Answered: A 6-pole alternator running at 1000…

A 6-pole alternator running at 1000 rpm, supplies an 8 pole induction motors. Find the actual speed of the motor if the slip is 2.5%.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 6RQ: Name three factors that determine the torque produced by an induction motor.

See similar textbooks

Related questions

Q: 10 V M 50 Ω e 25 Ω 100 Ω: 25 Ω W 75Ω 50 Ω 3 d Π tr 50 Ω =25Ω Ξ75Ω 100 ΩΞΞ 50Ω== Π |107 W 50 Ω —25Ω…

Q: 2. Is it desirable to have leading power factor loads? Why?

A: Obviously, it is always desirable to have a power factor lead so that the power factor of the system…

Q: Laplace transform of eet sin (wt) is: ● (52+02) (s_0)2+2 0 s–(8–w) 2 (0+8)2_2

A: Given function, ft=eθt sin ωt

Q: The form of the FS representation presented in this question, namely x(t) = Σ x[k]e/kwst k=-00 is…

A: A Fourier series is a periodic function represented by a sum of sine and cosine waves. Each wave in…

Q: Consider the function: X(s) Show that s = 0 is not a pole of X (s). = 1- e-Ts S

Q: R ww 220 Ω IR V/₂=20 V 12M=60 mA 32.68v to 33.87v 23.67v to 36.37v 20.80v to 38.9v 27.00v to 56.8v "…

Q: Explain and discuss the Integration property of laplace transform.

A: The solution is

Q: A 100 μF capacitor that had been charged to 30 V is discharged through a resistor. The figure…

A: Given, Capacitance, C=100 μF Initial voltage, V0=30 V Capacitor is discharged through a resistor.…

Q: Calculate the current required to produce a flux of 1.75 mwb in the ring, if the relative…

Q: Answer the following: a. Range of frequencies that are within the cut-off frequencies. -pass band…

A: Given

Q: The maximum power dissipation of a transistor is 100mW. If VCE = 20V, what is the maximum collector…

A: Given, PD = 100 mW = 0.1 Watt VCE = 20 V

Q: The device (or element) that used to protect electronic components which are vulnerable to reverse…

A: In reverse biased condition the diode doesn't conducts. So, the diode is the element that used to…

Q: Question 1: A) Derive the transfer function of the electrical circuits shown in Figure below and…

Q: A circuit consist of a single diode and resistor which are connected to AC source. The resistance…

Q: For the same secondary voltage, the output voltage from a center-tap rectifier is ............ than…

Q: For the circuit shown find the maximum and minimum values of zener diode current. 5kQ2 IL I 80-120 V…

Q: Determine the Q point of the transistor circuit shown in Figure. Given B = 200 and VBE = 0.7V. Ic IB…

Q: Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of…

A: The required parameter can be obtained by calculating the impedance of the capacitor and then by…

Q: how was the load 300<-36.86 achieved?

A: We know that power factor can be represented in terms of cosine function as shown below.

Q: b) The deflecting torque of an instrument is directly proportional to the square of the current…

A: Given,In an instrument, the deflecting torque is directly proportional to the square of the current…

Q: * The device (or element) that used to protect electronic components which are vulnerable to reverse…

A: The device that used to protect electronics components which are vulnerable to reverse voltage is…

Q: Industrial Electronics Please explain Show an application or an example of a circuit that…

A: It is asked to show an application or an example of a circuit that employs Ultrasonic sensors as its…

Q: 1 Simplify the expressions below, by using Karnaugh maps, in sum-of-products and product-of-sums…

A: Given a Boolean expression, F=ab+ab'c+ad'+a'cd

Q: What capacitor in series with a 100 resistor and a 15 mH inductor will give a resonance frequency of…

Q: it used to protect - against high voltage surges.

Q: Q3: Design a full adder with two 4/1 MUX.

Q: The D latch of Figure 1 is constructed with four NAND gates and an inverter. Consider the following…

A: It is given that:

Q: 5. A logic circuit has four inputs (x4x3x₂x₁) and a single output xo. The output is required to take…

A: According to the question, we need to design a logic circuit that contains an odd number of 1's.

Q: Determine the collector bias current. Assumeß = 50 and IS = 10^(-17)A

Q: circuit is used to shift vertically of the input signal.

Q: Compute the reactance of a 0.445 H inductor at frequencies of 61.0 Hz and 570 Hz. Enter your answer…

A: Given: Inductance, L=0.445 H Frequencies, f1=61.0 Hzf2=570 Hz

Q: Q8- The electric field intensity of a linearly polarized uniform plane wave propagation in the +z…

Q: As shown in the circuit below, a transformer is used to match an amplifier with an 8-ohm speaker.…

Q: (a) Derive the following relations for energy density and power density. E = 1/2 CV² E=1/7.2 CV² in…

A: given relation

Q: How does TP4056 works? What is the purpose of red and blue lights in the components?

