A cylinder with a frictionless, movable piston like that shown in the figure, contains a quantity of helium gas. Initially the gas is at a pressure of 1.00×105Pa, has a temperature of 300K, and occupies a volume of 1.50L. The gas then undergoes two processes. In the first, the gas is heated and the piston is allowed to move to keep the temperature equal to 300K. This continues until the pressure reaches 2.50×104Pa. In the second process, the gas is compressed at constant pressure until it returns to its original volume of 1.50L. Assume that the gas may be treated as ideal.   a. Find the temperature of the gas at the end of the second process. b. Find the total work done by the gas in the first process. c. Find the total work done by the gas in the second process.

Q: The p-V diagram in the figure shows two paths along which a sample of gas can be taken from state a…

A: Introduction: It is known that the internal energy of a system is a point function i.e. it depends…

Q: An ideal gas is compressed from a volume of V, = 5.50 L to a volume of V, = 3.00 L while in thermal…

A:

Q: A cylinder with a moveable piston on top, free to move up and down, contains one mole of an ideal…

A:

Q: One mole of oxygen gas is at a pressure of 6.75 atm and a temperature of 28.5°C

A:

Q: An ideal monatomic gas is contained in a vessel of constant volume 0.450 m3. The initial temperature…

A:

Q: A sample of an ideal gas is compressed and cooled as it is taken from state 1 to state 2. The given…

A: The given values are listed below. P1=94 kPaV1=0.05 m3V2=0.04 m3T1=300 KT2=260 K

Q: In ideal gas initially at 328ﾟC occupies a volume of 30 cm^3 at pressure 3.0 atm. It then expands to…

A: Ideal gas equation is PVT= constant                                                   .......(1)…

Q: Suppose that an ideal gas in a sealed metal container (so it has a fixed volume) has its temperature…

A: Consider the initial temperature of the gas is T1 and the initial pressure of the gas is P1. The…

Q: A gas expands by 1.2 L at a constant pressure of 2.5x105 Pa. During expansion 230 J of heat is…

A:

Q: common pressure and temperature assuming no heat loss in the containers and the surrounding of the…

A: An adiabatic process is defined as the thermodynamic process in which there is no exchange of heat…

Q: A cylinder with a frictionless, movable piston like that shown in the figure, contains a quantity of…

A: For the first part the temperature T is kept constant.Hence, using Boyle’s law according to which,

Q: The p-V diagram in the figure shows two paths along which a sample of gas can be taken from state a…

A:

Q: V. Th To V Room temperature T 293 K Vp The temperature changes from Th to To during process 3. The…

A: work done in thermodynamic process W = ∫ P dV

Q: Suppose that an ideal gas in a sealed metal container (so it has a fixed volume) has its temperature…

A: Given data:  An ideal gas The volume of gas is fixed New temperature (T2) = 4.80 × T1 Required: The…

Q: A 2500 cm3 container holds 0.15 mol of helium gas at 330 ∘C. How much work must be done to compress…

A: Given: Volume of container V = 2500 cm3. moles of helium n = 0.15 mol. Temperature of helium gas T =…

Q: Consider a pressure versus volume graph, where the different curves represent different processes…

A:

Q: One mole of an ideal gas initially at a temperature of Ti = 3.4°C undergoes an expansion at a…

A:

Q: The pV diagram in the figure (Figure 1) shows a process abc involving 0.350 mol of an ideal gas.…

A: Let Pa, Pb and Pc are the value of pressure, Va, Vb and Vc are the value of volume and Ta, Tb and Tc…

Q: A cylinder with a piston has some ideal gas inside. The piston is pushed inward to compress the gas…

A: Its a concept of adibatic process.

