An air-filled capacitor consists of two parallel plates, each with an area of 7.60 cm2, separated by a distance of 2.20 mm. If a 19.4-V potential difference is applied to these plates, calculate the following. (a) the electric field between the plates magnitude kv/m direction Select-- (b) the capacitance pF (c) the charge on each plate

An air-filled capacitor consists of two parallel plates, each with an area of 7.60 cm2, separated by a distance of 2.20 mm. If a 19.4-V potential difference is applied to these plates, calculate the following. (a) the electric field between the plates magnitude kv/m direction Select-- (b) the capacitance pF (c) the charge on each plate

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter20: Electric Potential And Capacitance

Section: Chapter Questions

Problem 37P

See similar textbooks

Similar questions

A parallel-plate capacitor with capacitance 5.0F is charged with a 12.0-V battery, after which the battery is disconnected. Determine the minimum work required to increase the separation between the plates by a factor of 3.
Check Your Understanding Determine the net capacitance C of each network of capacitors shown below. Assume the C1= 1.0 pF, C2=2.0pF, C3=4.0pF, and C4=5.0 pF. Find the charge on each capacitor, assuming there is a potential difference of 12.0 V across each network.
Check Your Understanding The potential difference across a 5.0-pF capacitor is 0.40 V. (a) What is the energy stored in this capacitor? (b) The potential difference is now increased to 1.20 V. By what factor is the stored energy increased?
Check Your Understanding When a cylindrical capacitor is given a charge of 0.500 nC, a potential difference of 20.0 V is measured between the cylinders, (a) What is the capacitance of this system? (b) If the cylinders are 1.0 m long, what is the ratio of their radii?
What If? The two capacitors of Problem 13 (C1 = 5.00 F and C2 = 12.0 F) are now connected in series and to a 9.00-Y battery. Find (a) the equivalent capacitance of the combination. (b) the potential difference across each capacitor, and (c) the charge on each capacitor.
Check Your Understanding The capacitance of a parallel-plate capacitor is 2.0 pF. If the area of each plate is 2.4 cm2, what is the plate separation?
What is the maximum charge that can be stored on the 8.00-cm2 plates of an air-filled parallel-plate capacitor beforebreakdown occurs? The dielectric strength of air is 3.00 MV/m.
Check Your Understanding The radius of the outer sphere of a spherical capacitor is five times the radius of its inner shell. What are the dimensions of this capacitor if its capacitance is 5.00 pF?
Figure CQ16.3 shows equipotential contours in the region of space surrounding two charged conductors. Find (a) the work WAB in electron volts done by the electric force on a proton that moves from point A to point B. Similarly, find (b) WAC, (c) WAD, and (d) WAE. Figure CQ16.3
(a) Regarding (lie Earth and a cloud layer 800 m above the Earth as the plates of a capacitor, calculate the capacitance of the Earth-cloud layer system. Assume the cloud layer has an area of 1.00 km2 and the air between the cloud and the ground is pure and dry'. Assume charge builds up on the cloud and on the ground until a uniform electric field of 3.00 106 N/C throughout the space between them makes the air break down and conduct electricity as a lightning bolt, (b) What is the maximum charge the cloud can hold?
(a) When a 9.00-V battery is connected to the plates of a capacitor, it stores a charge of 27.0 C. What is the value of the capacitance? (b) If the same capacitor is connected to a 12.0-V battery, what charge is stored?
A capacitor has parallel plates of area 12 cm2 separated by 2.0 mm. The space between the plates is filled with polystyrene, (a) Find the maximum permissible voltage across the capacitor to avoid dielectric breakdown, (b) When the voltage equals the value found in part (a), find the surface charge density on the surface of the dielectric.