Calculate the energy stored in the capacitor of the circuit to the right under DC conditions.
Q: Calculate the energy stored by the capacitor
A:
Q: 3. Find the equivalent capacitance seen at the terminal of the circuit. (40µF) 50 μF 60 µF Cea 120…
A: As per the bartleby guidelines for us, I can solve only one question. Please post other question…
Q: Q20. A circuit comprises a coil of inductance 15mH and resistance 102 in series with a variable…
A: The solution for the given series RLC circuit is done below.
Q: The circuit shown below has the following parameters: C1 = 15 µF, C2 = 8 µF, C3 = 11 µF and V = 175…
A: What is value of total capacitor and charge on each capacitor. Capacitor are connet in Series…
Q: In an L-R-C series circuit, the source has a voltage amplitude of 121 V , R = 75.0 Ω , and the…
A: VS=121 VR=75 ΩXC=475 ΩVC=358 V (A). Relation between voltage and current across capacitor,…
Q: Find the value of capacitance which when placed in parallel with a coil of resistance 22 ohms and…
A: Given, Coil has resistance (R) = 22 ohms Coil has inductance (L) =0.07 H Capacitor is in parallel…
Q: In Electrolytic capacitors, the capacitance value can be decreased by increasing O Dielectric medium…
A: Although formula of capacitance is given by C=εAdWhere,ε=Realtive permitivityd=distance between the…
Q: A coil of 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 micro-farad…
A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…
Q: 2.) Find the equivalent capacitance seen at the terminals of the circuit. 50 uF 60 µF 70 uF 20 µF…
A:
Q: Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 6 ohms R2 = 50…
A:
Q: Activity 2: Series-Parallel Capacitor Four capacitors are connected as shown in the figure below.…
A: The voltage source have a value Vt= 30 V. The capacitor c1 and c2 are short circuit. So the voltage…
Q: For the circuit shown, what would be the voltage across the capacitor at t= 30 t=0 + 10 mA 5 kN V.…
A: Given
Q: Q1 How is the initial current through a bulb affected by putting a capacitor in series in the…
A: 1) When one places a capacitor in a circuit containing a light bulb and a battery, the capacitor…
Q: A 50 and 100-microfarad capacitors are connected in series and connected across a 100sin(ωt +30°)…
A:
Q: An inductor L is connected in parallel to the series combination of capacitor C and resistor R. If L…
A:
Q: 5. For the given circuit below, determine (a) the voltage across each capacitor and (b) the energy…
A: Here, we have given an electrical circuit having, no. of capacitor connected in series and parallel…
Q: In a RC charging circuit, given R = 100 Kohm, Supply voltage = 12 V and voltage across the capacitor…
A: In this question RC charging circuit is given with supply voltage and resistance value....Given…
Q: 46. An inductor is connected to a 240-V, 60-Hz supply. The current in the circuit is 5 A. WWhat is…
A: Impedance of induction = voltage across inductor/ current through it. Impedance of inductance…
Q: Energy is stored in a Capacitor in the form of electrostatic field. Select one: O True O False
A: The expression for the electric field between the capacitor plates is given by: E=VdV=Ed Here, V…
Q: A coil of inductance 1 henry and negligible resistance is connected in series with a capacitance of…
A:
Q: 5. Refer to the graphic in the Appendix (C). Determine the total capacitance in the circuit
A:
Q: Determine the equivalent capacitance at terminals a-b of the circuit
A:
Q: 8 µF 6 µF 6 µF C3 µF C4 12 V C(uF) V (Volts) Energy (J) C2 C3 C4 CT
A: Energy cross different capacitor is found below: Energy across capacitor C1: C1=6μF,V=12VE1=C1V22…
Q: long time. At t-0 the switch is moved to position "b". Find the capacitor current as a function of…
A:
Q: Calculate the capacitive reactance of a capacitor that has 100V RMS across it and 35mA pk current…
A:
Q: ?What is the magnitude of the capacitor current
A: given amplifier consist of the capacitor and is an integral amplifier.
