At 20°C the interfacial tension between water and n-octyl alcohol is 8.50 dynes/ cm. If the surface tension of n-octyl is 27.53 dynes/cm and that of water is 72.75 dyne/cm, predict whether water spreads on the alcohol by calculating c) the spreading coefficient of water on alcohol

Q: A rubberized, cubic chamber was filled with butane gas and was expanded from 3.0L to 4.5L at a press...

A: The heat is equal to sum of internal energy and work done. The work done is product of pressure and ...

Q: 16. How much calories is required to change 600 gm of ice at – 2 °C to steam at 120°C? d. 436,830 17...

A: 16.  Heat Required to raise the Ice to its Meting Point Specific heat of ice needed to raise 1 gram ...

Q: B- In the Venturi scale, kerosene flows at a density of 0.82 kg/ m3. If the choke diameter is 10 cm ...

A: Given: Kerosene flow in a venturi scale having a choke diameter of D2 = 10 cm and input diameter of ...

Q: A PI controller has Kp = 2.0, K1 = 2.2 s1, and p¡(0) = 40%. Plot the output for an error given by th...

A: Given data: Proportional gain = 2 Integral gain = 2.2 s-1

Q: What is the detector in a spectrograph in which spectral lines are recorded photographically?

A:

Q: Q2/ A Petroleum cut has the following ASTM D86 distillation data:- Volume% 30 50 10 70 90 95 distill...

A: Given data: The ASTM D86 distillation is given.

Q: . If 10 Ib of water is evaporated at atmospheric pressure until the vohume of 288.5 ft' is occupied,...

A: Given data Mass of water evaporated (m)= 10 lb volume occupied (V2)= 288.5 ft3 formula of work done ...

Q: onsider the first order gaseous phase reaction, A-3R in a tubular flow reactor. alculate the time co...

A:

Q: One mole of an ideal gas, Cp = (7/2)R and Cy = (5/2)R, is compressed adiabatically in a piston/cylin...

A:

Q: A gas tank is accidentally placed near a heat source. Its bourdon pressure gauge reading was initial...

A: Given: Initial pressure P1 is 30 kPag Final pressure P2 is 50 kPag Initial temperature T1 is 300K Fi...

Q: How method. the solids are stored in an industry? Provide advantages and disadvantages of each

A: The storage methods for solids in industry are to be mentioned with advantages and disadvantages.

Q: A double pipe heat exchanger is to be designed to heat 1 kg/s of a cold fluid from 30°C to 60°C usin...

A:

Q: 1- Calculate the total work done for the path (a b c) of (2 mole) of ideal gas b P a V Cp=29.1 J.mol...

A:

Q: Calculate the velocity, frequency and wavelength of the sodium D line ( λ=589 nm) as light from this...

A: The Refractive index is the extent to which light bends when it passes from one medium to another. I...

Q: Prandtl number in heat analogues to which dimension less number in mass transfer. a) Schmidt number ...

A:

Q: QUESTION 4 A 3.82-g sample of magnesium nitride is reacted with 7.73 g of water. Mg3N2 + 3H20 2NH3 +...

A: Given Data : The reaction is given as :  Mg3N2+3H2O→2NH3+3MgO-----(1)The amount of Mg3N2 present in ...

Q: For the Chilton-Colburn J-factor analogy, what is x? - 1 attachment h (x)3 = JH CpG 2 O A. Prandti n...

A: Given that Chilton colburn J-factor analogy is given we have to identify the x termAccording to bart...

Q: Calculate the composition of the coal on a dry ash free basis which has the following  composition o...

A: Given Composition of coal on weight basis S  4% N2  2% O2  5% Ash  10% H2O  2% C/H=10 ...

Q: Q2/ Calculate the activation energy for vacancy formation in aluminum, given that the equilibrium nu...

A: Given, The density of aluminum, ρ = 2.62 g/cm3 The atomic weight for aluminum, M = 26.98 g/mol Equil...

Q: Isopropyl ether (E) is used to separate acetic acid (A) from water (W). The liquid-liquid equilibriu...

A: We will obtain the right triangle diagram for the given equilibrium data. The amount of feed and sol...

Q: A mixture of gas is composed of 30 moles ammonia and 45 moles air. Determine the change in entropy w...

A: Given, Moles of ammonia, nA = 30 mol Moles of air, nB = 45 mol Initial temperature, T1 = 25 °C = 25+...

Q: One end of a copper a wall that is maintained at 200t . The other end is connected te a wall that is...

A: The net heat lost by the rod to the air is to be determined.

Q: It is designed to separate 100 kg of crystals into two fractions, a coarse fraction retained on a 10...

A: (a) F=feed, Z=coarse fraction, W=fine fraction mass balance, F=W+Z component balance, 100×0.47=W×0.9...

