A vertical trapezoidal gate is used as an automatic valve that is held closed by two springs, which are located along edge AB. Knowing that each spring exerts a torque of magnitude 2500 Nm, determine the depth "d" of water at which the gate will open.

Q: re the forward kinematic model for a 3-li sl₁, l2 and le respectively by developing Respective…

A:

Q: A rigid (closed) tank contains 16 kg of saturated water at 90 °C. If all of this water is in the…

A:

Q: Consider a flat plate positioned inside a wind tunnel, and air at 1 atm and 20°C is flowing with a…

A:

Q: Locate the centroid of the plane area shown. y Vertex Parabola 60 mm 60 mm -75 mm

A: Given Shade Zone To find Centroid

Q: Draw the frontsideant top view the Shape Shown

A: According to the details provided in the question, we need to Draw three projection views.

Q: Determine the shear force acting at each of the following locations:

A:

Q: For a spring-mass-damper system with the following characteristics m= 70 k= 707 C= 69 Xo = 0 m/s Vo…

A: Write the given data. m=70 kgk=707 N/mc=69 Ns/mx0=0 m/sv0=0 m/sFt=100te-t

Q: Calculate the force in member BG using a freebody diagram of the rigid member ABC. The force is…

A: For the truss, it is given that at A, a downward load of 800 lb is acting. It is required to…

Q: 6. Diffusivity. the diffusivity of volatile solvents is frequently measured using an Arnold cell.…

A: Given: The length of vertical glass tube, L1 = 10 cm = 0.1 The surface area of glass, A = 1 cm2 The…

Q: system the heat is supplied to generator by condensing stream at 0.2 MPa. The in d the final state…

A:

Q: A rigid (closed) tank contains 16 kg of saturated water at 90 °C. If all of this water is in the…

A: Given: mass m = 16 kg Temperature = 90 deg C

Q: A model of the Airbus 320 is tested in a wind tunnel using air at standard conditions. If the tunnel…

A:

Q: If the temperature of the sun is doubled, the rate of energy received on the earth will increase by…

A: Heat energy generated from sun reaches to the earth by radiation heat transfer. In radiation heat…

Q: ar

A:

Q: A drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum.…

A:

Q: Determine the y-coordinate of the centroid of the shaded area shown. 15" Parabolic 4" 6"

A:

Q: cycle length of the order (in days) will be

A: Given data,  Annual requirement of rivets at a ship manufacturing company is,  D= 2000 kg/yrRivets…

Q: At the beginning of compression in an SI engine, it operates on a 0.045 kg/s of air from 14 psia and…

A:

Q: 2(a). A rectangular case is loaded with uniform vertical thin rods such that when it is full, as…

A:

Q: Water at 15°C is to be heated to 65°C by passing it over a bank of resistance heating rods 4 m long…

A:

Q: At a given instant the center of the roller A on the bar has the velocity and acceleration shown.…

A: I have used instantaneous method to solve this problem.  As you have already calculated VB through…

Q: boat race, boat A is leading B by boats are elling at a constant speed of 169 kph. AT TEU, The…

A: Relative velocity is 14.5508 m/sec

Q: The force P is applied to the 61-kg block when it is at rest. Determine the magnitude and direction…

A:

Q: An aircraft has the following relevant specification outlined below: Weight: 329 kN Wing planform…

A: Given: The weight, W = 329 kN The planform area, A = 191 m2 The drag polar, CD = 0.01+0.064CL2 The…

Q: An empty 6-in. diameter dust fall jar weighs 1560 g. After sitting outside for the prescribed amount…

A:

Q: A commercial aircraft flies at 0.86 at altitude of 10000 feet above sea level. The inlet has been…

A: Given:  gamma = 1.38 Mach number , M = 0.86 pressure recovery = 0.96

Q: Find the dimensions of K, knowing that P: Pressure, V: volume and that the following equation is…

A: Find the dimensions of K, knowing that P: Pressure, V: volume and that the following equation is…

Q: Write a brief introduction about control of furnace door (OPEN ENDED) . Note:Include all the…

A: Given: There are automatic door of the furnace and automatic supplier of the fuel to the furnace. In…

Q: Determine the magnitude of the pin force at A. Assume W = 670 lb, a = 5.2 ft, b = 3.5 ft, r = 7 in.…

A:

Q: In hydraulic systems, why should hydraulic fluid operating temperatures be kept under 140°F? Fluids…

A: given = multiple choice question

Q: You only know one point on a pump curve, where a water pump produces 20 m of hydraulic head at flow…

A: A pump's performance curve shows how well it will operate in terms of flow and pressure head. For a…

Q: The life of a ball bearing at a load of 10 kN is 8000 hours. Its life in hours, if the load is…

A: Life ∝ (1P)3 => L2 = L1(P1P2)3 => L2 = 8000×(1020)3 Therefore, L2 = 1000

Q: Write the shear and moment equations for the beam loaded as shown, then sketch the shear and moment…

A:

Q: 8. A single-acting reciprocating air compressor has a clearance volume of 10%. Air is received at 90…

A: Given : clearance volume, Vc = 0.10 VD clearance ratio , c = Vc /VD = 0.10  pressure at suction , P1…

Q: Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium equation…

A:

Q: Find the longitudinal strain when a bar is stretched to double in its length. Select one: O a. 2.00…

A: Given: initial length, L1 = L Final length , L2 = 3L To find : longitudinal strain

Q: A rigid (closed) tank contains 16 kg of saturated water at 90 °C. If all of this water is in the…

A:

Q: A balloon goes vertically upward at a constant speed sec/m7, and when it was at a height of 134.4…

A:

Q: Prepare the forward kinematic model lengths 1, 2 and le respectively by deve Respective coordinate…

A:

Q: The specific volume of superheated water vapor at 0.6 MPa and 900°C is 0.90179 m³/kg in the steam…

A: Given: T = 900 deg C P = 0.6 MPa specific volume = 0.90179 m3/kg

Q: A tensile test generates the stress-strain diagram shown here. 600 Stress (MPa) 500 400 300 200 100…

A: In this problem, it is asking about the last 3 sub-parts.

Q: drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum.…

A:

Q: Correct the following sentences (more than one mistake may be presented for each sentence): 1. The…

A: Given Statement To find Correct statement

Q: in an indirect evaporative system,through a tube heat exchanger, the primary air at an inlet has a…

A: GivenThi=43oCTci=22oCε=0.8

Q: Which of the following is true about components of a pneumatic system such as valves, pipes, and…

A: As per given question Which of the following is true about components of a pneumatic system such as…

Q: A laboratory furnace wall is constructed of 0.656ft thick fireclay brick having k=1.0 W/m·K. This is…

A: Given: Lbrick = 0.656 ft Kbrick = 1 W/mK Linsulation = 1.181 in Kinsulation = 0.07 W/mK

Q: A 150-mm-long bronze tube, closed at its ends, is 80 mm in diameter and has a wall thickness of 3mm.…

A:

Q: 17 In an irreversible process there is a loss of heat. no loss of work MED a b gain of heat No gain…

A: (Q 1) It is required to state the condition that are applicable for irreversible process. (Q 2) It…

Q: The difference between the headwater and the tail water elevation is 150 m. The head utilized by the…

A:

Q: 1 The maximum shear stress in that section 2 The shearing stress at point P 12 mm 25 AN 12 mm 100 mm…

A: Given: All the downward forces are given in the figure at 0.4 m and 0.7 m from the point A. So…