Biol 190L Practice Problems 4. Solve the following concentration problems and show your work. • Calculate and describe how you would make 60 mL of a 0.8 M NaCI (working) solution from a 6 M stock solution. Calculate how much (volume) of 0.8 M working solution could be made from 12 ml of 6 M CGH1206 (stock) solution. 5. Solve the following concentration problem and show your work. Calculate and circle which represents a higher concentration of NaCl : 1) 5 M or 2) 20%?

Biol 190L Practice Problems 4. Solve the following concentration problems and show your work. • Calculate and describe how you would make 60 mL of a 0.8 M NaCI (working) solution from a 6 M stock solution. Calculate how much (volume) of 0.8 M working solution could be made from 12 ml of 6 M CGH1206 (stock) solution. 5. Solve the following concentration problem and show your work. Calculate and circle which represents a higher concentration of NaCl : 1) 5 M or 2) 20%?

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.107E

See similar textbooks

Similar questions

Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
A solution labeled “0.25 M AICl3” would contain _________ le(s) of Al3+ and mole(s) of Cl- in each liter of e solution.
D5W is a solution used as an intravenous fluid. It is a 5.0% by mass solution of dextrose (C6H12O6) in water. If the density of D5W is 1.029 g/mL, calculate the molarity of dextrose in the solution.
An experiment in a general chemistry laboratory calls for a 2.00-M solution of HCl. How many mL of 11.9 M HCl would be required to make 250 mL of 2.00 M HCl?
Addition of water to concentrated sulfuric acid is dangerous because it generates enough heat to boil the water, causing it to spatter out of the container. For this reason, chemists remember to add acid to water. In a dilution experiment, we calculate the amount of the more concentrated solution that must be measured out. If we place this concentrated solution (Figure 4.7) in the volumetric flask first, then dilute with water, we violate the caution Add acid to water. Describe a safer variation on the method shown in Figure 4.7 that allows the quantitative dilution of concentrated sulfuric acid. Figure 4.7 Preparing a dilute solution from a concentrated solution. (a) Draw the concentrated solution into a pipet to a level just above the calibration mark. (b) Allow the liquid to settle down to the calibration line. Touch the tip of the pipet to the side of the container to remove any extra liquid. (c) Transfer this solution to a volumetric flask. Again touch the pipet to the wall of the flask to ensure complete transfer, but do not blow out the pipet because it is calibrated for a small amount of liquid to remain in the tip. (d) Dilute to the mark with solvent. Frequently, especially with concentrated acids, it is best to have some solvent present in the volumetric flask before you add the concentrated sample.