Answered: A hydraulic turbine turning at 100…

A hydraulic turbine turning at 100 r/min is coupled to a synchronous generator. If the induced voltage has a frequency of 50 Hz, then how many poles does the rotor have?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter39: Synchronous Motor Operation

Section: Chapter Questions

Problem 14SQ: Induction motors and welding transformers require magnetizing current, which causes a. lagging power...

See similar textbooks

Related questions

Q: i. Let x[n] = {1,2,5,-1}. Generate x[2n] and various interpolated versions of x[n/3] ⇓ ii. Let x[n]…

A: Given: Various discrete time signals. In all parts, we have to perform some type of transformation…

Q: LT of the given function

A: In this case, the Laplace transform of the given function is to be determined.

Q: . Determine the value of h(0)

Q: A series RLC circuit has a resistance of 7.5 , a capacitance of 10-2 F, an inductance of 1/6 H, and…

Q: QUESTION 11 Nodal analysis (CLO 4) The value of Vo in the following electric circuit equals: +1 Vo…

A: Given circuit,

Q: Four resistances are connected in shunt against 110 V supply. The resistance are such that R1>R2,…

Q: Find the size of the C-filter in an FWR needed to keep ripple values within 3%; the circuit is…

Q: If the absorption coefficient of silicon is 0.05 pm-1 at 860 nm, find the penetration depth at which…

Q: Do the following conversion problem: Calculate the binary equivalent of 2/3 out to eight places.…

A: It is given that: 2310

Q: oduct of resistance and capacitance (RxC) in a passive high pass filter circuit as shown in Figure…

Q: 4_ For the system shown in figure N°4, find the percentage overshoot, the settling time, the peak…

A: The natural frequency and damping factor can be calculated by using the closed loop transfer…

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

Q: The voltage drop across the R3 lamp is? 40 60 90 30

A: Given circuit,

Q: In the figure, these three resistors are connected to a voltage R, source so that R2 = 5.5 N and R3…

A: The required parameters can be calculated by using resistor reduction techniques and by using the…

Q: QUESTION FOUR A single-phase 1kVA, 440/110V, 50 Hz transformer has the following equivalent circuit…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: What is the commutator pitch of a 4-pole, duplex wave-wound armature having 120 commutator bars?

A: Given: A duplex 4 pole duplex wave-wound armature has 120 commutator bars.

Q: In a parallel circuit, ET = 120 V, R = 1500 $2, and XL 1000 2. What is the apparent power? M O a.…

A: Answer: a. 17.32VA Explanation: a.

Q: Of the following test, which is the most valid for checking a diode?

A: Ohmmeter Mode (or Resistance Mode)- a forward and reverse resistance check with an ohmmeter d is…

Q: U₂ (1) C * R Op-amp vo (1) •Find vo(t) if vi(t)=In(2t)sin(2t) mV.

Q: Which of the following integrals correctly solve for the magnetic flux passing through the surface…

Q: Two bidirectionally infinite line charges exist in vacuum. One has a charge density of -5 nC/m at x…

A: Given data: First charge density λ=-5 nC/m =-5×10-9 C/m Located point x = 0 , y = -6 Second…

Q: 14.3.6 - What field is sent in period 8 of an I2C message? ACK The read/write bit The STOP condition…

Q: To access the services of the operating system, the interface is provided by the

A: The correct option along with the explanation is provided in the following section.

Q: A4 A Zener regulator shown in Fig. A4. The source resistor Rs = 10092 and the Zener voltage V₂ =…

Q: 7. The ability of material to oppose the flow of electrons? a. current b. voltage c. resistance d.…

A: Given data: 10 LEDs, each LED has 2 volts forward voltage drop. Once these LEDs are connected in…

Q: 3_ For the system shown in Figure 3, first find the values of K1 and K2 to obtain a peak time of 1…

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

A: 13. Given data, Terminal voltage V = 200 V Field resistance Rf=200 Ω Field current will be equal to,…

Q: a) A balanced A-connected 3-phase load of 20 2 is supplied from 500 V/60 Hz mains supply. The load…

A: Given, A balanced delta connected 3-phase load of 20 ohm is supplied from 500 V/60 Hz mains.

Q: 2. You should measure DC power dissipated in a resistive load indirectly using a DC voltmeter and…

A: Given- Voltage reading= 10V Current reading= 1 A Voltage error=±0.4 V Current error= ±0.08 A To…

Q: R₁ R₂ Answer: R3 Quiz 3 - Q1CQ Given: R₁ = 14372 (Ohms) R₂ = 76172 (Ohms) R3 = 6227 2 (Ohms) Find…

A: Given circuit: R1=1437 ΩR2=7617 ΩR3=6227 Ω

Q: Using sum-by-column method, solve the following problem: a) An finite impulse response (FIR) filter…

Q: What should be the power of the voltage supply that we will use in velocity selector region?

