(c) For the circuit shown in Figure Q2c, E = 100 V, R₁ = 102 and R₂ = 30,with the current drawn from the battery being 6 A. The current through theload resistor, I, changes to -51 if the two resistors R₂ are replaced by shortcircuits.RER₁Figure Q2cR2[IR₁Using a circuit analysis technique with which you are familiar, determine thesimultaneous equations which, when solved, will allow the determination ofthe values of R, R, and I. There is no need to solve the simultaneousequations.

We need to write all simultaneous equations to find values of R,RL and I using any circuit analysis…

(c) For the circuit shown in Figure Q2c, E = 100 V, R₁ = 10 and R₂ = 30, with the current drawn from the battery being 6 A. The current through the load resistor, I, changes to -51 if the two resistors R₂ are replaced by short circuits. R E R₁ Figure Q2c R2 [I RL Using a circuit analysis technique with which you are familiar, determine the simultaneous equations which, when solved, will allow the determination of the values of R, R, and I. There is no need to solve the simultaneous equations.

(c) For the circuit shown in Figure Q2c, E = 100 V, R₁ = 10 and R₂ = 30, with the current drawn from the battery being 6 A. The current through the load resistor, I, changes to -51 if the two resistors R₂ are replaced by short circuits. R E R₁ Figure Q2c R2 [I RL Using a circuit analysis technique with which you are familiar, determine the simultaneous equations which, when solved, will allow the determination of the values of R, R, and I. There is no need to solve the simultaneous equations.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel to each other. The parallel connection of the said practical batteries is connected across the ideal battery. The two practical batteries have the following specifications: 10 volts, 0.2 ohm; 8 volts, 0.5 ohm. Determine the total current being delivered by the source.
In the figure the current in resistance 6 is i = 1.43 A and the resistances are R₁ = R₂ = R3 = 1.68 2, R₂ = 15.1 Q2, R5 = 7.41 Q2, and R6 = 4.57 2. What is the emf of the ideal battery? E www R₁ O a. 25.7V O b. 52.3 V O C. 47.2 V O d. 21.4 V O e. 6.54 V R3 www R₂ www R₁ R₂ 16 R6
150 100 + VA- a -4V AVA -7V 81. B b Figure 2 shows a simplified model of a gas-discharge lamp. One characteristic of these lamps is that they exhibit negative resistance; in other words, as current increases the voltage drops further, making such lamps inherently unstable. As such, a current-limiting ballast is required. For the connection shown in the figure: 1. Find the equivalent Thevenin circuit of the lamp. 2. Find the ballast resistance needed to limit the current drawn from a 24-volt source to 6 amperes.
Q2) Consider the circuit in Figure (3), and answer 3 branch only. a) What type of circuit is this? b) What is the total peak secondary voltage? c) Find the peak voltage across each half of the secondary. d) Sketch the voltage waveform across RL. 4:1 120 V rms RL 1.0 k2 D2 eelee
2. Build the circuit below shown in Figure 2. R1 1k V1 VOFF = 0 VAMPL = 4W FREQ = 10kHz C1 0.1uF Figure 2 2.3 Plot the waveform v for the voltage across R in simulation. Save the waveform and add it 2.4 Assuming the waveform of the voltage drop across R1 is Vr= VrPCOSwt, determine the amplitude (VRP, in 'Volt') and the radian frequency (w, in 'rad/sec') from the waveform.
For the network shown in figure (3), if the switch is closed for 2usec and then opened for Susec, find mathematical expressions for vi and in of both periods of time and then plot the waveforms of vL and i as a function of time.
please sketch them all and show a step by step solution
lell L1 R Ro 2. In this figure, assume arbitrary numbers for R1, R2, L1, and L2 including some number for the battery E. Find the rate of current in which inductor one (L1) is changing just after the switch is closed. Next, find the current in L1 after some time after the switch has been closed. lell
Which of the following statements regarding circuits are true? To find resistance in a parallel circuit, you must sum the individual resitances The direction of conventional current is the direction of positive charge flow. In a circuit, electrons flow from high potential energy (at the negative terminal) to low potential energy (at the positive terminal). When electricity is passed through a lightbulb, the electrons are 'used up' by the bulb. All voltages in a loop sum to 12V The current that flows into a resistor is the same as the current that flows out. To 'short circuit' something means there is an alternate path of less resistance for the current to flow. Switching on a light happens immediately because electrons move from the power source to the bulb incredibly quickly. A 'kilowatt-hour' is a unit of power, not energy.
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
Part A: A multi-range ammeter is required to measure the current in a certain network. A PMMC instrument has connected as an Ayrton shunt with a four resistor across PMMC. The resistance values are R1 = 0.006N, R2 = 0.0650, R3 = 4.00 and R4 =10.00. The PMMC has Rm = 1kQ and FSD = 50µA. %3D %3D a. Draw the circuit for the multi-range Ayrton shunt. b. Calculate the four current ranges of the ammeter. c. What is the main advantage of Ayrton shunt ammeter compared to parallel type. d. Briefly explain how this device can be calibrated. * Note: Show all calculation details. Part B: The measurement of the voltage from a prototype of a 20V DC power supply were captured by 8 times as shown in the following table: Number 1 2 3 4 6 Voltage (V) 18.5 19.8 20.2 19.9 20.0 20.1 19.7 18.9 Determine the following: 1. the arithmetic mean, 2. the standard deviation of the readings, 3. the probable error. 4. If the voltmeter that used to carry the measurements has an error of 0.5%; calculate the total…
2 The figure is a graph of ... 5 (5 Points) Current Voltage the current across a voltage as a function of the potential difference through it the resistance as a function of the current across a component the current through a component as a function of the voltage across it All three of the above (a), (b), and (c) are true None of the above (a), (b), or (c) is true