A closed current path is made from two different circular arcs as shown in the figure below. The larger arc has radius 3.0 cm and covers one quarter of the circle, and the smaller arc has radius 1.0 cm and covers the remaining three quarters of the circle. If the current is 1.5 A going counterclockwise, what is the magnitude of the B-field at the center of the circular arcs? Express your answer to the nearest uT.

A closed current path is made from two different circular arcs as shown in the figure below. The larger arc has radius 3.0 cm and covers one quarter of the circle, and the smaller arc has radius 1.0 cm and covers the remaining three quarters of the circle. If the current is 1.5 A going counterclockwise, what is the magnitude of the B-field at the center of the circular arcs? Express your answer to the nearest uT.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A metal cube with sides of length a is moving at velocity v=voj across a uniform magnetic field B = Bok. The cube is oriented so that four of its edges are parallel to its direction of motion (i.e., the normal vector of two faces are parallel to the direction of motion). (Figure 1) Figure Bo N 1 of 1 Vo Part A Find E, the electric field inside the cube. Express the electric field in terms of vo, Bo, and unit vectors (i, j, and/or k). E = Submit Part B V ΑΣΦ -î Request Answer Now, instead of electrons, suppose that the free charges have positive charge q. Examples include "holes" in semiconductors and positive ions in liquids, each of which act as "conductors" for their free charges. www. J? If one replaces the conducting cube with one that has positive charge carriers, in what direction does the induced electric field point? Submit Request Answer
A wire 2 m long has a mass of 342 g. The wire is connected to an emf. What is the minimum current in the wire that would allow it to levitate above the ground in a magnetic field of magnitude1.9 T? To continue, please enter the result in units of A. Round your answer to 2 decimal places. Per previous question, what direction must the current flow?
Figure 1: CRT with coils in Helmholtz configuration. The hot cathode emits electrons which are then accelerated through potential difference Vacc. When the electrons enter the magnetic field B, which is perpendicular to their velocity, they move on a circular path with radius r. The magnetic field is due to coils in Helmholtz configuration (2 coils separated distance that equals their radius). The magnetic field due to one of the coils with radius R, at a point on the axis distance z away from the center of the coil, was found using the Biot-Savart law: HOIR?N B1 2(R2 + z2)ž
Force between Parallel Wires You have two wires with current running through them (see image below). The wires are a distance d apart. Current 1 = 3.25 A Current 2 = 2.85 A d = 0.370 m What is the force per length between the wires? Put your answer in μΝ microNewtons/m (· :). m If the force per length is repulsive, put in a negative sign. If the force per length is attractive, leave your answer positive. Your Answer: Answer Wire 1 Current 1 Wire 2 Current 2
Question 1. Plot a Graph with the data in Table 2, use Magnetic Force as the vertical axis and Current as the horizontal axis. Perform a linear least squares fit on the Graph, record the slope, intercept, and correlation coefficient in the Table 3. [Refer to Appendix 3_ Graphical Analysis of Experiment Results.docx]. Assume the horizontal copper trace on the Magnetic Force Board perfectly perpendicular to magnetic field, determine the magnitude of the magnetic field B, show your calculation in Table 3. Current (A) Table 2 0 0.25 0.5 0.75 1 -0.5 -1 Table 3 Mass of Magnet Assembly (gram) (Measured from scale) 0.000 0.039 0.080 0.122 0.162 -0.094 -0.222 Graph: Measure magnetic force versus Current Slope: Intercept: Correlation coefficient: Calculate magnetic field strength from the slope of your graph: Magnetic Force FB (Newton) 0 0.3822 0.784 1.1956 1.5876 -0.9212 -2.1756
Each of the wires in the figure carries a current of 1.0 A perpendicular to the page with the direction of current flow indicated. For the path shown (notice that an integration direction is specified), what is · d3? Express your answer in μT m, to at least one digit after the decimal point.
An electron in a cathode-ray tube is accelerated through a potential difference of 10 kV, then passes through the d = 1.8-cm-wide region of uniform magnetic field in the figure(Figure 1). Figure 1 of 1 d OV 10 kV
A metallic tube has inner radius a and outer radius b. A current I runs hrough the tube and is distributed uniformly on the cross-sectional area. Use Ampere's heorem to determine the magnetic field strength at all points. 2
B INSTRUCTION Solve the following problems. ANSWER ONLY TWO OUT OF THREE QUESTIONS. Show your complete solutions. NOT FOLLOWING OF INSTRUCTIONS will be a deduction of 10 POINTS from the total score. 1.A proton enters a magnetic tield of flux density 1.5 Wb/m² with a vetocity of 2.0 x 107 m/s at an angle of 30° with the field. Compute the force on the proton. 2.A steady current of 2 A in a coil of 400 turns causes a flux of 104 wb to link (pass through) the loops of the coil. Compute the average back emf induced in the coit it the current is stopped in 0.08 seconds. 3. A coil of 50 loops is pulled in 0.020 seconds from between the poles of a magnet, where its area intercepts a flux of 3.1 x 10-4 Wb, to a place where the intercepted flux is 0.10 x 10-4 Wb. Determine the average emf induced.
A long, cylindrical conductor of radius R carries a current I as shown in the figure below. The current density J, however, is not uniform over the cross section of the conductor but is a function of the radius according to J = 4br2, where b is a constant. Find an expression for the magnetic field magnitude B at the following distances, measured from the axis in part a and b. (Use the following variables as necessary: ?0, r1, r2, b, R.) Note: See image for the original question and figure
Criterion A: Knowing and understanding i. state scientific knowledge. (Max. 2 points) A wire loop is moved from outside the magnetic field until it is fully inside the magnetic field. The initial magnetic flux is 0 Wb, and the change in magnetic flux is 2.5 Wb. The magnetic field has a strength of 0.031 T. Calculate the area of the wire loop. The following equations may be useful: AP = D = BLA Round your answer to 3 significant figures. BA 2.5 Wb A 0.031 T A = m² || ||
paz For the current distribution given below. The cylinder radii are 2 cm and 3 cm. The current density at the inner cylinder, K= 10 A/m with an angle 0=30°, and the current K2= 5 A/m at the outer cylinder, calculate a. The magnetic field in points a (at radius 1 cm), b (at radius 2.5 cm), and c (at radius 4 cm). b. What is the force acting on the inner and outer surfaces of the inner cylinder? c. Calculate the energy per length inside the cylinder