A: Velocity Selector Region:- A zone with a constant magnetic and electric field is known as the…

Q: A given shunt generator delivers 430 A at 240 V and the resistance of the shunt field and armature…

A: Given a shunt generator delivers, Load current, IL=430 A Supply voltage, Vs=240 V Shunt field…

Q: How the sensors communicate with each other and to the edge devices using SPI and I2C Communication…

A: IoT (Internet of Things):- The Internet of Things (IoT) networks, which are highly connected…

Q: Find the operating frequency of the transistor of a Colpitts oscillator if C₁ = 0.001 μF, C₂ = 0.01…

A: We have an Transistor of a colpitts oscillator with, C1 = 0.001 μF = 0.001 * 10-6 C2 = 0.01 μF =…

Q: Write an HDL dataflow description of the logic circuit described by the Boolean function in Problem…

A: Given data: boolean function with a 4×1 multfluxer and externals gates a).…

Q: vo resistors R₁ and R₂ (where R₁ = R₂) are connected in series to an ideal battery. Which of the…

A: The total resistance= R1+R2 = 2R1=2R2 The total resistance is…

Q: Design a circuit with an op amp that provides a gain of 7.5 having a Rin resistor of 12k2. What…

Q: la = ? IB = ? Ic=? E1 = 14.00 V E2 = 12.00 V R1 = 0.100 2 R2 = 0.0100 2 R3 = 1.20 2 Ic IB IA R3 m R₂…

Q: find the indicated resultant.

Q: A- Find £{f(x)} for the square wave shown in the following figure. f(x) 1 2 5 6 7

Q: B) Show that the system shown in Figure (3) is equivalent to

Q: In a parallel circuit, ET = 120 V, R = 1500 $2, and XL 1000 2. What is the apparent power? O a.…

A: Given: In a parallel circuit, ET=120 VR=1500 ΩXL=1000 Ω

Q: : A conductor of 2 m length moves with a uniform velocity of 1.27 m/sec under a magnetic field…

A: We have been asked to find magnitude of induced e.m.f. if a conductor moves under a magnetic field…

Q: 1. Solve the circuits below. Vs b) Vs www R1 ww R2 ww R2 Load R₁ R₂ Total Load R₁ R₂ R3 Total…

Q: Determine the total power consumption of the total circuit if Vs=20V, R1 and R2 are 15ohms, R3 is…

A: Given, The values of resistors are take as below mentioned data, VS=20 VR1=15 ΩR1=15 ΩR3=20 ΩR4=50…

Q: A 2-pole wave wound dc generator has 120 conductors in each parallel path of its armature. If it is…

A: For wave wound Number of parallel paths is equal to number of poles So A =2 Emf equation will be…

Q: how to solve complex equations for impedences. How do I do the algebra for (j15.08)*10/ (j15.08+10).…

Q: An annoying thing about CMOS is that it is naturally inverting so if you wanted to implement a…

A: Given that CMOS has the unpleasant tendency to invert automatically in this situation if we wished…

Concept explainers

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.

Question

A hydraulic turbine turning at 100 r/min is coupled to a synchronous generator. If the induced voltage has a frequency of 50 Hz, then how many poles does the rotor have?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Winding and Construction of the Rotor and Stator

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Varying the DC voltage to the rotor field changes the a. motor speed. b. power factor. c. phase excitation. d. slip.
A basic one-loop dc generator is rotated at 60 rps. How many times each second does the dc output voltage peak (reach a maximum)?
A small 4-pole generator with a six-turn rotor coil generates the following voltage wave: e = 169.706 sin(40t). Determine the (i) Maximum pole flux (in weber) and (ii) The frequency of the induced voltage (in Hz)
A 6 pole DC wave wound generator has 30 armature conductors with flux per pole is 25 mWb and the e.m.f generated is 79 V, then the speed of the machine is O 105.33 rps O 5.06 rps 0.51 rps O 35.11 rps
A separately excited dc generator generates 230 V when driven at 1200 rpm of the field flux is decreased by 10%. What is the new emf with speed remains the same.
In DC machines the number of parallel paths for a wave winding generator is Select one: O a. Three O b. Two OC. Half the number of poles O d. Equal to Number of Poles
To change the direction of rotation of a series wound DC generator the general rule is to
In a synchronous generator, a DC current is applied to the rotor windingList two advantages of this arrangement.
Electrical Machines A 4-pole single-phase induction motor is rotating in a clockwise direction at a speed of 1000 rpm having a voltage of 100 V with a frequency of 50 Hz. At a standstill, if the rotor resistance is 1.70, then in the backward branch what will be the effective resistance?
Due to the presence of two rotating magnetic fields force the three phase induction motor is self starting Select one: O True O False
An 8-pole,3-phase induction motor has a frequency of 50Hz and that in the rotor is 1.5Hz, at what speed is the motor running? What is the slip?
estion The generated voltage per phase of an alternator is E0 while the speed of rotor rotation is 3000 rpm. On changing the rotor speed to 750 rpm, the generated emf phase will become O a. 0.25*EO O b. 0.5*EO O c. 0.75*EO O d. EO