At the end of the experiment you will be assessing the purity of your aspirin by measuringits absorbance at 525nm. If the absorbance measurement is found to be 0.040 then whatis the % salicylic acid impurity in your aspirin? a. 0.06 b. 0.25 c. 0.15 d. 0.44 e. 0.35

Answered: At the end of the experiment you will…

Organic Chemistry: A Guided Inquiry

2nd Edition

ISBN:9780618974122

Author:Andrei Straumanis

Publisher:Andrei Straumanis

ChapterL1: Infrared Spectroscopy

Section: Chapter Questions

Problem 2CTQ

See similar textbooks

Similar questions

A solution of a dye with an absorptivity coefficient (ε) of 3.75 x 102 M-1cm-1 had an absorbance of 0.039 measured in a cell whose width is 1.00 cm. What is the concentration of the dye in the solution? a. 1.46 x 10-3 M b. 1.04 x 100 M c. 1.04 x 10-4 M d. 1.46 x 101 M
If a solution has an absorbance of 2 you can be certain that the solution is highly diluted and needs to be concentrated all the statements are correct this is a reliable absorbance and downstream analysis can be done the solution is highly concentrated and needs dilution
Test tube Concentration (M) absorbance 1 0.0003 0.13 2 0.0006 0.27 3 0.0009 0.41 4 0.0012 0.59 5 0.0015 0.72 unknown solution 0.00054 0.26 graph are attached please check The concentration corresponding to unknown absorbance is 0.00054. Using the Absorbance of your unknown, determine the concentration of your unknown from the graph by interpolation. Include your unknown concentration in the data table. and Was Beer’s Law obeyed? Explain your answer please answer 1 and explain properly thank you all data arementioned
A series of six solutions was prepared at the given concentrations. Sample AB C D E F Concentration (mM) 50 100 | 150 | 200 300 400 The absorbance of each solution was then measured using a colorimeter. Sample A B C D E F Absorbance 0.25 0.50 0.75 1.00 1.50 2.00 What is the concentration of the solution with an absorbance of 1.50? C = mM
2. Add the absorbance of your Part III solution to the graph. Llse the of best fit of your qraph to calcuate its line concentration. Concentraton vs Absorbance 1.6 con c: 0.003M 1.4 1.2 0.8 0.6 0.4 0.2 0.0005 0.001 0.0015 0.002 0.0025 0.003 0.0035 Concentration Co.003M) Concentration you have calculated in 2 is CCrO, of Ag CrO4. calculate your experimental ksp of Ag CrO4. = [Cr O4]? Use it to 2. %3D ksp of AgCr Oy = CAg+] [CrO4] Absorbance te Out
Given that the molar mass of the Red 40 dye is equal to 496.42 g/mol, how many grams of Red 40 food dye were in the 0.235 L solution of drink mix? Remember that you diluted your original solution ten fold before measuring its absorbance. Choose the closest answer. A. 0.0045 g B. 0.085 g C. 0.0011 g D. 0.011 g
When using a spectrophotometer to measure concentration of a solution, which of the following absorbance readings would indicate the highest concentration? 1. 0.56 2. 0.32 3. 1.34 4. 1.28
em1.png chem3.png Part 3: Q9 Average absorbance Flask 8 Flask 9 Flask 10 Flask 11 Part 3: Q9 Flask 8 Flask 9 Flask 10 Flask 11 Part 3: Q10 Flask 8 Flask 9 Flask 10 Flask 11 Q Part 3 0.146 [Fe] -0.002mol/L 0.166 volume 5.00mL 0.215 0.294 [FESCN mol/L) ✪ 4.59* 10 5.18*10* 6.64 x 10 9.08*10* [Fe(mol/L) 5.00 x 10 5.00*10* Y=3362x -0.0083 R¹ 0.9993 5.00 x 10 5.00*10* (Amounts of flask 8 (9 - 11's values are in the spreadsheet) 1:1 Ratio so, Molarity of Fe(NO3))3 = 0.2M Volume of Fe(NO3))3 = 5.00mL 71% Moles of Fe³= Molarity x volume(L) Moles of Fe = 0.2M × 0.005L = 1× 10-³mole 68% [SCN ](mol/ 4 x 10-4 5 x 10-4 7*10* 1*10* الخا chem2.png Concentration of Fe³ 9, X = mole of Fe³1x10³ mole Volume 0.0054 Ⓒ 8, Average absorbance for solution 8 (same for 9 - 11) Average absorbance for flask 8 = sum of all absorbances / number of readings (0.145 +0.147 +0.148) 3 Using equation of calibration curve's line(slope) of best fit, the average absorbances of the unknown concentrations to determine…
Sample (μg) Absorbances (520 nm) Concentration 0.0 0.621 0 2.5 0.599 2.5 5.0 0.556 5 10.0 0.469 10 15.0 0.418 15 20.0 0.291 20 Plot a graph in which y axis represents for absorbance and x-axis represents for concentration From graph, y=mx + c Calculate the vitamin C concentrations of samples by the equation with consideration of dilution factors.
A standard curve for a compound was created with a series of standards, and is shown below. If an unknown produced an absorbance of 0.279, what was the concentration of the compound? Absorbance 0.6 0.5 0.4 0.3 0.2 0.1 Standard Curve for Comound A 0 -0.1 0 10 20 30 Conc. A (ppm) 40 y = 0.0104x -0.0044 R² = 0.9947 50 60
If absorbance of a sample is 0.521, what is its concentration?
5) If absorptivity (the constant of how much light of a given wavelength the sample absorbs) and path length (how much solution there is for light to pass through) are the same, which is true for a Beer's Law solution? a) its concentration and absorbance are proportional b) its concentration and rate are proportional c) its absorbance and rate are proportional d) the solution is an alcoholic beverage

SEE MORE QUESTIONS

Recommended textbooks for you

Organic Chemistry: A Guided Inquiry

Chemistry

ISBN:

9780618974122

Author:

Andrei Straumanis

Publisher:

Cengage Learning

Living by Chemistry

Chemistry

ISBN:

9781464142314

Author:

Angelica M. Stacy

Publisher:

W. H. Freeman

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

Organic Chemistry: A Guided Inquiry

Chemistry

ISBN:

9780618974122

Author:

Andrei Straumanis

Publisher:

Cengage Learning

Living by Chemistry

Chemistry

ISBN:

9781464142314

Author:

Angelica M. Stacy

Publisher:

W. H. Freeman

Chemistry & Chemical Reactivity

Chemistry

ISBN:

9781133949640

Author:

John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

At the end of the experiment you will be assessing the purity of your aspirin by measuring its absorbance at 525nm. If the absorbance measurement is found to be 0.040 then what is the % salicylic acid impurity in your aspirin? a. 0.06 b. 0.25 c. 0.15 d. 0.44 e. 0.35