Q: The graph in Figure 1.1 shows one mole of monoatomic gas at initial temperature of 40 ˚C and volume…

A: i) Pressure P=2.5×105 Pa V1=2 LV2=5 L Workdone in the isobaric process  WAB=P(V2-V1)…

Q: An ideal gas in a container exerts a pressure of 100Pa while its volume increases by 0.2m^3. Its…

A:

Q: An ideal gas in a closed container of constant volume is warmed until its pressure doubles. The gas…

A: SOlution: given that P1 = P P2 = 2P T1 = 100 C

Q: In the first of two processes that a gas undergoes, the volume remains constant at 0.16 m3 and the…

A:

Q: 3.5 mol of monatomic gas A interacts with 3.0 mol of monatomic gas B. Gas A initially has 8900 J of…

A: given Number of moles mono atomic gas A ,   nA =  3.5 mol Number of moles mono atomic gas B ,   n B…

Q: One mole of an ideal gas initially at a temperature of Ti = 0°C undergoes an expansion at a constant…

A: (a). from the ideal gas equation, the new temperature of the gas is

Q: If I add 11664 J of energy to an ideal gas inside a balloon, causing the internal energy to increase…

A: Write the given values with the suitable variables. Q=11664 JΔU=7278 J Here, Q and ΔU are the amount…

Q: Consider a pressure versus volume graph, where the different curves represent different processes…

A:

Q: 1. A gas fills the right portion of a horizontal cylinder whose radius is 5.30 cm. The initial…

A: Given: The radius of the cylinder is r=5.30 cm. The initial pressure of the gas is P1=1.01X105 The…

Q: 2.Three moles of an ideal monatomic gas expand at a constant pressure of 2.50 atm; the volume of the…

A:

Q: If I add 12,183 J of energy to an ideal gas inside a balloon causing the internal energy to increase…

A: Given data: Q=12183 J∆U=5185 JNeed to determine the work is done on the environment by the gas as…

Q: A cylinder with a cross-sectional area of 0.035 m2 is fitted with a piston that is free to move up…

A:

Q: A tank contains one mole of nitrogen gas at a pressure of 5.20 atm and a temperature of 24.5°C. The…

A: Given data: Pressure, P=5.20 atm Temperature, T1=24.50C=24.5+273 K=297.5 K

Q: A gas is confined in a thermally insulated cylinder as shown in the figure below. The gas is…

A:

Q: In the figure, container A holds an ideal gas at a pressure of 4.26 x 105 Pa and a temperature of…

A: We need to find the final common pressure of the two given containers.

Q: cylinder with a diameter of 5.64 cm has a movable piston attached to a spring as shown in Figure…

A: Given Diameter of cylinder d = 5.64 cm = 5.64 × 10-2 m Initial volume V1  = 1.32 L Initial pressure…

Q: A frictionless gas-filled cylinder is fitted with a movable piston, as the drawing below shows. The…

A: Introduction: Ideal gas law: Ideal gas law states that the volume of a given amount of gas is…

Q: 2.5 mol of monatomic gas A initially has 5000 J of thermal energy. it interacts with 3 mol of…

A:

Q: A cylinder in a car engine takes V1 = 0.045 m3 of air into the chamber at 300 C and at 1 atm…

A: Given: Initial temperature, T1=30ᵒC Initial Pressure, P1=1 atm Then pressure after compression,…

Q: A 33 -mol sample of hydrogen gas is heated at constant pressure from 153 K to 308 K. Calculate the…

A: Given data: no. of moles of sample of hydrogen, n = 33 mol Change in temperature, ∆T = 308 K - 153 K…

Q: In a cylinder sealed with a piston, you rapidly compress 3.50 L of N2 gas initially at 1.00…

A: Given that the final volume of the gas is half of its original volume.

Q: An ideal monatomic gas is contained in a vessel of constant volume 0.220 m3. The initial temperature…

A:

Q: A container (8.0 L = 8.0 x10-3 m3) has an ideal gas 2 mol. The initial temperature of the container…

A: Given information:Initial volume of the gas (V1) = 8 L = 8 × 10-3 m3Number of moles of gas (n) = 2…

Q: 0.75 m3 container of an ideal gas at atmospheric pressure is at a temperature of 40 oC and contains…

A:

Q: A cube 19 cm on each side contains 4.0 g of helium at 20*C. 1000 J of heat energy are transferred to…

A: Given Side length of cube = 19 cm Mass of helium = 4.0 g Initial temperature of helium = 20 °C  Heat…

Q: In the figure, container A holds an ideal gas at a pressure of 4.26 x 105 Pa and a temperature of…

A:

Ideal Gas Law

Ideal gas law states that the product of pressure and volume of a gas directly varies with the product of the number of moles, the universal gas constant, and the temperature of the gas.