SINUSADAL ALTER UATINGSIDES 5CM471t is APPUED TO A H.5cmIS WOUND HTH 300 TUIN3.) A SINUSODAL ALTERUATINGSINUSADAL ALTERNATINGVOLTAGE HAC N C.m.s VALUE OF200 VFREQUENCY OF so Hz. IT THE ZERO AXIS IN ACROSSESPOSITIVEDIRECTIONKHEN t=0. DETERMINE li) THE TIME WHEN VOLTAGE FIRSTREACHES THF STANTANEOUS VUE OF 2wY AND (i) THE TME HEN KOUAGELETER PASSING THROUGHTs MAXIMUM POSITIVE YALUE REACHES THE VALUE11141.4 V.(0.0025 SELOND (ii) 1/300 SECOND)OF 200 SN 47 E iS APPUED TO A HWAN ALTEFNSTNG VOLTAGESEPIES VITH AKRISTANE OF 40 2.IF THE

Given, RMS value of voltage is V = 200 volts Frequency (f) = 50 Hz The zero crossing of the…

-) A SINUSODAL ALTERNATING HAS AN rims VALUE OF VOLTAGE 200 V FREQUENCY OP so HE IT CRO5SES THE ZERO AXIS IN A AUP POSITIVE DIRECTION WHEN t=0. DETERMINE li) THE TIME WHEN VOLTAGE FRST REACHES THE USTANTANEUS VAUE OF 200 Y ANP () THE TIME WHEN OLAGE LETER PASSING THROUGH IT MAXIMUM POSITIVE YALUE REACHES THE YALUE

-) A SINUSODAL ALTERNATING HAS AN rims VALUE OF VOLTAGE 200 V FREQUENCY OP so HE IT CRO5SES THE ZERO AXIS IN A AUP POSITIVE DIRECTION WHEN t=0. DETERMINE li) THE TIME WHEN VOLTAGE FRST REACHES THE USTANTANEUS VAUE OF 200 Y ANP () THE TIME WHEN OLAGE LETER PASSING THROUGH IT MAXIMUM POSITIVE YALUE REACHES THE YALUE

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

Ererrises: IA platinum oil has a resifance of 3-14k r at go°C and 3.747JV at 100°C.- Fin'd the resistance at o'C ond the kmp -creff. of resifonce af 40°C 2. A pofential difference of r5oV is apphed to a field wnding at 15°C and the currend is SA. What will be the mean fempouafure of the winiding when currend has falen to 3.91A, apphedvrltage being constant Aasume s =p7.5. 3. A cril has a resi fance of 182 when its mean femperature is 20°C and 20v when ik mean femperature s 50°C. Frid is mean femperature rise when ik resotonce is 21JL and the sorrandinig femperature is i5°C. A cril of a relay takes a curre of 0.12 A when it is at the vem insbi o al 4. A jemperature of is'C ond canneckerdacms a oV supply If the minimum operating current of the relay is 0.1 A, colculate the femperature above ohich the relay will fail to operate when connected ti the same supply. Resi tncenfemp.coefficrenf of the cril makria] is o.0043 per °C at 0°C.
A certain impedance is given by 1012° N. Does the current lead or lag the voltage, and by how many degrees? Fill in the blanks. The current the voltage by
An alternating current i=50.5sin 520t is following through a resistance.find a frequency ,max value of current R.M.S and average value ,form factor , peak factor?
"If lab is equal to 595.8252306 and lb is 344296, the phase sequence is:" O POSITIVE O NEGATIVE
please solve value of Capacitor with 0.1V Ripple. And draw output ripple waveform. Explain it one by one for me thanks..
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
For the current waveform that shown in Figure below Find:- 1). Average value 2). R.M.S value 3). Form factor Current (A) ha 8 10 12 1-2
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
The sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 50 µs/cm and the volt/cm switch is on 20 V/cm. The width of one complete cycle is 3.6 cm and the peak to peak height is 5.8 cm. Determine the following: The frequency is = The peak to peak voltage is = The amplitude is = The R.M.S voltage is =
For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 5ms/cm and the volt/cm switch is on 3 V/cm. a) the frequency will bel Hz b) the amplitude will be V.
can you please give me the comple solution for this question, thanks. A certain voltage function contains a constant term, a fundamental and third harmonic. The maximum value of the fundamental is 85 % of the constant term and the maximum value of the third harmonic is 55 % of the constant term. If the effective value of this function is 180.3V, find the magnitude of the two harmonics. A.IstHarmonic = 75 V , 3rd Harmonic = 120V B. Ist Harmonic = 80 V , 3rd Harmonic = 125V C. IstHarmonic = 120 , 3rd Harmonic = 75V D. Ist Harmonic = 125 V , 3rd Harmonic = 80V E. NOTA