Q: A sample of helium gas was placed inside a cylinder enclosed with a moving piston. The gas expanded ...

A: Given: Constant temperature process  Initial volume V1 is 10.9 Final volume V2 is 15.3  Work done in...

Q: A rigid vessel of 0.06 m³ volume contains an ideal gas, CV = (5/2)R, at 500 K and 1 bar. a. If heat ...

A:

Q: In distillation, q is defined as the moles of liquid flow in the stripping section per mole of feed ...

A: In distillation, values of q for saturated liquid and saturated vapor:

Q: What is the “glass transition temperature” of a polymer? (a) How can it be measured? (b) What molecu...

A:

Q: In the nitric acid manufacture, 100 m'/h of ammonia at 290 K and 1 bar is mixed with air and passed ...

A: Given data: Volumetric flow rate of ammonia = 100 m3/h Temperature = 290 K Pressure = 1 bar Degree o...

Q: Calculate the entropy change when 1.00 mol of water at 0°C freezes to form (ce./For water, A fusHo =...

A:

Q: Stoichiometric 1200 air-fuel ratio 2000 - 1000 Carbon 1600 - E 800 - ,monoxide 1200 600 5 Nitrogen o...

A: Here , we have to find out why level of co is inversly proportional to air fuel rtio.

Q: 4. Barium carbonate is commercially important as a basis for the manufacture of other barium compoun...

A: There are total four reactions involved in this system. Barium sulfide is obtained by heating sulfat...

Q: From the proton NMR spectrum in Figure 19-44, deduce the structure of this hydrocarbon.

A: Proton NMR is proton nuclear magnetic resonance. This is used to determine the molecule structure. T...

Q: what is Fixed-bed leaching ?

A: Leaching: It is a solution of one or more constituents of solid mixture by contact with a liquid so...

Q: 100 mole of nitrogen gas (N2) per hour entering a heat exchanger with the temperature of 100°c and l...

A: The mean temperature is half of sum of temperature of inlet and outlet of hot stream. Mass flow rate...

Q: A copper pipe with an inner diameter (ID) of 2.68 cm with a length of 10 m flows water at a speed of...

A: The pressure drop along the pipe is to be determined.

Q: Q1. Characteristics for the Servo problem is given as: 1 G, (s) s2 + 4s + 1' G.(s) = K. ; Gm(s) = G,...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: What is the “glass transition temperature” of a polymer? (a) How can it be measured? (b) What molecu...

A: a) The glass transition temperature of polymers is the range of temperature where the substrate of t...

Q: A petroleum cut has the following TBP Distillation data: Volume % distillate 0 10 30 Temperature °c ...

A: Given data for petroleium distillation cut is- Temperature conversion from ⁰C to K (Kelvin): K= ⁰C +...

Q: Q.2. Air flows steadily adiabatically through a pipe with a cross-sectional area of 0.002 m?. At the...

A:

Q: Banks DIH says its classic Banks Beer contains 4.5% alcohol by volume (v/v) in the liquid phase. The...

A: Beer have 4.5% alcohol by volume in liquid phase Henry’s volatility constant=2.12×10-9 T=25℃ Find C...

Q: A compound had a molar absorptivity of 2.93 x 103 L cm-1 mol-1 What concentration of the compound wo...

A: Beer Lambert's law is a relationship between the physical properties of the solution and the absorba...

Q: The molar flux of component A in molecular diffusion is independent of A. mass transfer area B. conc...

A:

Q: 1) Form the following data for CH;CI T(°C) Y (dynes/cm) 10 20 19.5 17.8 16.2

A:

Q: A simple heat exchanger consisting of two concentric flow passages is used for heating 1110 kg/h of ...

A:

Q: City A was found to be humid all year round (with humidity levels of around 65%). This city is surro...

A: Dear Subscriber ! There are three separate questions posted here in the order of b, c and a. As per ...

Q: Chemical Engineering Question

A: Black is the absence of light. When there is no light, everything is black. Test this out by going i...

Q: How many milligrams of a drug should be used in preparing 100 mL of a stock solution such that 10mL ...

A: Given data: Concentration of diluted solution = 1:8000 (w/v)

Q: Q.2 Sulfur dioxide reacts with oxygen producing sulfur trioxide SO: + ½ 02- SOs In order to ensure c...

A: Given Reaction is SO₂+1/2 O2→ SO3 Oxygen supplied=2×Oxygen theoretical needed Conversion=60% P=500k...

Q: The osmotic pressure of an aqueous solution at 288K is 99.0 kPa. Calculate the freezing point of the...

A: Given data: T = 288 K P = 99 kPa  

Q: Q3/ Estimate the Watson characterization factor K, molecular weight, Aniline point, carbon to hydrog...

A: Give data: Mean average boiling point = 99 0C API gravity = 52