/ Calculate the current (Vas) using superposition. [IV] IV 40 Ω 10Ω 51 Α 4Ω 25Α 12V - Vab

Q: For the circuit, find RT, 1₁, 12, and 13. R₁ 6.67 0 150 V R₂ 292 R₂ m 102 R₂ w 30 1²

A: The given circuit diagram is shown below,

Q: The voltage signals VA and VB from two sensors need to be conditioned to obtain an output voltage…

A: Given : Output voltage VOUT=AVA-VB Gain A is between 0 to 100 Find : Circuit used to perform the…

Q: 4. Find Req- 42 Req 360 80 Jal: 22 -WN- M 1202 402 M 1 of th 1 US -M 152 25 322

A:

Q: A non-inverting amplifier is implemented with two 10 kΩ resistors with 5% tolerance What is the…

A: Given: A non-inverting amplifier and inverting amplifier Two resistor of 10 kΩ with 5% tolerance

Q: What is the output voltage Vout if the open loop gain assumed to be (A = 10³), R₁ = 5k0, R₂ = 40k0,…

A: Given op-amp circuit, Open loop gain, A=103 Input voltage, Vin=200 mV Feedback resistance, Rf=40 kΩ…

Q: b) Sketch the I-V characteristic of an ideal diode.

A: Diode is a semiconductor device . The I-V characteristics of the ideal diode are given below.

Q: P4.11d Find the damping ratio and natural frequency of the closed-loop transfer function. 20…

A: Given, The closed loop transfer function is, Ts=20s2+6s+144.

Q: a 3-bit up-counter JK Flip flops Design using 1) Truth table to express the function of the counter…

A: The 3-bit up counter can be designed by using the three jk flipflop. The logic expression can be…

Q: Consider the Wheatstone Bridge below.The bridge is balanced.Calculate the unknown resistor R. 500v…

A: Given: A balanced Wheatstone's bridge,

Q: Q2: Find Thevenin's equivalent across terminals a and b in the circuit of Fig. (1). ting the…

A:

Q: An ADC having a range of [0, 5] V. i. Determine the number of bits required if the minimum…

A: Given Range = [0,5] V Tolerance = 0.61mV

Q: Q1-A closed-loop control system of open-loop transfer function a- b- 4(s²+10s+100) (s3+3s2)…

A: A closed-loop control system of open-loop transfer function :…

Q: 2. Obtain the transfer function of the system given below using block diagram reduction techniques.…

A: A block diagram is shown below. We have to find the transfer function.

Q: Q6:- For the system in Fig. 5: a) Find Pr. Qr. Sr. Vr and the power factor Fp. b) Draw the power…

A: Given:

Q: Ex20: Determine the current (Io) and the voltage at the (10) resistor, 4Ω 60 V Io Μ Μ Α 10 Ω σ ΖΩ…

A: Given circuit,

Q: If (i) Fault current = 1000 Amp (ii) CT Ratio = 80:1 (iii) Relay setting = 150% Then PSM (plug…

A: Given, Fault current, If=1000 A CT ratio = 80 : 1 Relay setting = 150 % = 1.50

Q: A 50-hp, 250 V, 1200 r/min de shunt motor with compensating windings has an armature resistance…

A: Given,For a DC shunt motor,P=50 hp.V=250 V.N1=1200 r/min.Ra = 0.08 Ω.Radj+Rf =50 Ω.N=1200 turns.

Q: for the circuit below, during mode 2, transistor Q1 is switched off and the current, which was…

A: In this question,  We need to choose the correct options Inductor act as short circuit after Long…

Q: A string of insulators in a 132 kV line consists of 5 units. If the value of the mutual capacitance…

A:

Q: An office with 30 m * 15 m is illuminated by 40 W fluorescent lamps of lumen output of 2200 lumens.…

A: We have been given an Office area and the given data, Working Area (A) = 30 m * 15 m = 450 m2…

Q: 6) Simplifying the "Y" expression, then fill in the "Y" column. Y = ĀBC +ĀBC + AB C + ABC: A B Y 0 0…

A: Given: Y=A B C +A B C+A B C+A B C

Q: State two advantages of the fuzzy logic in respect to the classic logic.

A: Fuzzy Logic:- Fuzzy describes things that are ambiguous or unclear.  Everyone encounters a…

Q: A DC source has an open circuit voltage of 30 V and an internal resistance of 1.5 ohm. A resistive…

A: Given, A dc source has open circuit voltage, Vs=Vth=30 V Internal resistance, Rs=1.5 Ω

Q: 5.164 20-4f 11₁₂=14001 pm a) If= 1.2.4 C 193 R₁=15-2 P=5KIJ-Pack

A: 5.16 P=4     RA=0.8 Ω   Vo=1.5 V n1=1400 rpm Solution- a) If=1.2 A  RL=15 Ω  PL=5kW=Pout   From…

Q: 8. The transfer function given below has; s+1 (s + 4) (s² + 3s + 2) P(s) =

A: Given: Ps=s+1s+4s2+3s+2 Required: Poles and Zeroes of the given transfer function.