A: The TP4056 chip is a single-cell lithium-ion battery charger that protects the cell against…

Q: 4. A 3-phase bundled transmission line of 200 km length consists of three ACSRconductors as shown O…

Q: A 0.5 Q resistance is required to be connected in parallel to a moving coil instrument whose full…

Q: A toaster oven is rated at 1100 W for operation at 120 V, 60 Hz. ▾ Part A What is the resistance of…

A: Given data : Rated Power of toaster oven P= 1100W Voltage of toaster oven V=120V

Q: Your answer The region in junction diode that (V=Vzk) is called---- Your answer

A: Bartleby has policy to solve only first question. So reupload the question

Q: 1-transfer function of DC Series motors (step by step) 2-block diagram of DC Series motors.

A: 63

Q: What the range of values of Vi that will maintain the Zener diode in the "on" state. R "L + 220 Ω P…

Q: What is the electric potential at 0.1 m away from a charge Q? Q=2.0 x 10-6 C k = Coulomb's constant…

A: Given: Charge, Q=2.0×10-6 C Distance from charge, r=0.1 m Coulombs constant, k=8.99×109 Nm2/C2

Q: The input of a Half-wave rectifier is V = 200 sin 40 t. If R₁ = 1K2, and forward resistance of the…

Q: 10. How to avoid DC signals to pass into output? O Using resistors on the output. O None of the…

A: The objective is to determine the correct option. Given: The signal is DC

Q: v= Ξ V = 10 V Ο 185 mA 46 mA Ο Ο 50 Ω R₁ 5ΩΣ R A B D

Q: Q2) A 220V, 50Hz, 6-pole 3-phase star-connected synchronous motor has a synchronous reactance 592…

A: Given information about a 3-phase star-connected synchronous motor is, Input voltage is Vt-line=220…

Q: Find the total capacitance in micro farads of the combination of capacitors shown in the figure…

A: Given: The circuit with the series parallel combination of the capacitance.

Q: 041 A single area consists of two generating units, unit 1 of 600 MVA with speed regulation of 6%…

A: GENERATOR : generator is a device used in electricity generation that transforms motive force…

Q: dy+ay(t) = Skx(t) The steady-state gain of the step response y(t) is 10 and the rise time is 4, what…

Q: For the circuit shown find the maximum and minimum values of zener diode current. 5 ΚΩ IL I 80-120 V…

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

A 6-pole alternator running at 1000 rpm, supplies an 8 pole induction motors. Find the actual speed of
the motor if the slip is 2.5%.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The maximum speed of an alternator working at 60 Hz is possible when the number of poles of the machine is ........ a. 4 b. 5 c. 3 d. 2
8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical power developed by the motor is ............ (i) 20 W (iii) 500 W (ii) 980 W (iv) 200 W
1. The operation of Commutator in DC Motor is * O a) to convert dc to ac O b) to convert ac to dc O c) to convert fixed dc to variable dc O reverse the current direction in the rotating windings each half turn
the field windings of a series motor has a resistance of 120 ohms at 15° c. after running for 2 hours, the resistance has increases to 140 ohms. if the temperature coefficient of the windings at 0°C is 0.004, find the new temperature of the windings
What is the freq. of a 10-pole alternator when running at 360 rpm? (b) At what speeds should a 6-pole alternator run to yield 25, 30, 50, and 60 cycles per second?
The winding of a 4-pole alternator having 36 slots and a coil span of 1 to 8 is short-pitched by ........... degrees. 150 40. 90 20 Brushless excitation system consisting of: Stator field winding and power diodes stator and rotor field winding and capacitor stator and rotor field winding and power diodes Everything mentioned in the options Full Name : *
A four-pole induction motor drives a load at 2478 rpm. This is to be accomplished by using an electronic converter to convert a 400-V dc source into a set of three-phase ac voltages. Part A Find the frequency required for the ac voltages assuming that the slip is 4 percent. The load requires 2 hp. Express your answer to three significant figures and include the appropriate units. f= Submit Part B Value I = HA Request Answer Submit If the dc-to-ac converter has a power efficiency of 90 percent and the motor has a power efficiency of 80 percent, estimate the current taken from the dc source. Express your answer to three significant figures and include the appropriate units. HÅ Value Units Request Answer ? Units ?
The rotor of a 220 –V 60 Hz, 4-pole induction motor has a power input of 80kW is observed that the rotor emf makes 90 cycles per minute. Calculate the rotor copper loss. (a). 2kW (b). 5kW (c). 3kW (d). 4kW
A four-pole induction motor drives a load at 2575 rpm. This is to be accomplished by using an electronic converter to convert a 400-V dc source into a set of three-phase ac voltages. ▾ Part A Find the frequency required for the ac voltages assuming that the slip is 4 percent. The load requires 2 hp. Express your answer to three significant figures and include the appropriate units. f= Submit ▾ Part B Value μÀ Submit I= Value Provide Feedback ^ Request Answer If the dc-to-ac converter has a power efficiency of 85 percent and the motor has a power efficiency of 80 percent, estimate the current taken from the dc source. Express your answer to three significant figures and include the appropriate units. 4 Ò Request Answer Units ? Units ?
The strength of the rotating magnetic field in a three phase induction motor is equal to times the flux produce ...... ....... in one of the phase windings. 1.25 1 O 1.5
Hello my friend, I need a summary of the power laws in a three-phase induction motor, listening to the same timbres on the next page
what is the conclusion for the concepts of rotating amature and rotating field in an alternator?