A 6-MW offshore wind turbine has a capacity factor of 40%. It has a height of 120 m, and 107-m long blades. The angular acceleration is 1.388 rad/s2. Assume that the distance from the center of the turbine to the connection with the blade is negligible, and that the turbine starts from rest. At ? = 12 s, calculate the velocity and the acceleration for points (a) at half the length and (b) at the tip of the blade.

Q: A prototype submarine moves at velocity V, in fresh water at 20 °C, at a 2-m depth, where ambient…

A: Given    Depth, h = 2 m Pressure, P = 128 kPa Cavitation number, Ca = 0.25 Find   Velocity, v

Q: A wind stress of 0.2 N m-2 blows over an initially stationary freshwater lake, 20 km long, and moves…

A: Shear stress acts tangentially to the surface. Turbulent flow  is that type of flow in which the…

Q: An impeller (axial-flow turbine propeller) in an agitated tank has an output torque (T) whose…

A: Given data Output Torque (T) depends on Volumetric Flow rate(Q), density ( ρ ) rotor diameter (D)…

Q: Example 1.10 gave an analysis that predicted that theviscous moment on a rotating disk M = πμ V R 4…

A: The expression of the viscous moment for a rotating disk, The uncertainty of each variable is given…

Q: Example 9.15 A rope, to which a weight is attached, passes around a pulley 50 cm in diameter. The…

A:

Q: lease I need an answer for this  A water jet is deflected 180 degree in a curved vane with diameter…

A: Givend=25.5mm=0.025mJet velocity V=6.5m/sθ=0°

Q: Q9-A block 0.2 m square, with 5 kg mass, slides down a smooth incline, 30° below the horizontal, a…

A:

Q: A wind turbine, 12 m in diameter, operates at sea level in a wind of 20 m/s. The wake or downstream…

A:

Q: An incompressible fluid (kinematic viscosity =7.4x10-7 m2/s, specific gravity=0.88) is held between…

A: Given:Kinematic viscosity of fluid, ϑ=7.4×10-7 m2/sspecific gravity of fluid=0.88velocity, v=0.5…

Q: P1.20 A baseball, with m = 145 g, is thrown directly upward from the initial position z = 0 and V =…

A: For this problem,  The weight of the ball, for upward direction motion ∑Fz=-maz-CV2-mg=mdvdt…

Q: A model of the Airbus 320 is tested in a wind tunnel using air at standard conditions. If the tunnel…

A:

Q: Required information Outside an inner, intense-activity circle of radius R, a tropical storm can be…

A: The velocity components are defined as: vr=∂ϕ∂rϕ=U0Rθvr=0vθ=1r∂ϕ∂θ=U0Rr

Q: A wedge split a sheet of 20°C water in the air. Both wedge and sheet are 1 m long into the paper.…

A: Given    Velocity, v = 4 m/s Thickness, h = 4 cm = 0.04 m          Angle  = 60o Find   Force…

Q: 3. Given: A 20 g-bullet with 0.5 cm diameter and an acceleration, a= 1.5 x106 ft/s² is fired from a…

A:

Q: EXAMPLE 4-2 Acceleration of a Fluid Particle through a Nozzle Nadeen is washing her car, using a…

A: Considering the motion in the nozzle as steady, one-dimensional incompressible flow. The velocity of…

Q: Suppose that it is desired to estimate volume fl ow Q in apipe by measuring the axial velocity u ( r…

A: Figure depicts the best three measuring points volume flow analysis Figure shows the three test…

Q: A bird is flying in a room with a velocity field of…

A:

Q: The tank of water in Fig.  accelerates uniformly byfreely rolling down a 30 ° incline. If the wheels…

A: Given data as per the question inclination angle =300 considering the acceleration equation of the…

Q: Q2/B: A wind turbine has 2 m radius rotor at a wind speed of 10 m/s and air density is 1.223 kg/m'.…

A:

Q: The propeller on Don Karnage's airplane can be modeled as three identical thin rods of uniform…

A: According to the information we have, A body rotates around a fixed axis during rotational movement.…

Q: = 1.006 m. Example 5.16. An open tank 10 m long and 2 m deep is filled with 1.5 m of oil of sp. gr.…

A:

Q: As a young engineer, you have been tasked to select the location of a wind turbine based on the…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Water flows through a 5 cm diameter pipe at the average velocity of 1.25 m/s. (a) In the dimensions…

A: Given - Diameter (d) = 5 cm = 0.05 m Velocity (v) = 1.25 m/s a) The volumetric flow rate (Q) =…

