A substation has two feeders, Sub Feeder-A have demand at a time is 35 KW and Sub Feeder-B have demands at a time is 42 KW, and the max demand of Main Feeder is 70 KW. The diversity factor of the system is Blank 1
Q: 1) The message signal m(t) as shown in the figure is phase modulated to generate the PM signal (t) =…
A: The instantaneous angular frequency will be obtained by differentiating the instantaneous phase as:…
Q: Q1 The following differential equation describes a water tank system d h(1) +/h(1)=9,(1) dt AR where…
A: 1) Given a differential equation describing a water tank system a) Write the differential equation…
Q: If the inertia constant H = 8 MJ/MVA for a 50 MVA generator, the stored energy is?
A: Given, Inertia constant, H = 8 MJMVA MVA rating, S = 50 MVA
Q: What are the characteristics of an ideal operational amplifier?
A: The solution is provided in the following section.
Q: Problem 15. A source of e.m.f. of 15 V supplies a current of 2A for six minutes. How much energy is…
A: Given, Source emf, V = 15 V Current supplies, I = 2 A For time, t = 6 min = 360 sec
Q: What are the Various type of faults in transformer
A: There are various type of faults in transformer which is given below- Overheating Overheating is…
Q: A three-phase motor draws 9 kVA at a lagging PF of 0.8 from a balanced system with line voltages of…
A:
Q: A 188 KW, 200 volt, three phase, delta-connected induction motor has a full load efficiency of 94 %…
A: Given data, Output Power (Pout)=188kW Line Voltage (VL)=200V Full load efficiency ηfl=94% or 0.98…
Q: P 11.9-11 Determine the coil voltages, V₁, V2, V3, and v4, for the circuit shown in Figure P…
A: The given circuit is shown below,
Q: 1. Find and draw the Fourier Transform of the signal shown if figure below: f(t) -T coswot T
A: 1) To find and draw the Fourier transform of the signal f(t) = cos(wot)
Q: -/ 1 Question 10 of 25 View Policies Current Attempt in Progress A square wire loop with 2.3 m…
A: Given data : The magnetic field B=0.035-0.84t The battery EMF E=16V Length of square L=2.3m
Q: A 2-pole, 50 Hz, 11 kV 100 MW alternator has a moment of inertia of 10,000 kg.m². The value of…
A: Given data, Number of pole P = 2 Frequency f = 50 Hz Power P = 100 MW Moment of inertia I=10000 kgm3
Q: A modulating signal is amplified by 60% efficiency amplifier before being combined with a 40kW…
A: Given, Efficiency of amplifier, η=60 % = 0.6 Carrier signal power, Pc=40 kW Modulation index, μ=80…
Q: Vo= 1 + 2R RR) (V₁ – V₂) = k(V₁ – V₂) Rp
A:
Q: A 3-phase, 4 pole, 400 V, 50 Hz, squirrel-cage induction motor is operating at a slip of 0.02. The…
A: Given a 3-phase squirrel cage induction motor having, Number of pole, P = 4 Frequency, f = 50 Hz…
Q: IB= 226.41u re = 1.14 Zi= 5.97k Av = 8.80m Vcc RB1 B RB2 E RE Given: B = 100, VCC = 15, RB1 = 15k,…
A:
Q: 5. Please refer to the parallel-based clipper circuit shown below for this problem. For simplicity,…
A: Given: Required: (a) Plot the output V0(t) for 0≤t≤T (b) Plot the voltage…
Q: The power input to a 500 V, 50 Hz, 6 pole, 3 phase induction mote running at 975 rpm is 40 KW. The…
A: In this question we will find slip , rotor cu loss , shaft power and efficiency.....
Q: or the circuit shown, determine the: a) the type of filter b) center frequency,
A:
Q: Q2. In the circuit shown, the current in the 12 resistor is 6V 202 www ww 392 P 122 www Q30 9V
A:
Q: A series RLC circuit with L=160 mH, C= 100 micro F and R=40 ohm is connected to a sinusoidal voltage…
A:
Q: OR e) What is BILS? Explain their significance in power system studies.
A: BILS : BIL is stand for basic level insulation which is also known as lighting impulse voltage or…
Q: A flow transmitter has an input range of 40 gallons per minute (GPM) to 130 GPM, using a standard…
A:
Q: Figure 1 shows a unity feedback system where the transfer function is given as 1 G(s): s(s² + 100s…
A:
Q: P 11.9-3 The source voltage of the circuit shown in Figure P 11.9-3 is vs = 141.4 cos 100t V.…
A:
Q: The switch in the circuit shown has been closed for a long time and is opened at t = 0. Find a) b)…
A:
Q: What are the working principle of air blast circuit breaker
A:
Q: * E B A F Find any Hamiltonian circuit on the graph above. Give your answer as a list of vertices,…
A:
Q: P 11.9-11 Determine the coil voltages, V₁, V2, V3, and v4, for the circuit shown in Figure P…
A: The given circuit is as shown below,
Q: Multiple Choice Question (1): (i) A sinusoidal carrier is modulated with a sinusoidal information…
A: Note : According to the guidelines of the company if the questions are not interlinked to each other…
Q: 8 For the circuit shown in Fig. 15-28, determine Ig(s) and sketch: (a) |L₂(0)| versus o; (b) |I₂(jw)…
A: Coupled Circuit: When coil 1 and coil 2 are not physically attached but mutual coupling takes place…
Q: Two inductors are connected in series with L₁= 27 mH, L₂ = 12 mH, and M = 0.0144 mH, find the…
A: Given, Two inductors are connected in series. L1=27 mHL2=12 mHM=0.0144 mH
Q: 31. For the circuit of Figure 5.71, determine the Thévenin equivalent that drives the 20 nF…
A: Given circuit :
Q: 3. Charge lies on the circular disk r ≤ 4 m, and z = 0 m with surface density G₁ = 10-4/r C/m².…
A: Given data, Surface charge density σ=10-4r C/m2
Q: Use minimum number of NAND gates only to represent the Boolean operation of an XOR gate.
