A 60 cycle current has a maximum value of 6.5A. What will be the instantaneous value of current at (a)0.0035 sec after the wave passes through zero in a positive direction (b)0.01153 sec after the wave passes through zero in a positive direction

Q: Ad.c. shunt generator runs at 400 r.p.m. and delivers 500 kW to busbars naving a constant voltage of...

A: Above question is based on DC generator, the major classification of DC generator are: Series gener...

Q: 2. Find the Mesh Currents in the given circuit:

A:

Q: Problem 1: Consider the circuit shown below. 2 A R. R, + 4 V - + -3 V - -1.5 A (1) R. (1) 3 A 12 V a...

A: Resistor The resistor is used to limit the flow of electric current. The resistor can absorb power f...

Q: Use Kirchhoff’s Law to find the power dissipated in the 5Ω resistor, determine the currents I1,I2,I3...

A: GIVEN: A circuit diagram                    R1=2ΩR2=5ΩR3=2ΩR4=20ΩR5=10Ω FIND:  the value of         ...

Q: . Determine the equivalent resistance between the terminals A and B 6.52 8.6612 132 ww

A:

Q: solve By Block Reduction

A:

Q: Problem 2. In a typical MOSFET structure with a p-Si body, the Drain/Body and Source/Body regions ar...

A: MOSFET-  Metal oxide semiconductor Field effect Transistor. It is basically a semiconductor transist...

Q: i, C, 2 µF 2 µF C2 10 μF e = 120 sin (10ʻt + 60°)

A: please find the solution in below image

Q: From the given network as shown, solve for current I3 using source transformation. Ans. 2.06 A

A: Given circuit is,  

Q: 1) Calculate lg.lc.lEAv.VCE And VCB

A: The DC analysis of the given circuit with and without capacitor will be same only the voltage gain w...

Q: i3

A: In KCL incoming currents in a node is equal to the outgoing currents.

Q: 2Ω 4Ω 3Ω 10V 5Ω 62 Vo 20V

A: The given circuit diagram is shown below:

Q: The circuit is composed of series parallel resistors with a voltage source. Compute for total resist...

A: The given circuit is shown below:

Q: A 952 range voltmeter is having an accuracy of + 0.84% of FSD. Calculate the following for the given...

A: Given: Range of voltmeter, V=952 V Accuracy, ±0.84% M1=857 VM2=912 V To find: (i) Range of acceptabl...

Q: Find the Energy and average power of the given signal.  And identify if it is power or energy signal...

A: Given Y(t)=1 for 0≤t≤1

Q: Q1/A-What is the total cost of using the following at 4c per kilowatthour? a) 600 W air conditioner ...

A: we have given  a) 600 W air conditioner for 8 h  b) 2800 W clothes dryer for 45 min c) 850 W coffee ...

Q: 12.a. Which test can be used to measure splice loss? A. Tensile measurement B. OTDR C. Bit error rat...

A: The portion of the optical power that does not pass through the splice and is radiated out of the fi...

Q: Silhcan 1kOhm Vout Vaut = %3D Silican 12V 1k Ohm VA = VB = Vc = Vo = D1 Silicon D2 Silicon 1 k Ohm 1...

A:

Q: 6.4 The SPST switch in the circuit of Fig. P6.4 opens at 1 = 0, after it had been closed for a long ...

A:

Q: In a dentist's office an X-ray of a tooth is taken using X-rays that have a frequency of 6.30 x 1018...

A: Dental X-rays are usually taken once a year. If your dentist is monitoring the progress of a dental ...

Q: 2. Find A, B, C, and ē if 40cos(100t - 40°) 20sin(100t + 170°) = Acos100t + Bsin100t = Ccos(100t + ¤...

A:

Q: 1. A wye connected load has a 5< 20° ohm impedance per phase and is connected across a 120 V three p...

A:

Q: At what frequency will the reactance of a 1.5µF capacitor equal the resistance of a 2kΩ resistor?

