An ideal transformer has two secondary coils with number of turns 100 and 150respectively. The primary coil has 125 turns and supplied from 400 V, 50 Hz,single phase source. If the two secondary coils are connected in series, the possible voltages across the series combination will be: (A) 833.5 V or 166.5 V (B) 833.5 V or 320 V (C) 320 V or 800 V (D) 800 V or 166.5 V

An ideal transformer has two secondary coils with number of turns 100 and 150respectively. The primary coil has 125 turns and supplied from 400 V, 50 Hz,single phase source. If the two secondary coils are connected in series, the possible voltages across the series combination will be: (A) 833.5 V or 166.5 V (B) 833.5 V or 320 V (C) 320 V or 800 V (D) 800 V or 166.5 V

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.5MCQ: For an ideal 2-winding transformer, an impedance Z2 connected across winding 2 (secondary) is...

See similar textbooks

Similar questions

A single-phase step-down transformer is rated 13MVA,66kV/11.5kV. With the 11.5 kV winding short-circuited, rated current flows when the voltage applied to the primary is 5.5 kV. The power input is read as 100 kW. Determine Req1andXeq1 in ohms referred to the high-voltage winding.
For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
In this Center tapped transformer Find the peak voltage of V1 and V2, RMS voltage of V1 and V2, and Peak to peak voltage of V1 and V2
In a step-down transformer ratio, which is larger the number of ratio O the number of turns O Secondary Voltage O Primary Voltage
How do i calculate secondary current in transformer analysis
O What are the 'ideal transformer' secondary and primary voltages Ez and E, and source voltage V1?
A IcA The voltage ratio in the following transformer equals to, Inc VAN/N1 Van/N2 Van/N1 Vab/N2
In no load phasor diagram of practical transformer, the magnetizing current Imag is with flux Ø O Leading by 30° O Lagging by 60° In phase O 90° out of phase
Draw the Phasor diagram of a practical transformer on no load operation
In the circuit shown in the figure, a voltage with a peak value of 212.16 V is applied to the input of the secondary transformer with common winding. The ratio between transformer windings is 5: 2. Find the Vrms value on VS2. A 59,98 Vrms B 29,99 Vrms C 42,43 Vrms D 84,86 Vrms E 42,52,99 Vrms
Question:4 A Step-down transformer is given and calculate 5:1 120 V 60 Hz V2 i k2 i. Peak load and D.C. load voltage ii. D.C. Current
A small filament transformer has a laminated sheet steel core whose average path length is 20cm and whose cross-sectional area is 5cm2. How many turns must there be on a primary winding to be connected to 120-V 60-Hz source if the flux density is 1.1T (H approximately 600At/m baseon figure 13-14)