Q: 16. An impedance of 100 Q resistance and an unknown inductance is connected across the capacitor.…
A:
Q: 15 μF 30 μF C ea 1 µF 3 µF 560 31 2 μF 8 μF 4 μF 12 μF
A:
Q: 9 What is the capacitor current when the capacitor is fully charged?
A: Q= CV Q= charge stored in the capacitor C= capacitance of capacitor V= Voltage across the…
Q: Problem [2] Find the equivalent inductance of the circuit. Assume all inductors are 10 mH. ll ll ll
A: In this question we need to find a equivalent inductance of the given circuit
Q: What is the equivalent capacitance of the following circuit?
A: If two capacitors C1 and C2 are connected in series than equivalent capacitance is( C1×C2) /(C1+C2…
Q: Determine the value of the unknown capacitance C in ( µF) , which would balance the AC Bridge in…
A: For balancing of the bridge ,the multiplication of cross bridge components should be equated. (i.e…
Q: 1 A resistance of 20ohms, an inductor of 0.2H and a capacitance of 100uF are connected in series…
A:
Q: One leg of a radio-tuned circuit has a capacitance of one times ten to the minus nine farad. It is…
A:
Q: Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 1 ohms R2 = 53…
A: Given, the Resistances & Capacitances as R1 = 1 ohms, R2 = 53 ohms, C1 = 10 Farad, C2 = 36 Farad…
Q: The reactance offered by a capacitor to alternating current of frequency 50hz is 20ohms. If…
A: Given Reactance offered by capacitor at 50hz=20Ω
Q: In an AC circuit, resistance 50 Ω, inductance 0.3 H and capacitance 15 μF is connected to an AC…
A: Given: An AC circuit with Resistance, R=50 Ω Inductance, 0.3 H Capacitance, C=15 μF Source voltage,…
Q: 60 2 H m 12 cos wt Volt w Volt 1/12 F Assume that w=20
A: I HAVE EXPLAINED IN DETAIL
Q: Determine the equivalent capacitance when a 9 microfarad capacitance is placed in parallel with…
A:
Q: 1 A resistance of 20ohms, an inductor of 0.2H and a capacitance of 100uF are connected in series…
A: The solution is given below
Q: 1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro…
A:
Q: What capacitance should be connected in series with 12 µF capacitor if the equivalent capacitance is…
A: If two capacitors C1 and C2 are connected in series than equivalent capacitance is C1×C2C1+C2 Given…
Q: In the box below, show that the voltage across the capacitor of the circuit Figure 1(b) is given by…
A:
Q: What is the equivalent capacitance (in µF) between a and b?
A: The given capacitor network can be reduced by using the star to delta conversion.
Q: 5 Ohm 5 Ohm 50V 100hm 10H 10mF
A: In steady state when the switch is closed then capacitor will be open circuited and inductor will be…
Q: For the circuit given below , show and explain what is the value of capacitor voltage before switch…
A:
Q: re Q5, calculate the capacitance values wn from the source R 4 + VR
A:
Q: Draw a phasor diagram showing the following parameters after the capacitor is inserted (calculate…
A: Given:VS=120 Vf=60 HzRated power, P=1.2 kW
Q: A resistor and a capacitor are connected in series with a variable inductor. When the circuit is…
A:
After a long time value of energy is.
Trending now
This is a popular solution!
Step by step
Solved in 3 steps with 4 images
- You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?
- Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
- In a pure capacitive circuit, does the current lead or lag the voltage?In reference to the load, how are capacitors connected to help prevent voltage spikes and surges? Are capacitors connected in parallel or in series with the load?QUICK A 100 µF capacitor in series w/ a 50-ohm resistance is connected suddenly across a 125-volt DC supply. What is the voltage in the capacitor after 10 ms? 79 V 100 V 108 V 125 V
- 1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.4. What is the effect as more inductors are added in series to a circuit? A. Decreased total inductance. B. Decreased total inductive reactance. C. Decreased total circuit current. D. Decreased total resistance.3. What is the effect as more inductors are added in parallel to a circuit? A. Increased total inductance. B. Increased total inductive reactance. C. Increased total resistance. D. Increased total circuit current.