fast and correct please A rock fill has a dry unit weight of 135 pcf and a relative density equal to 83%. IfG; = 2.73, what is emin and emax if yd min = 100 pcf?

Answered: Image /qna-images/answer/572c66ae-c947-4e25-ae49-78cd0347c9e0.jpg

Answered: A rock fill has a dry unit weight of…

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.19P

See similar textbooks

Similar questions

Determine the value of porosity if void ratio is 0.262
A 5-ft fill is to be placed over the following soil profile shown below. Determine if the clay is normally consolidated or over-consolidated. The pre-consolidation pressure (past maximum consolidation stress) of the clay is 1000 lb/ft3. 5 ft 2 ft 4 ft Proposed Fill, y = 120 lb/ft³ Sand Clay Rock 2 ft A Ydry = 100 lb/ft³ Ground water table Ysat 110 lb/ft³ = o'= Pc = 1000 lb/ft²
An isolated footing 1.50m x 1.20m x 0.30m designated as F-1, is to be used as foundation for two storey residence. There are nine (9) pcs of F-1. Using Class A 1:2:4 Concrete Mix Proportion, a) determine the required total quantity of cement - 40kg bag.
A consolidated-drained triaxial test was conducted on a normally consolidated clay. Theresults are, Ϭ3 = 300 kN/m2, (ΔϬd)f = 250 kN/m2. Determine? Draw a neat Mohr Circle to aconvenient scale and determine following?a. Angle of friction ϕ’?b. Derive a relation between angle Ѳ (that the failure plane makes with the majorprincipal plane) and internal friction angle of soil (ϕ’)? Also find out the failure planeangle (Ѳ) in this case?c. Find the normal stress Ϭ’ and the shear stress Ƭ on the failure plane?d. Determine the effective normal stress on the plane of maximum shear stress andorientation of this plane?e. Determine the orientation of both major and minor principal planes?
The coefficient of permeability of a sand at a void ratio of 0.62 is 0.03 cm/sec. estimate the coefficient of permeability at a void ratio of 0.48. a. Using Casagrande equation b. Using kozeny - Carman equation.
11.12 A 2-m clay layer in the field has a current effective stress, oó= 70 kN/m?. There is a net stress increase, Ao = 180 kN/m², due to a foundation load. Calculate the expected primary consolidation settlement. The results of a consolidation test on the clay are given below. o' (kN/m) 0.98 12 0.94 50 0.82 200 0.73 400 ©Cngage lamng 2014
a. Compute the value of x b. Compute the area in the fill c. Compute thr area in cut
4. Calculate the total settlement of two clay layers? The two clay samples at Location A and Location B were collected and analyzed. Use information at Location A to estimate the settlement at the stiffy silty clay. Use information at Location B to estimate the settlement at the very stiff clay. Compression index C, at point A is 0.25, C, at point B is 0.2. Swelling index C, at point A is 0.08, C, at point B is 0.06. Initial void ratio eo at point A is 0.66, eo at point B is 0.45. Maximium vertical stress cat point A is 101 kPa, at point B is 510 kPa. The 8.5 m thick proposed fill generated a increase of vertical stress = 20.3x8.5 = 172.55 kPa. 8.5 m 2.0 m 3 m 7.0m 4 m 4 mⒸ 4 m5 18.0m 5 mo 5 m Proposed Fill y=20.3 kN/m² y-18.3 kN/m² 7-19.0 kN/m² y-19.5 kN/m² 4.0 Stiff Silty Clay (CL) 10.0 Very Stiff Clay (CL) Glacial Till
Problem 1 The void ratio versus pressure data shown below. The initial void ratio is 0.725, and the existing vertical effective overburden pressure is 130 kPa. Void Ratio 0.708 0.691 0.670 0.632 0.635 0.650 0.642 0.623 0.574 0.510 0.445 0.460 0.492 0.530 Pressure (kPa) 25 50 100 200 100 25 50 200 400 800 1600 400 100 25 a. Plot the data as e versus log o b. Evaluate the overconsolidation ratio. c. Determine the field compression index using the Schmertmann procedure. d. If this consolidation test is representative of a 12 m thick clay layer, compute the settlement of this layer if an additional stress of 220 kPa were added.
Refer to Figure Q3. Estimate the primary consolidation settlement in the clay layer. Given: Δ? = 85 ??/?2 ?1 = 2 ? ?2 = 4 ? ?3 = 6 ?. Soil characteristics are as follows (use appropriate relations):• Sand: ? = 0.65; ?? = 2.66• Clay: ?? = 54;? = 0.98; ?? = 2.74; ?'c = 150 ??/?2; ?? = 1/6 ?c
The following technical data are given below: Overburden pressure = 180KPa Increase in pressure = 140KPa Clay thickness = 8m Compression Index = 0.315 Void ratio = 1.132 What is the total settlement in clay?
Q5-A proposed earth dam requires 7500 m³ of compacted soil with relative density of 94%, maximum void ratio of 0.73, minimum void ratio of 0.4 and specific gravity (Gs)= 2.67. Two borrow pits are available as described in the following table. Choose the best borrow pit with a minimum cost. Borrow Pit A B Degree of saturation % 82 100 Moisture content % 18.43 24.34 Cost ($/m³) 10 5

SEE MORE QUESTIONS

Recommended textbooks for you

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Fundamentals of Geotechnical Engineering (MindTap…

Civil Engineering

ISBN:

9781305635180

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Principles of Geotechnical Engineering (MindTap C…

Civil Engineering

ISBN:

9781305970939

Author:

Braja M. Das, Khaled Sobhan

Publisher:

Cengage Learning

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781305081550

Author:

Braja M. Das

Publisher:

Cengage Learning

Fundamentals of Geotechnical Engineering (MindTap…

Civil Engineering

ISBN:

9781305635180

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

A rock fill has a dry unit weight of 135 pcf and a relative density equal to 83%. If Gs = 2.73, what is emin and emax if yd min = 100 pcf?