A very common problem in instrumentation is that of interference of the telemetry that is to be measured. One of the primary sources of the interference is the power line. This is particularly true for high impedance circuits. Another path for this noise is ground-loops. One possible solution is to use a notch filter to remove the 50HZ component. Design a suitable notch filter for this purpose.

A very common problem in instrumentation is that of interference of the telemetry that is to be measured. One of the primary sources of the interference is the power line. This is particularly true for high impedance circuits. Another path for this noise is ground-loops. One possible solution is to use a notch filter to remove the 50HZ component. Design a suitable notch filter for this purpose.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3. An essential part of an AC-DC power supply circuit is the filter, used to separate the residual AC (called the "ripple" voltage) from the DC voltage prior to output. Here are two simple AC-DC power supply circuits, one without a filter and one with: Plug unfiltered Plug Filter Vatered Draw the respective output voltage waveforms of these two power supply circuits (unfiltered versus filtered). Explain why that type of filter circuit is needed.
discuss the uses of Hanning window in FIR filter!?
2.How Capacitor filter is removing the AC components ?
How the phase modulation can generate frequency modulation?
In the filter shown in figure 8 the ratio between the output AC voltage Vout and input voltage Vin is given by Vout R wCR (1) R+ j(wL – 1/(wC)) Vin R+ j(w?LC – 1) - -
1. The purpose of the Lag Compensator is: I. Improve the study state response of the close system. II. Speed up the transit response. III. All the above. IV. None of the above. 2. In the Lead Compensator: I. Z > P. II. Z < P. III. Z = P. IV. None of the above.
RLC Series AC Circuits• Calculate the impedance, phase angle, resonant frequency, power, power factor, voltage, and/or current in a RLCseries circuit.• Draw the circuit diagram for an RLC series circuit.• Explain the significance of the resonant frequency.
Which of these filters are stable,which of these are unstable and why?
1. Derive the lower cut-off frequency for the basic RC high-pass circuit in Figure 1. R, Figure 1.
What is a bandpass filter? How is its bandwidth defined?
What are the effects and significance of using filter capacitance?
Discuss how the pressure of the air inside a Helmholtz resonator affects its resonant frequency.