A dam on a river is built so that the wall facing the water is shaped like the region above the curve y = 0.52 and below the line y = 280. (Here, distances are measured in meters.) The water level is 40 meters below the top of the dam. Find the force (in Newtons) exerted on the dam by water pressure. kg (Water has a density of 1000- m m3 and the acceleration of gravity is 9.8- :) sec²

A dam on a river is built so that the wall facing the water is shaped like the region above the curve y = 0.52 and below the line y = 280. (Here, distances are measured in meters.) The water level is 40 meters below the top of the dam. Find the force (in Newtons) exerted on the dam by water pressure. kg (Water has a density of 1000- m m3 and the acceleration of gravity is 9.8- :) sec²

Name: A dam on a river is built so that the wall facing the water is shaped
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: A dam on a river is built so that the wall facing the water is shaped like the region above the curvey = 0.52 and below the line y = 280. (Here, distances are measured in meters.) The water level is 40meters below the top of the dam. Find the force

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Note: In the text, all questions use 62.5 pounds/ft as the force per volume density of water. In metric, we would need Newtons/meter. The mass density per volume of water is 1000 kg/m³. To convert this into a force density per volume, we multiply by gravity, approximately 9.8 m/s?. The resulting quantity is the force density per volume in metric: 9800 N/m³.
Find the fluid force (in newtons) on the vertical plate submerged in water, where the dimensions are given in meters and the weight-density of water is 9,800 newtons per cubic meter. square X newtons
The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the region above the curve y 0.4x2 and below the line y : 240. (Here, distances are measured in meters.) The water level is 32 meters below the top of the dam. Find the force (in Newtons) exerted on the dam by kg m water pressure. (Water has a density of 1000- and the acceleration of gravity is 9.8- .) m3 sec?
1- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its bottom edge is hinged as shown in Fig. What force P is needed to just open the gate and its Water location? Hinge 45° 2- A tank containing water is shown in Fig. E Calculate the total resultant force acting on side ABCD of the container and the 6 ft location of the center of pressure. Y = 62.4 Ib/ft3 Water 8 ft B -20 ft
The flat surface shown is submerged vertically in water. Find the fluid force against the surface. The weight density of water is 9810 N/m. 6m 5m 8m Enter the exact answer. F = %3D
The flat surface shown is submerged vertically in water. Find the fluid force against the surface. The weight density of water is 62.4lb/ft'. -8 ft 8 ft 8 ft Enter the exact answer. F = i lb
1- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its bottom edge is hinged as shown Water in Fig. What force P is needed to just open the gate and its location? Hinge 45° 2- A tank containing water is shown in Fig. E Calculate the total resultant force acting on side ABCD of the container and the 6 ft location of the center of pressure. y = 62.4 Ib/ft3 Water -20 ft
The plate R in the figure below, bounded by the parabola y = x2 and y = 1, is submerged vertically in water (distance in meters). Calculate the fluid force F on a side of R. (The density of water is p = 103 kg/m3 and the gravitational acceleration g is 9.8 m/s2. Round your answer to two decimal places.) F = N y Water Surface 1-y fy) Vy, y) R y = x²
In a hydraulic system, the power is measured as 31.9 X 10-2 Kilo joules per seconds and pressure is given 134.7 x10-3 N/m2 .Find the pressure of the hydraulic system in pascals. Answer
The figure below shows the cross-section of a tank full of water under pressure. The pressure in the tank is 19.62 kN m² and its length is 2 m in the paper. An empty cylinder lies along the length of the tank on one of its corner as shown. Find the resultant force acting on the curved surface ABC. 19.62 kNm R-1m 1.5m Tank fal of water
1- A 60 cm square gate has its top edge 12 m below the water surface. It is on a 45 angle and its bottom edge is hinged as shown in Fig. What force P is needed to just open the gate and its Water location? Hinge 2- A tank containing water is shown in Fig. Calculate the total resultant force acting on side ABCD of the container and the location of the center of pressure. y = 62.4 Ib/ft3 Water -20 ft 3- Find the total pressure and position of center of pressure FREE WATER SURFACE on a triangular plate of base 2 m and height 3 m which is immersed in water in such a way that the plane of the plate makes an angle of 60 with the free surface of the water. The base of the plate is parallel to water surface and at a depth of 2.5 m from water surface. 4- The 200 kg, 5 m wide rectangular gate shown in Figure 05m is hinged at B and leans against the floor at A making an Water angle of 45° with the horizontal. The gate is to be opened 3m from its lower edge by applying a normal force at its…
Find the discharge of water in liters / second in a pipe of diameter 20 cm with the velocity of 4.5 m/s. (ENTER ONLY THE VALUE IN THE BOXES BY REFERRING THE UNIT GIVEN IN BRACKET) The discharge of water through pipe is (Lit/sec) = Which of the following is the dimension of capillary depression O M'L1 T° O M° L' T° O M'L-1 TO M° L-2 TO The viscosity of Hydrogen gas increases when we heat it. Select one: O True O False