A:

Q: H3(s) H (S) R(s) + C(8) G3(s) G,(8) G2(s) H2(s) H¿(8) H4(S)

A:

Q: last four digits 4 3 2 { Your student IO → XX - -- fixed A = + 1| + 10 = 15 ニ Calaulate A ニ = Write ...

A: Let the complete student I'd is: 141332871

Q: 1211 – 512 – 413 = -24 -511 – 1812 – 6I3 = 112 -411 – 612 + 18I3 = –106

A:

Q: Find I, in the circuit. 20 150/20° V 30 ww

A:

Q: Four field coils, each with a resistance of 80 ohms, are connected in series and Supplied by a 240- ...

A:

Q: Question 8 Not yet answered Marked out of 1.00 P Flag question Obtain the differential equation of t...

A:

Q: 10. Naghsh-Jahan Generation owns three generating units that have the following cost functions: Unit...

A: The generation cost is minimum when the incremental fuel cost of all the units are equal i.e.  ∂CA∂P...

Q: へ97 7る? 4323 8. て 22 て

A: Mesh Analysis Mesh analysis is also called loop analysis. To determine unknown currents in the circu...

Q: A pure 20 mH inductor is connected to a 30 V, 50 Hz supply. Calculate the reactance

A:

Q: 1.35. Carefully sketch each signal described below. x[n] = {1, -1, 3, -2, 5} a. %3D | T[n] = (0.8)" ...

A:

Q: VoD carry out VDD sum B.

A: General examples: 

Q: Given a system y(t) = x²(t)-1, determine and prove (1) if it is linear or %3D nonlinear system? (2) ...

A:

Q: The resistance of 250 x 103 ft. of copper wire (pno - 10.36 (cmil-A)/ft.) is found to be 25.9 ohm, w...

A:

Q: Rc 100L Q1 RB RE 100 KA 150 L VEE lov Q: find IE ?

A:

Q: Two alternators working parallel supplying the following loads (1) lighting load of 600Kw (2) 900 KW...

A: Given: Two alternators working parallel supplying the following loads: (1) lighting load of 600 KW (...

Q: 5- a. Let x(t) = u(t + 2) – u(t - 4) sketch %3D

A: In this question we will draw signal y(t) with the help of x(t)...

Q: Consider the following circuit, the value of Ris 2 220V f=50HZ Draw the power triangle indicating re...

A:

Q: function in terms of R, C, and C,. R out

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: Example synchronous reactance of 0 + j20 2 per phase. A 500 kVA, 3-phase, 6.6 kV, star-connected sy ...

A: Given P=500 kVA V= 6.6 kV xs =20 ohm  

Q: 1. A Ge pn junction is doped with acceptor doping of 105 em and donor doping of 1015 em Assuming tha...

A: Given for a Ge p-n junction diode : Acceptor doping NA=1015 cm-3Donor doping ND=1018 cm-3Area, A=0.0...

Q: Given the circuit shown, Calculate the Peak Output Voltage. Express your answers in 2 decimal places...

A:

Q: R1 VR, Vr, R2 For the circuit shown above use Kircho's laws to compute the voltage VR, across resist...

A:

Q: How ring main distribution network is different than radial systems?

A:

Q: 1. Sketch Vo 20 V A si 3 V -20 V

A:

Q: Calculate the Apparent power (complex in VA), real power (real part in W) and reactive power (imagin...

A:         Let the current flowing through 40 Ω from top node to bottom node is I1 and the current flow...

Q: 13.31 There is no energy stored in the capacitors in the PSPICE circuit in Fig. P13.31 at the time t...

A:

Q: A) Can you use PN junction diode as Switch? If yes, exptain how? B) Filt in the blanks using MINORIT...

A: A) Yes we can use pn junction diode as switch.  In forward bias, diode behave as sort circuit i.e sw...

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.