A refrigerant of a certain thermodynamic cycle at a point during the evaporation process where its fraction dryness is 50%, and latent heat of 211.3 kJ/kg. Determine the enthalpy of this refrigerant at this point knowing that its saturated liquid enthalpy is 190.7 kJ/kg

A refrigerant of a certain thermodynamic cycle at a point during the evaporation process where its fraction dryness is 50%, and latent heat of 211.3 kJ/kg. Determine the enthalpy of this refrigerant at this point knowing that its saturated liquid enthalpy is 190.7 kJ/kg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In an air-conditioning unit 3.5 m3/s of air at 32 C dry-bulb temperature, 50 percentrelative humidity, and standard atmospheric pressure enters the unit. The leavingcondition of the air is 18 C dry-bulb temperature and 90 percent relative humdity.Using properties from the psychrometric chart, (a) calculate the refrigeratingcapacity in kilowatts and (b) determine the rate of water removal from the air
In an air-conditioning unit 3.5 m3/s of air at 28 C dry-bulb temperature, 50 percent relative humidity, and standard atmospheric pressure enters the unit. The leaving condition of the air is 14 C dry-bulb temperature and 90 percent relative humdity. Using properties from the psychrometric chart, (a) calculate the refrigeratingcapacity in kilowatts and (b) determine the rate of water removal from the air
A 2.99 kg of air at 24.24 C underwent an isentropic process wherein its initial pressure of 52.1 kPa was doubled. Determine the change in enthalpy (kJ) of the system. Consider the individual gas constant, specific heat at constant pressure, and specific heat ratio of air as 0.287 kJ/kg-K, 1.00 kJ/kg-K, and 1.4 respectively. Do not round off the final answer.
السؤال الثالث The thermodynamic properties of refrigerant R22 mixture of liquid and vapor leaving the expansion device and entering the evaporator are: pressure of 498 KPa, temperature of 0 °C, fraction dryness (x) of 0.238, saturated liquid enthalpy of 200 kJ/kg, and saturated vapour enthalpy of 405 kJ/kg. The pressure of this refrigerant at the entrance of the condenser is measured to be 19.3 bar After the subcooling process, the enthalpy in (kJ/kg) and the pressure in (MPa) of this refrigerant have been measured and were found to be 199 47 kJ/kg and 2.3 MPa. 239. 68 kJ/kg and 1.96 MPAO 248.79 kU/kg and 1.93 MPa 110 52 kJ/kg and 3.1 MPa 1:29 PM 91°F Sunny 5/14/2022
Atmospheric air at 1 atm, 32°C, and 95 percent relative humidity is cooled to 24°C and 60 percent relative humidity at a rate of 20 m³/min as shown in Figure Q2. A simple ideal vapor-compression refrigeration system using refrigerant-134a as the working fluid with 0.05kg/s mass flow rate, is used to provide the cooling required. It operates its evaporator at 4°C and its condenser at a saturation temperature of 39.4°C. The condenser rejects its heat to the atmospheric air. Calculate: a. the amount of water, in kg/kg dry air, removed from the air, b. the rate of heat removed from the air, in kJ/kg dry air, c. the rate of heat rejected at the condenser, d. sketch the process on the psychrometric chart provided. Expansion valve 24°C 60% Evaporator -www- Dry air mass balance: Water mass balance: Energy balance: Condenser in ₁ h= 0 Condensate Compressor m = m = m I alm Figure Q2 + Σinh m₂ + m₂ →Q 1 32°C 95% m₂ = m (, -a) = m(h, -h₂)-mh
A 2.99 kg of air at 24.24 C underwent an isentropic process wherein its initial pressure of 52.1 kPa was doubled. Determine the change in enthalpy (kJ) of the system. Consider the individual gas constant, specific heat at constant pressure, and specific heat ratio of air as 0.287 kJ/kg-K, 1.00 kJ/kg-K, and 1.4 respectively.
5500 kg of steam is produced per hour at a pressure of 7.6 bar in a boiler with dryness fraction 0.98. The feed water temperature is 51°C. The amount of coal burnt per hour is 650 kg of calorific value 30500 kl/kg. Determine the boiler efficiency and equivalent evaporation,
2) In a well-insulated fixed-volume closed vessel, there is initially 5 kg of saturated liquid-vapour mixture water at 100 kPa pressure. In this state, one quarter of the total mass is in the vapor phase. Then, the electric heater in the container operates and a current of 8 A flows through the heater plugged into a 110 V outlet. How long will it take to evaporate all the liquid in the container? Plot the phase change in the T-v diagram showing the saturation curves.
Pat Pb itde Air enters a window air conditioner at 1 átm. 30 c° and 80 % RH at a rate of 10 m³/min and it leaves as saturated air at 14 c°. Part of the moisture in the air that condenses during the process is also removed at 14 c°. Plot the schematic and psychometric of the process and determine the rates of heat and moisture removal from the air. in Far V. -
Air is to be conditioned to have a final humidity ratio of 0.0194. If 50 cu. meter/min of this saturated air enters the conditioner at 15.64 C and increases its temperature by 20.35.C, using the thermodynamic properties of air formula determine the: NOTE: DO NOT USE PSYCHROMETRIC CHART!!! -Draw the schematic diagram of the problem -the total amount of heat transferred in kW -amount of latent heat added in kW -the sensible heat ratio.
A stream of outdoor air is mixed with a stream of return air in an air conditioning system that operates at 101 kPa pressure. The flow rate of outdoor air is 3 kg/s, and its condition is 30 deg C Tdb and 23 deg C Twb. The flow rate of return air is 2.5 kg/s and its condition is 15 deg C Twb and 60% RH. Determine (a) the enthalpy of the mixture, (b) humidity ratio of the mixture, (c) the dry bulb temperature of the mixture, and (d) the dry bulb temperature by the weighted average of the dry bulb temperatures of the entering streams.
In an air-conditioning unit 3.5 m3/s air at 27°C dry-bulb temperature, 21°C wet-bulb temperature, and 90 kPa atmospheric pressure enters the unit. The leaving condition of the air is 13°C dry-bulb temperature and 90 percent relative humidity. Calculate the inlet air mass flow rate in kg/s.