Q: The quality factor of a bandpass filter that has an upper cutoff frequency of 121 krad/s and a lower…

A: Given data, Upper cutoff frequency, fH=121 krad/s Lower cutoff frequency, fL=100 krad/s

Q: A 3-phase, 10 MVA, 11 kV generator with a solidly earthed neutral point supplies a feeder. The…

A: We have an 3-Phase generator with a solidly earthed neutral point which supplies a feeder. Positive…

Q: Circuit breaker usually operate under   A) after D. C. component has ceased B) transient state of…

A: Circuit breaker:- It is an electrical device which used as a switch for safety purposes. It protects…

Q: (a) A flat, circular coil does not actually produce a uniform magnetic field in the area it…

A: Given data: The voltage V=1.50 volt The resistor R=270 Ω The parameter of the circle 90 cm

Q: Problems Introduction P 1-9. Write a set of differential equations, in state form, for the coupled…

A: Given:

Q: Q10/Chose the correct answer for the output Q3 of the following circuit ( Assume that A=…

A: Writing the expression from the circuit. S=A+BR=C⊕DT=AD Writing the characteristic equation of Flip…

Q: Q2. Two integer numbers A and B are represented in pure binary by two bits, being A=a₁a0 and B=b₁bo.…

A:

Q: The product of (3+4j)(1-2j) in polar form is

A: Given expression: (3+4j)(1-2j)

Q: a 6-kWh battery has a DoD of 74%, find the maximum amount of energy that can be used befor…

A: Given data, Energy E =6 kWh DoD (Depth of Discharge) = 74%

Q: A parallel-plate capacitor consists of square plates of edge length ℓ that are separated by a…

A: Given that: A parallel plate capacitor that has a length is l. Between that parallel plate air and k…

Q: 4Ω ЗА Μ Μ ΖΩ 8 Ω 3Ω % 12 V

A:

Q: Calculate the current (Vab) using superposition. 40 S2 www (11 V] 15 V for 1002 1 452 ww 2.5 A 12 V…

A: Superposition theorem states that in any linear, bilateral network where more than one source is…

Q: ellele 1₁ V₁ = 200 V ellele r 1₂ V₂ = 400 V

A: Given data, In a 2 wire d.c. system, Power is transmitted over same distance and have same power…

Q: Consider a receiving antenna with a ground value of 20 dB and an equivalent noise temperature of…

A: In this question,  We need to choose the correct options Here Antenna Gain = 20dB Equivalent noise…

Q: 6. What is the natural frequency of the following system? 5 14s² +358 +350 a) 5 rad/s 18.7 rad/s b)…

A: Given transfer function, Ts=514s2+35s+350

Q: 7;0 ĐF C₁ RB B CC www C RC ΦΕ E | t C₂ Q₁ V

A: For any queries please let me know through comments. I will try to reply ASAP! Please upvote if…

Q: (d) Calculate the output active power, apparent power and the power factor. (e) Suggest how the…

A:

Q: Q2-The open-loop transfer function of a unity feedback control system is find: 40.69 10 (0.5 s²+s)…

A: Closed-loop systems that employ feedback enhance control by automatically altering the controller…

Q: Problem 1: 12V What is the output voltage when the input Vin is low? When Vin is high? R, =8KO V.…

A: Given data,

Q: a. Find Voi=? b. If Input DC level = | Voil and R2-15002, design R1 to shift DC level from Vail to…

A: Since you have asked multiple questions, we will solve the first question for you If you want any…

Q: 1.25 Fig 1.5 + v PSPICE The voltage and current at the terminals of the circuit element in Fig. 1.5º…

A:

Q: 28. Referring to Fig. 33.17, what will be the a.c. resistance of crystal diode at point P? (1) 10 Ω…

A: Given figure,

Q: P1.71. Determine the value of vx and i, in the circuit shown in Figure P1.71. + Vx 0.5 Ω + 10…

A: Given,

Q: 3. A BJT transistor's α = B/(B + 1) is 0.992. Find the collector-current (Ic) for a base-current…

A: Given, A BJT transistor with, Current gain, α=ββ+1=0.992 Base current, IB=20 μA

Q: Ex19; For the circuit below, determine the voltage at the (452) resistor and the power at the (802)…

A:

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.