A water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a period of 30 minutes while warm water is discharged from the tank at a rate of 25 L/min. The amount of water in the tank at the end of 30 min period is 50 L. The rate of hot water entering the tabk in L/min is (WITH FREE BODY DIAGRAM) CHOICES: A.7 B.5 C.11 D.25

A water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a period of 30 minutes while warm water is discharged from the tank at a rate of 25 L/min. The amount of water in the tank at the end of 30 min period is 50 L. The rate of hot water entering the tabk in L/min is (WITH FREE BODY DIAGRAM) CHOICES: A.7 B.5 C.11 D.25

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Similar questions

Include a free body diagram A water initially contains 140 L of water. Now equal rates of cold and hot water enter the tank for a period of 30 minutes while warm water is discharged from the tank at a rate of 25 L/min. The amount of water in the tank at the end of 30 min period is 50 L. The rate of hot water entering the tabk in L/min isA. 11B. 5C. 25D. 7
dp 1. It shows that the behavior of fluid is A From the equation stated, show the formula for mass flow rate AVp = c. :C.
3. For a Pelton turbine the pressure of the flow before the nozzle is 5 bar while the velocity of flow leaving the nozzle is 31m/s. If the speed of the turbine is 500 rpm and the wheel diameter is 1.5 m, the efficiency of the nozzle will be: а. 0.96 b. 0.97 с. 0.98 d. 0.99 e. None of the them.
B: The pump in Fig. Q3B increases the pressure in the water from 200 to 4000 kPa with a flow rate of 0.1 m³/s? The electric power of motor 275 kW. Determine the mechanical efficiency of the pump and overall efficiency pump/motor unit when the motor efficiency is 90 percent. Fig. Q3B 50 mm Pump 100 mm Water Motor
2. A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079ft/cu. ft and discharges it with a density of 0.304 lb/cu. ft. At the suction, P 1 = 15 Psia; atdischarge, P 2 = 80 psia. The increase in the specific internal energy is 33.8 BTU/lb and the heattransferred from the air by cooling is 13Btu/lb. Determine the work on the air in BTU/min and inhp. Neglect kinetic energy. 3 decimal in final answer pls
At the inlet to a certain nozzle the enthalpy of the fluid is 3025 kJ/kg and the velocity is 60 m/s. At the exit from the nozzle the enthalpy is 2790 kJ/kg. The nozzle is horizontal and there is negligible heat loss from it. i) Find the velocity at the nozzle exit. ii) If the inlet area is 0.10 m2 and specific volume at inlet is 0.19 m3/kg. Determine the exit fluid density (kg/m3) if thea area at the exit is one-tenth of the area at the inlet
Problem 1. Air in a diffuser (diffuser: A device that increases pressure of a fluid by decreasing fluid velocity). Air enters the diffuser at a inlet outlet steady velocity of 200 m/s, T= 10 °C, and P = 80 kPa. The inlet area of the diffuser is 0.4 m². The air leaving the diffuser (outlet) has a very diffuser small velocity compared to the inlet velocity. Find the mass flow rate (kg/s) of the air and the temperature (°C) leaving the diffuser.
Identify what is the system in this problem and write the general energy balance equation (no need to solve) A turbine is driven by a system that enters the turbine at the ff. conditions: 200 kg/h, 39 atm, 501 deg C, 49 m/s linear speed. The steam exits at a point 8 meters below the inlet stream of the turbine with the following conditions: atmospheric pressure, 290 m/s speed. 69000 W of shft work is delivered by the turbine while 100 kcal/h heat is lost. What is the specific delta H?
Suppose that you are willing to determine the diameter of the water jet impinging to the sink from the kitchen tap.The tap is produced to supply three different flow rates of the low, medium, and high. For each flow rate level, waterthat comes from the tap fills the beaker with a volume of 30 mL in 10 s, 6 s, and 2 s, respectively. The outlet of the tapis 13 mm, and the distance between the tap outlet and the sink is 53 mm. Determine the diameters of the water jetimpinging on the sink at three given flow rates.
A garden hose is connected to raise a narrower hose wherein the diameter of the bigger is twice the diameter of the narrower hose. The fluid flowing is a fresh water having an entrance velocity of 1.2 m/s and a pressure of 143 kPa find the the pressure in KPa and velocity in m/s at the exit point. Note; h or Ay = 20.0 cm (Express or round off your answer to one decimal place.) 20.0 cm Answer:
A right cylindrical container 4 m. diameter is 3 m tall. A 50 mm diameter hole is provided at the bottom of the container to drain the water when necessary. If it is full of water, how long in hours does it take to empty the container from the instant the hole is opened? Coefficient of velocity and coefficient of contraction are both equal to 1.0. A.1.39 hoursC.1.13hoursB.1.26 hoursD.1.49hours
Hot water at a constant volumetric flow rate of Fh and temperature Th(t) is mixed with cold water at a constant volumetric flow rate of Fc and a constant temperature of Tc. Both streams flow into a bathtub, but because of carelessness, the water is overflowing and keeping the bathtub full of water. The bathtub volume is V, and the heat loss can be ignored. Assuming the water in the bathtub is perfectly mixed and constant density and heat capacity, derive the differential equation relating the temperature in the bathtub, T(t), to the temperature of the hot water, Th(t).