At time ? = 0, the height of water in the tank is ℎ0. Find an expression for the height as a function of time, ℎ(?). As part of a processing of biofuels, water is pumped into a circular tank with a diameter Dt.as shown in Figure Q3. The flowrate into the tank is Q₁ and the flowrate out is Q₂. Whenthe vessel is heated, water evaporates. The average velocity at which the vapour risesacross the entire tank is vevap-You may assume that water has a density of Pw, and vapour has a density of Pv.Acceleration due to gravity is g. 2₁VevapQ₂=>D₂Figure Q3: Water being pumped through a heated evaporation tank.

Answered: At time ? = 0, the height of water in…

Engineering

Mechanical Engineering

At time ? = 0, the height of water in the tank is ℎ0. Find an expression for the height as a function of time, ℎ(?).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If a liquid enters a pipe of diameter d with a velocity, v. what will irs velocity at the exit be if the diameter reduces to 0.5d?
4. The circular tank of water is being filled from a pipe shown in figure below. The velocity of flowof water from the pipe is 10 ft/s. What will be the rate of rise ( in ft/s) of the water surface in the tank?
Transcribed Image Text:As part of a processing of biofuels, water is pumped into a circular tank with a diameter Dt. as shown in Figure Q3. The flowrate into the tank is Q₁ and the flowrate out is Q₂. When the vessel is heated, water evaporates. The average velocity at which the vapour rises across the entire tank is vevap- You may assume that water has a density of Pw, and vapour has a density of Pv. Acceleration due to gravity is g. 2₁ Vevap Q₂ => D₂ Figure Q3: Water being pumped through a heated evaporation tank. Find anexpressio for the rate of chnage of the mass of water in the tank At time t= 0 the height of water in the tank is h0. Find an expression for the height as a function of time h(t) An alarm is triggered when the pressure at the bottom of the tank exceeds P alarm. Find an expression for the time at which the alarm goes off
The figure below shows a gasoline storage tank with cross-sectional area Asub1, filled to a depth h. The space above the gasoline contains air at pressure psub0, and the gasoline flows out the bottom of the tank through a short pipe with cross-sectional area Asub2. Derive expressions for the flow speed in the pipe and the volume flow rate. Thank you!
Q4. Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe length is 100 m. If the water pressure needs to be at a pressure of 1.6 atm on a lower level. What should be the different in elevation between the upper and lower levels in order to achieve this pressure? Take the density of water 1000 kg/m and gravity is 9.81 m/s, consider the energy loss.
Initially tank I and tank II each contains 100 gal of brine, tank I having 200 lb salt and tank II 50 lb of salt in solution. Brine runs at 2 gal/min from tank I to tank II through one pipe and at 3 gal/min from tank II to I through another pipe. The brine is kept well stirred. How much salt (in lb) will be in the second tank after 50 min?
A tank initially holds 100 gal of a brine solution containing 1 lb of salt. At t = 0 another brine solutioncontaining 1 lb of salt per gallon is poured into the tank at the rate of 3 gal/min, while the wellstirredmixture leaves the tank at the same rate. Find:a. the amount of salt in the tank at any time t and b. the time at which the mixture in the tank contains 2 lb of salt.
4. FLUID FLOW 1. The figure below shows a water tank with piping system for a small manufacturing plant. If water flows through the system ((A) at 40 L/s, what would be the pressure at point B? The water has a density of 998 kg per cubic meter and viscosity of 0.8 centipoise. measures 0.04089 m and 0.04826 m in inside and outside diameter, respectively. The tank is exposed to the atmosphere The 1.5 inches (nominal) wrought iron pipe Given: Q= 40L/s = 0.040 m/s p= 998 kg/m H=0.8 centipoise 0.001P-s = 0.08 P-S Reg'd: Pressure at B. = ? 1 cp i.d. = 0.04089 m o.d. = 0.04826 m length of pipe = 110 m
5. Consider two tanks, A and B, each with a large opening at the top. The two tanks contain different liquids. A small hole is made in the side of each tank at the same depth h below the liquid surface, but the hole in tank A has three times the cross-sectional area of the hole in tank B. (a) If it is known that the mass flow rate is the same for the two holes, find the ratio of PALPB of the densities of the liquids in tanks A and B. (b) (c) equal volume flow rates, what height above the hole must the liquid in tank A be just then? Find the ratio RVAIRVB of the volume flow rates from the two tanks. At one instant, the liquid in tank B is 90 cm above the hole. If the tanks are to have
Water enters a fountain through a pipe with a cross-sectional area A₁ at a flowrate Q. The pressure in the inlet pipe is p₁. The water then leaves through a nozzle with a cross- sectional area A₂ and at an angle 0, as shown in Figure Q5. Both the inlet and the nozzle are at a height h₂, and the jet reaches a maximum height h3. You may assume that viscosity is negligible. a) Find the horizontal force on the block b) What is the horizontal-component (u₂), vertical component (v₂) and magnitude (V₂) of the velocity of the jet as it leaves the nozzle? c) What is the maximum height of the jet? You may assume that the horiztonal component of velocity is the same at every point in the jet. P₁ A₂. Ө h₂ h3 Figure Q5: Jet emitting from a fountain.
For a pumper truck pumping water to a fire, the back pressure is the additional pressure on the pump caused by the height of the nozzle. (Another way of thinking of back pressure is as the minimum pressure the pumper must produce in order to make water flow out the end of the nozzle.) Consider a pumper at street level pumping water through a hose to firefighters on the top of the ninth floor of a building. If each floor is 16 feet high, what is the head of water at the mouth of the nozzle?
1. At time t = 0 a tank contains Qo Ib of salt dissolved in 100 gal of water. Assume that water containing 1/4 Ib of salt/gal is entering the tank at a rate of r gal/min, and that the well-stirred mixture is draining from the tank at the same rate. Set up the initial value problem that describes this flow process. Find the amount of salt Q(t) in the tank at any time, and also find the limiting amount QL that is present after a very long time. If r = 3 and Qo 2Q, find the time T after which the salt level is within 2% of Q. Also find the flow rate that is required if the value of T is not to exceed 45 min. %3D %3D