As shown in the figure below, this is a speed regulation method for DC separately excited notor. 1) What is the speed regulation method? ) What are the characteristics for this speed regulation method? no BA ne Fa 11₂ B Ra R: Rs

Q: A 1000 μF capacitor is charged at a constant current of 1 mA. The final voltage across the capacitor…

A: it is asked to find the charge and time required from given values of capacitance, current and final…

Q: 1. Simplify the block diagram shown in Figure 1 and obtain the closed-loop transfer function…

A: The given problem is from block diagram reduction techniques.  The detailed solution is given in the…

Q: 200pF, CD=CGD+CDB Consider the common gate amplifier shown below. Let R₁ = 2.5kN, Rs = 25kN, R₁ =…

A:

Q: Problem #6: An abrupt p-n junction varactor is used to tune an oscillator shown in Figure 3. At zero…

A:

Q: Determine the continuous-time convolution of x(t) and h(t) x(1) 111 1 0 2 h(t) 2 0 1 2

A: In this question We need to determine the continue time convolution of the given signals.  We know…

Q: Define each of the following terms by giving an example for each term: Static sensitivity Error…

A:

Q: a) Design a voltage to frequency converter using the 9400 as shown in the circuit below for fo=…

A: According to the question, for the given circuit of the voltage to frequency converter by using the…

Q: The current through the inductor of the figure is known, Calculate the voltage v(t) Report only the…

A: Given: The current in the circuit, it=-5t+10 A. Inductance, L=5 mH.

Q: 5. If a potential difference of 240 V is applied to a field winding at 15°C and the current is 4 A.…

A: Given data, Case 1 : Supply voltage V = 240 V. Current i = 4 A. Resistance is given by,…

Q: For the two-port networks shown below, find the S parameters: 0.502 ww Ур 10- 1'0 0.50 Ya Y< 0.50…

A:

Q: Please Draw the Circuit and Solve. 1)The non inverted active low pass filter has impedance resistor,…

A: The circuit of active loss pass filter can be designed as

Q: 7) If the reload value in TH is 96, the frequency oscillator is 11.059MHz, and the SMOD bit equals…

A: Given that TH is 96. Oscillator frequency is 11.0592 MHz SMOD bit equal 1. Find the baud rate at…

Q: b) This question is about the Short-Time Fourier Transform. The Short Time Fourier Transform is used…

A: While the normal Fourier transform offers the frequency information averaged across the whole signal…

Q: Determine the 1₁ (t) and equivalent resistance that seen by source ZTH in the circuit of Figure.…

A: In this question We need to determine the current i1(t) and equivalent impedance Zth as shown the…

Q: Example 4: The speed of a 50Hp series motor working on 500V supply is 750RPM at full load and 90%…

A: Solution:

Q: 7. Find iz > 0 SVI 1052 102 Va 202 1=0 102 elle 12H

A:

Q: For the following system represented in state space, find out how many poles are in the left half-…

A: it is asked to find how many poles are in left half plane, right half plane, on the jw-axis of the…

Q: 2. Table 1 A 230 VRMS, 60Hz generator is supplying five (5) loads as shown below. Some measured…

A: it is asked to find the different types of powers and power factor of given system

Q: Phosphorous ions are doped into active areas of NMOS transistors. P-well is required for PMOS…

A: We have to write whether the given statements are True or False. 1) Phosphorous ions are doped into…

Q: Write current equations and determine the admittance matrix of the network

A: Given: 5 Bus one-line diagram of power system Bus Convert impedance to admittance Y=1Z For example,…

Q: (b) The circut has been reconnected with the same silicon diodes as shown in Figure 2b Calculate…

A: The given circuit is:

Q: Consider the following transfer function C(s) R(s) From the information given which one of the…

A: In this question We need to choose the correct option What is correct parallel canonical form?.

