An overexcited 2300-V, 3-phase, wye-connected synchronous motor runs at a power angle of 21 degree.The per-phase synchronous impedance is 0.1 + J2 ohm. If the motor takes a line current of 350 A.A) Find the power factorB) if the internal induced voltage is the same as the line voltage at the power angle 20 degrees, find thepower factor and the line current of the motorC) In part b) find the developed power of this motor

Answered: Image /qna-images/answer/7389f464-d12a-4982-b934-4a2d427851cb.jpg

A) Find the power factor B) if the internal induced voltage is the same as the line voltage at the power angle 20 degrees, find the power factor and the line current of the motor C) In part b) find the developed power of this motor

A) Find the power factor B) if the internal induced voltage is the same as the line voltage at the power angle 20 degrees, find the power factor and the line current of the motor C) In part b) find the developed power of this motor

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125 kVA, 3-f, 240 V, 60 Hz, 1800 rpm). The load of alternator A is 70 kW at 85% pf leading and the load of alternator B is 85 kW at 75% pf leading. Determine the pf of load.
Draw a complete equivalent circuit of one phase only of a synchronous generator. Then draw the phasor diagram for a unity power factor. Assume the phase resistance is ignored
In a Three-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. Subject: Electrical engineering
A 3-phase, 16 pole alternator has a star connected winding with 144 slot and 10 conductor per slot. The flux per pole is 30 mWb sinusoidally distributed and the speed is 375 rpm. The frequency of generated emf is? Also find, the line emf is?
A single-phase synchronous generator has a rated output of 500 kVA at a terminal voltage of 3300 V. The stator winding has a resistance of 0.6 ohms and a synchronous reactance of 4.0ohms. Calculate the percentage voltage regulation at a power factor of 0.8 lagging. Sketch the phasor diagram.
A three-phase star-connected alternator delivers at rated load a current I = 200 A under a voltage of 5 kV-50 Hz (between phases). The load is inductive of power factor equal to 0.87, the resistance of each stator winding is 0.292 and the speed of the rotor is n = 750 r.p.m. The sum of the constants losses and the stator Joule's losses and the rotor Joule's losses is 55 kW. The no load test, at rated frequency, gave: E-4200 V (between phases) for an excitation current lexc = 40 A. The short-circuit test, for an excitation current lexc = 40 A, gave a short-circuit current in the stator windings Ise =2.5 kA. 1- Calculate the numbers of poles of the alternator. 2- Calculate the synchronous reactance (X). 3- Calculate the electromotive force of the alternator (E) between phases for the same excitation current. 4- Calculate the power absorbed by the alternator (Pa).
65. A three-phase, 440 V, 60 Hz supply is connected to a three-phase, wye-connected induction motor and synchronous motor. The impedance per phase of the induction motor is (1.5 + j2.5)N. The synchronous motor is over-excited and draws 100 A at 0.8 power factor. What is the combined power factor of the load? A. 0.99 lagging B. 0.99 leading C. 0.51 lagging D. 0.51 leading
A 3-phase generator possesses a synchronous reactance of 60 and the excitation (induced) voltage Eo is 3 KV per phase. Calculate line-to-neutral voltage E for a resistive load of 82 and draw the phasor diagram.
Two identical three – phase Y – connected alternator A and B share equally a load of 10MW at 33kV and 80% lagging pf. The synchronous reactance of each machine is 4 ohms per phase and thew armature resistance is negligible. Alternator A has its filed excitation adjusted to carry 125 A lagging current, what is the current supplied by alternator B? a. 96 A b. 97 A b. 98 A d. 95 A
A three-phase 3300V. 50 Hz star-connected alternator has an effective resistance of 0.5 ohm/phase. A field current to of 30A produces full-load current of 180A on short- circit and a line to line emf of 1000V on open circit Determine(i) the power angle of the alternator when it delivers full-load at 0.8p.f(lag) (ii)the SCR of the alternator D
two synchronous generators are connected in parallel, feeding a load together. the frequency of the first generator in the no-load State is 52 Hz and the slope of the characteristic is 1 MW/Hz. the total power of the load fed by these two generators is 2.5 MW and the power coefficient is 0.6 inductive. by drawing the characteristic curve of the system;a) what is the frequency of the system when the load in question is fed, and how do the two generators share the load between themselvesb) if a load of 0.5 MW is added to the system, find the operating frequency of the new system and the powers given by each generatorc) if a second load of 0.5 MW is connected to the system, the idle operating frequency of the second generator is increased by 0.5 Hz, what happens to the operating frequency of the system and the power values given by the generators
b) Two alternators are connected in parallel to feed a load together. The no-load frequency of the first alternator is 51.5 Hz and its slope is 1MW / Hz. The no-load frequency of the second alternator is 51.0 Hz and its slope is 1MW / Hz. The total power of the load fed by these two alternators is 2.5MW and the power factor is 0.8. Accordingly, at what frequency does this system work and what are the power values transferred to the load by each alternator.