A closed surface with dimensions a=b%3D0.40 m and c=0.60 m is located as in the figure below. The left edge of the closed surface is located at position x= a. The electric field in the region is non-uniform and is given by E=(3.0+ 57x2 ) i N/C, where x is in meters. Calculate the net electric flux leaving the closed surface?

A closed surface with dimensions a=b%3D0.40 m and c=0.60 m is located as in the figure below. The left edge of the closed surface is located at position x= a. The electric field in the region is non-uniform and is given by E=(3.0+ 57x2 ) i N/C, where x is in meters. Calculate the net electric flux leaving the closed surface?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter25: Gauss’s Law

Section: Chapter Questions

Problem 20PQ

See similar textbooks

Similar questions

A thick insulating cylindircal shell of inner radius a=2.8R and outer radius b=5.3R has a uniform charge density p. b What is the magnitude of the electric field at r=9 R ? Express your answer using one decimal place in units of pR :? €0
Two 1.20m nonconducting wires form a right angle. One segment has charge q1=4.0 nC uniformly distributed along its length, the other segment has charge q2 = –6.0 nC uniformly distributed along its length. Point P lies on the central axis of each wire and is 60.0 cm apart. a. The horizontal component of the net electric field at point P is:______N/C. in i or -i. b. The vertical component of the net electric field at point P is:______ N/C. in j or -j. c. The magnitude of the net electric field at point P is:______N/C. d.its direction measured with respect to the x-axis is:_____.
The figure shows two concentric rings, of radii R and R-2.61R, that lie on the same plane. Point Plies on the central z axis, at distance D-2.60R from the center of the rings. The smaller ring has uniformly distributed charge Q-5.00 10° C. What is the uniformly distributed charge on the larger ring if the net electric field at Pis zero? D
H A very long line of a thin conducting wire produces a radial outward electric field of magnitude 2.24 kN/C at a radial distance of 45.1 cm. How much charge (in nC) is contained in a 5.52-m long length of this wire?
I| An early model of the atom, proposed by Rutherford after his discovery of the atomic nucleus, had a positive point charge +Ze (the nucleus) at the center of a sphere of radius R with uniformly distributed negative charge -Ze. Z is the atomic number, the number of protons in the nucleus and the number of electrons in the negative sphere. a. Show that the electric field inside this atom is Ze 1 Ein 4πο R3 b. What is E at the surface of the atom? Is this the expected value? Explain. c. A uranium atom has Z = 92 and R = 0.10 nm. What is the electric field strength at r =R?
The figure shows two parallel nonconducting rings with their central axes along a common line. Ring 1 has uniform charge 9₁ and radius R; ring 2 has uniform charge 92 and the same radius R. The rings are separated by a distance 3.00R. The ratio of the electric field magnitudes of Ring 1 and Ring 2 at point P on the common line is 3.46. What is the ratio of charge magnitudes 91/92? nber i Ring 1 91 O Ring 2 R 92 Units No units
The figure shows two concentric rings, of radii R and R' = distance D = 2.18R from the center of the rings. The smaller ring has uniformly distributed charge Q = 5.31 × 106 C. What is the 3.53R, that lie on the same plane. Point Plies on the central z axis, at uniformly distributed charge on the larger ring if the net electric field at P is zero? D Number i Units
If the curved rod in the figure below has a uniformly distributed charge Q = 39.5 nC, radius R = 0.795 m, and p = 63.0°, what is the magnitude of the electric field at point A? N/C R A
An electric field has a uniform value (doesn't change with position) that can be described by the following equation: E = (Aĵ + B k) N/C where A and B are given by the values below. A = 1.35 B = 1.80 There is a flat circular surface that is in the x-y plane and centered at the origin point (0,0,0). This surface has a radius of 1.65 m. Calculate the magnitude of the electric flux through the surface due to the electric field described above. Your units should be Nm²/C.
At a point on a conducting surface, E = 30a, - 40a, + 20a, mV/m. Calculate the surface charge density at that point.
A thin, horizontal, 14-cm-diameter copper plate is charged to -2.8 nC. Assume that the electrons are uniformly distributed on the surface Part A What is the strength of the electric field 0.1 mm above the center of the top surface of the plate?
Two homogeneous rods with a length of 5 cm each are positioned as in Fig. a. Determine the magnitude and direction of the electric field vector at point P on the coordinates (5.0) cm, if the unit charge density is λ = 2.10-9 C / m! b. If an electron is placed at point P, what is the electric force that is experienced by the electron?