Q: A rocket of mass 2.5 x 10°kg , launched with speed 300 requires a force of 1.5 × 10*N to give it a…

A: Given that mass of the rocket(m) =2.5×103 kg, u=300 m/s, F=1.5×104 N , v=500 m/s; the distance…

Q: 1. The piston speed of an air compressor is 150 m/min and has a piston diameter of 4 inches. double…

A:

Q: A two-dimensional reducing bend has a linear velocity profile at section 1. The flow is uniform at…

A:

Q: Q3) A body with a mass of 15 kilograms is moving with a velocity of 3 meters/second. If a force of…

A:

Q: As pictured below, you have a box, of unknown mass m, and push it against a spring, k = 100 N/m,…

A: Write the given data. k=100 N/mD=20 cm=0.20 m

Q: Find the distance of load from the nozzle in meter

A: Given: A water jet F=150.9 N v0=17.9 m/s d=3.9 cm To determine:  The distance of load from the…

Q: QI): Impulse turbine diameter 3.2m O = 0: Angular velocity = 25 rad/s Absolute velocities V, 140m/s…

A: Given: The diameter of impulse turbine, D = 3.2 m The angular velocity, w = 25 rad/s The absolute…

Q: Answer with True or False of the following question: 5. For a fluid at rest, the shear stress is…

A: 5 . For a fluid at rest, the shear stress is zero. True.   When we apply shear stress on solid it…

Q: A plate 0.05mm distant from a fixed plate moves at 1.15 m/s and required a force per unit area of…

A: As per the Bartleby rule, We’ll answer the first question since the exact one wasn’t specified.…

Q: An incompressible fluid flows in the converged nozzle provided in the figure. nozzle area ->…

A:

Q: A very tall 10-cm-diameter vase contains water at a depth of 6 cm. When spun steadily to achieve…

A: Given data as per the question Diameter = 10 cm Depth =6 cm

Q: For H =3 m, calculate Qi and Q2. 3m KENTRANCE= 1.0 KENT = 1.0 Q1 Q2 Di- 20 cm Li=2m Dz= 50 cm t=002…

A: Given: To Find: Q1 and Q2 "Since you have asked multiple questions, we will solve the first…

Q: Q2: A wind farm is proposed to be built outside of Baghdad Airport. The airport wind data Obtained…

A: Let us calculate the yield required 65 m annually.The yield required per hour =65 m10^qw / (365 x…

Q: In an axial compressor: O Both pressure rise and velocity rise can be predicted by the Euler…

A:

Q: thin layer oI water flowWs down a plate inclined to the horizontal with an angle a = 15° in the…

A: ζ=μvαForce=F=ζAF=μAvαF=mg sinα

Q: reducing water pipe section has an inlet diameter of 50 mm and exit diameter of 30 mm. If the steady…

A: Given Data D1=50 mm D2=30 mm V1=2.5 m/s

Q: A small, axisymmetric, low-speed wind tunnel is built to calibrate hot wires. The diameter of the…

A: At 60°F The properties of air ρ=0.07489 lbm/ft3μ=1.23×10-5 lbm/ft.s The speed of air, v=5 ft/s…

Q: /B: A wind turbine has 2 m radius rotor at a wind speed of 10 m/s and air density is 1.223 kg/m'.…

A: As per our guidelines we have to answer only one question. So, I am answering question B. Post the…

Q: Q2. The velocity distribution in the boundary layer over a high spillway face was found to have the…

A: For a given velocity distribution inside boundary layer Displacement thickness : It is the distance…

Q: Assuming that there are no heat effects and no frictional effects,find the kinetic energy and speed…

A: Stored potential energy at top will be converted into kinetic energy and potential energy at point…

Q: For a high-fl ow site with a head of 45 ft, it is desired to designa single 7-ft-diameter turbine…

A: given:Prototype Turbine speed ,Np=360 r/minpower=4000 bhphead=45 ftefficiency=88 %model turbine…

Q: the flow of a stream U, past a blunt flat plate creates a broad low-velocity wake . , with only half…

A: Given Data: The height of the plate is, L. The width of the paper is, b. The free stream velocity…

Q: A one-fifth scale model of a water turbine is tested in a laboratory at T = 20°C. The diameter of…

A: Given H = 15 m ,  Q = 17 m3/hr  = 173600 m3/sN = 1500 rpmP = 450 wattat 20°C( For water ) → S = 998…

Q: A small model water turbine is tested in a flume where Cp is measured to be 0.38. Assuming dynamic…

A:

Q: 1 (a) A plate 0.05mm distant from a fixed plate moves at 1.15 m/s and required a force per unit area…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.