has a field resistance of 0,4 ohms, Calculate the value of the resistance (Ra) of the armature when Eb = 200V. Select the correct response: 0.2 ohms 0.6 ohms 0.8 ohms 0.4 ohms
A value of magnetizing current in a 3-phase induction motor * gives power factor smaller .. larger smaller. .poor large . better O large...poor O
A 250 V series motor has an armature resistance of 0.2 ohm and a series-fieldresistance of 0.18 ohm. If the speed is 6oo RPM when the current is 32 amps.What will be the motor speed when the load is reduced so that the current is18 amps, under which condition the percent flux change is 50 % of the percentcurrent change.
16 A 4-pole dc series motor has wave connected winding with 600 conductors. When fed from 250 V dc source, the motor drives a load of 5 kW and takes 50 A with a flux per pole of 10 mWb. The torque developed is (Neglect losses).
The winding of a 4-pole alternator having 36 slots and a coil span of 1 to 8 is short-pitched by ........... degrees. 150 40. 90 20 Brushless excitation system consisting of: Stator field winding and power diodes stator and rotor field winding and capacitor stator and rotor field winding and power diodes Everything mentioned in the options Full Name : *
6. The motion in DC motor can be increased by the following factors... (you may choose more than one) * a) Using a stronger magnet b) Increasing the potential difference c) Increasing the current d) Increasing the number of turns on the coil
8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical power developed by the motor is ............ (i) 20 W (iii) 500 W (ii) 980 W (iv) 200 W
a) The figure below shows the per-phase equivalent circuit of a two- pole three-phase induction motor operating at 50 Hz. The voltage (E1) across the magnetizing inductance is 210 V, and the slip (s) is 0.05. What is the developed torque produced by the motor ? 0.04 n j0.22 0 j0.22 0 j6.28 N E1 0.05 0
The efficiency of 3-ph induction motor. at (Is=4.5A, T=13 N.m, N=1333 rpm, Pph=864 watt ) is