Q: What is the best splice procedure when replacing a connector? Bundle all splices together. Use all…

A: In order to connect two cables, splicing is done. This is often done when a cable has to be…

Q: 15) An alarm sounds when certain conditions occur in a nuclear reactor. The output X, of a logic…

A: Given: Output of logic circuit is 1 only: Either CO2 pressure is too low and temperature is &lt;=…

Q: What two measurements are required in order to determine the CMRR of an Op Amp? if 1mV is applied to…

A: CMRR= Adm / Acm  To determine CMRR, Adm and Acm are required. Adm= Differential mode gain  Acm =…

Q: The ciren't below is in sheady state before the switch changer position at to 0 seconds. Find It (1)…

A:

Q: -8Ia + 6Ib = -2 5Ib  + 15Ic = -8 6Ia - 13Ib + 5Ic = 4   Solve Using Gauss Seidel Method

A: Given equations are  -8Ia + 6Ib = -2 5Ib + 15Ic = -8 6Ia - 13Ib + 5Ic = 4  Hence by using  Gauss…

Q: Suppose a liquid level ranging from 5.5 to 8.6 m is linearly converted to pneumatic pressure ranging…

A:

Q: When 1 A is passed through three impedance coils. A, B and C in series, the voltage drops are…

A:

Q: A galvanometer with a full scale current of 10 mA has a resistance of 1000 Ω. The multiplying power…

A: Given: A galvanometer with a full scale current, Im = 10 mA. Meter resistance, Rm=1000 Ω Shunt…

Q: What are the branch currents, 12 and 13 ? 늪 R1 4 kOhm V₁ 35 V R2 7.5 kOhm R3 12.5 kOhm

A:

Q: A 400kV, 200km, 3-phase transmssion line have the follollowing parameters per phase: z = 0.14+j0.304…

A: It is given that: VR=400 kVl=200 kmz=0.14+j0.304 Ωkmy=j5.306×10-6 skm

Q: 2. Two charges are situated near point P. q;= -4.5 µC and q2 = 3.5 µC. Find the electric field…

A:

Q: Suppose a circuit has a transfer function of the form A (w): = For Ao = -10 V/V and wo = 100 rad,…

A: Given: Transfer function: Aω=A01-jωω0, And, ω0=100 rad/s,   So, Aω=-101-jω100.......(i)

Q: A unity feedback system has a plant transfer function described by G(2) as follows: 1 G(₂) = 22-72…

A: Given transfer function is : G(z) = 1z2-7z+11

Q: Find the difference equation for the following transfer function: H(z) = 1+2Z/(3+Z)(4+Z)

A: transfer function of a given discrete system is given  it is asked to find the difference equation

Q: A coil having an inductance of 200 mH is magnetically coupled to another coil having an inductance…

A: Given data, Inductances are given L1=200 mH, L2=500 mH. Coefficient of coupling between inductances…

Q: Type of sensor used to detect both metallic and non-metallic: Inductive sensor Capacitive sensor…

A: A device that measures or detects a physical attribute and records, indicates, or reacts to it in…

Q: (a) Assuming ideal op-amps, drive an expression for the frequency of oscillation and the condition…

A: Given data Two ideal operational amplifier circuit is given in the problem. V02 and V01 are the…

Q: Q3. Provide short response for the followings (a) The advantage of DSB-SC modulation over AM (e DSB…

A:

Q: In digital signal processing , how can express the joint time frequency analysis methods or some…

A: In digital signal processing we have to express the joint time frequency analysis methods or some…

Q: 9V ImA 1002 ↑ +1 85022 loks 8505 IMS 25002 VI

A:

Q: For the series circuit, find the parallel circuit that will have the same total impedance. Z₁ 2052…

A: it is asked to find the parallel circuit of given series circuit

Q: the rotor frequency of a four-pole, 60 Hz induction motor with 5% full * load slip is 50 Hz O 60 Hz

A: Given data, Number of poles P = 4. Frequency f = 60 Hz. Slip s=5%=0.05

Q: Given two voltage sources 10 cos (wt + 45°) and 10 sin (wt - 459) are connected in-series, what is…

A: Given: V1=10cosωt+45° V2=10sinωt-45° V1 and V2 are in series To Find: Resultant Voltage, V1 and V2

Q: Consider a second order system whose state space representation is of the form *= Ax+ Bu. Where B =…

A:

Q: Write the function in terms of unit step functions. Find the Laplace transform of the given…

A: In this question We need to write the given function in the term of step function and Laplace…

Q: Find the expression for the output function, F. Do not simplify. Vdd- B C B bar B bar A 0 A bar A…

A: According to the question, for the given circuit as shown below We need to find the output function…

Q: biased such that it operates in the saturation region with Vov = 0.25V. To simplify things, recall…

A:

Q: Why does the emergency switch turn off by pressing it and turns on when turned forward ?

A: There is no hard and fast rule but since it is easy to press a single button to use emergency switch…