After a shower and dishwashing, there is "no hot water" left in the 185 kg water heater. This suggests that the tank has emptied and refilled with water at roughly 10°C. How much energy does it take to reheat the water to 50°C ? How long would it take if the heater output is 9500 W? * 52.8 min O 55.6 min O 57.2 min. 54.4 min

After a shower and dishwashing, there is "no hot water" left in the 185 kg water heater. This suggests that the tank has emptied and refilled with water at roughly 10°C. How much energy does it take to reheat the water to 50°C ? How long would it take if the heater output is 9500 W? * 52.8 min O 55.6 min O 57.2 min. 54.4 min

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter41: Troubleshooting

Section: Chapter Questions

Problem 8RQ: When the outside ambient air temperature is 90F, the temperature of the condensing refrigerant in a...

See similar textbooks

Similar questions

HOW MUCH HEAT IS RELEASED BY THE REFRIGERATOR TO THE HOT RESERVOIR? (please only answer if you are 100% correct)(show work)
The reheat process is O decreases the turbine work increases the pump efficiency O decreases the pump efficiency increases the turbine work
A Camot engine requires 37 kW from the hot source. The engine produces 22 kW of power and the temperature of the sink is 28 °C. What is the temperature of the hot source in "C?
A manufacturer conducted an experiment for an evaporator capacity 548.8 kW cooling. Enthalphies of the refirgerant and solution are found to be: -144 solution leaving the Absorber -535.27 solution leaving the Generator 3256.50 refrigerant generated 167.93 refrigerant leaving the Condenser 2549.76 refrigerant absorbed determine: Mass flow of the refrigerant in kg/s Answer in four decimal places.
The coefficient of performance (COP) for a vapor compression cycle chiller is 8.7. If the chiller can produce 58 tons of cooling. If the chiller operates for a total of 3568 hours annually, and the cost of electricity is $0.15 per kWh, how much does it cost to operate the chiller? Fill in the operating cost of the chiller in one year in $.
iii) the exit area of the nozzle. Take Cp = 1.005 kJ/kg-K and R=287 J/kg-K Q.B3. A heat engine operates between two reservoirs at 400°C and 30°C. Half the power produced by the heat engine is used to drive a Carnot heat pump that removes heat from the cold surroundings at 2°C and transfers it to a house maintained at 27°C. The heat engine is absorbing heat at a rate of 5 kJ/s. i) Draw the complete schematic of the device ii) Determine the thermal efficiency of the heat engine iii) Determine the coefficient of performance of the heat pump iv) Determine the rate of heat loss from the house. v) Determine the minimum rate of heat extraction by the heat pump, and vi) the total rate of heat rejection.
A refrigeration system using R22 is to have a refrigerating capacity of 60 kW. The evaporating temperature is -5degC and condensing temperature of 35 deg-C. Determine the volume flow rate of the refrigerant at the inlet to the compressor, the power required by the compressor, and the fraction of vapor in the mixture at the entrance to the evaporator. Use the spreadsheet to solve this problem.
Subject : Thermofluid A well-sealed house left alone during the midday heat was found to be at 35oC. He turns on the air conditioner, which cools the entire house to 24oC in 30 min. If the COP of the air-conditioning system is 2.6, determine the power drawn by the air conditioner. An estimated of 750 kg of air is within the house for which cv = 0.72 kJ/kg·oC and cp = 1.0 kJ/kg·oC.
For a 15 ton capacity refrigeration system, the pressure of refrigerant in the evaporator is 150 kPa, whereas in the condenser it is 1590 kPa. If ammonia (R-717) is used under saturated conditions, calculate the theoretical power required to operate the compressor (kW).
For a 15 ton capacity refrigeration system, the pressure of refrigerant in the evaporator is 150 kPa, whereas in the condenser it is 1380 kPa. If ammonia (R-717) is used under saturated conditions, calculate the theoretical power required to operated the compressor (kW)
A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the evaporator, while in the condenser it is 750 kPa. If R-134a refrigerant is in a saturated state, calculate the theoretical power required to operate the compressor. Compressor Power = Answer kW.
A Carnot engine requires 35 kW from the hot source. The engine produces 15 kW of power and the temperature of the sink is 26oC. What is the amount of heat rejected to the sink?