A:
Q: Explain differential current and voltage differential scheme of bus bar protection
A: Differential current bus bar protection Voltage differential bus bar protection
Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * -12.7 V R1…
A: For the given diode circuit we need anode to cathode voltage of the diode.
Q: E V.(2) Figure 10.1 A (2, 1, 3) binary convolutional encoder.
A: Convolutional Encoder: A(2,1,3) binary Convolutional Encoder states that k=1, n=2 and K=3 where k…
Q: 1. Use the concept of mesh current analysis to find io in the circuit shown. Note: to, the branch…
A: Given,
Q: (a) Qualitatively sketch the inversion charge density in the channel region when an NMOS transistor…
A:
Q: Vi Question O'ska K DI ATOV 39.5752 D2 SV Vo E2 mo Find Vo using CVD model of diode (VDO = 0`GV) (a)…
A:
Q: equal to: 05 on The function F(s) = 58² +1 8(8²+5) has a final value
A: Given data, Function is given, Fs=5s2+1ss2+5
Q: A 5 KVA, 2300/230 V, 50 Hz transformer was tested for iron losses with normal excitation and copper…
A: GIVEN: A 5KVA, 2300/230 V, 50 Hz transformer was tested for iron losses with normal excitation and…
Q: The equivalent resistance between L and M of the circuit 6.2 L 14.02 205 20 10.02
A: Given circuit,
Q: An integrated circuit is .. A. A complicated circuit B. An integrating device C. Much costlier than…
A: Integrated circuit is also called microchip or chip. It is kind of wafer that has millions of…
Q: Discuss and compare the various method of neutral earthing
A: Different earthing methods are given below, 1. Underground neutral earthing : In ungrounded earthing…
Q: What is bode plot ?
A: It is the Frequency domain Analysis which consists of Both magnitude Plot and Phase plot. Purpose of…
Q: Determine the current gain and the power gain of the circuit shown below. 24 V
A: The given amplifier is the cascaded multistage amplifier. DC analysis of the amplifier Now the…
Q: what is bus impedance matrix ? how it is useful in symmetrical fault analysis?
A: Impedance bus matrix : Impedance bus matrix is a algorithm method to form a bus impedance matrix on…
Q: is Idc -Idc 0 K de 2 If ripple-free load current in steady-state is assumed, the input current is…
A: Fourier series coefficient using full range Fourier series:
Step by step
Solved in 2 steps
- A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuitThe section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance. On bus-bar-A, there are two generators each of 10 MVA with 8% reactance and on bus-bar-B, two generators each of 6000 kVA with 10% reactance. Find the steady MVA fed into a dead short circuit all phases on B with bus-bar reactor in the circuit.
- Q20. The section bus-bars A and B as shown in Figure B5 are linked by a bus-bar reactors each rated at 5000 kVA with 10% reactance. On bus-bar A, there are two generators each of 10,000 kVA with 10% reactance and on B two generators each of 8000 kVA with 12 % reactance. Find the Current and MVA that fed into a dead short circuit between all phases on B with bus-bar reactor in the circuit. Page 4 of 5 جامعة التقنية والعلومر التطبيقية بإبراء University of Technology and Applied Sciences - Ibra Student ID: Section: Student Name: 8,000 kVA 12% 10,000 kVA 10,000 kVA 10% 8,000 kVA 12% 10% 2 3 5,000 kVA 10% lell 8,000 kVA 10% Figure B5 "End of Question Paper"A generating station is to supply four regions of load whose peak loads are10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Then the installed capacity is (25 to26)MW. O (24 to25)MW. O (23 to24)MW. OA 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
- 6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current heA power station consists of two synchronous generators A & B of ratings 250 MVA and 500MVA with inertia 1.6 pu and 1.0 pu respectively on their own base MVA ratings. The equivalent pu inertia constant for the system on 100 MVA common base is:- (a) 2.6 (b) 0.615 (c) 1.625 (d) 9.0Can we improve a leading load pf using a synchronous condenser? Explain briefly your answerin one(1) sentence.
- two generators supplying a load. Generator I has a no-load frequency of 62.5 Hz and a slope Sp1 of I MW/Hz. Generator 2 has a no-load frequency of 62.0 Hz and a slope sp2 of I MW/Hz. The two generators are supplying a real load totaling 2.5 MW at 0.8 PF lagging. (a) At what frequency is this system operating, and how much power is supplied by each of the two generators? (b) Suppose an additional I-MW load were attached to this power system. What would the new system frequency be, and how much power would Gl and G2 supply now? Generator 1 VT V2 Generator 2 VTí KVAR KVARA generator operating at 50 Hz delivers 1 p.u. power to an infinite bus through a transmission circuit in which resistance is ignored. A fault takes place reducing the maximum power transferable to 0.5 p.u. Where as before the fault, this power was 2.5 p.u. and after the clearance of the fault, it is 2 p.u. The value of 8 is maxes and efficiency at half load